Search

Type: Posts; User: pro1200

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Don't fall for the myth that Yamaha builds a more...

    Don't fall for the myth that Yamaha builds a more reliable ski-there are serious quality issues with products from all three brands. The best an owner can do is hope that the repairs are done...
  2. I put dielectric grease on the ID of the spark...

    I put dielectric grease on the ID of the spark plug boot so the porcelain of the plug doesn't bond to it.
  3. Replies
    1
    Views
    107

    WTB - Parts How about my gently used system?...

    How about my gently used system?
    http://greenhulk.net/forums/showthread.php?t=282469
  4. Replies
    1
    Views
    185

    For my '18 GTR-X, I used the procedure from the...

    For my '18 GTR-X, I used the procedure from the factory service manual that I downloaded:
  5. I also experience occasional numbness while...

    I also experience occasional numbness while riding (ski and bike) but my whole hand is affected. I find it worse when my daughter is riding with me and I theorize that's because I don't change my...
  6. Replies
    37
    Views
    2,477

    HaHa!!! Make sure you have insurance, a VHF...

    HaHa!!! Make sure you have insurance, a VHF radio, and a tow service subscription! In a couple of weeks I'll be trying out my '17 RXT with the fifth carbon ring replacement. One of the failures...
  7. Replies
    11
    Views
    939

    No, I didn't bore the venturi (nozzle), I wasn't...

    No, I didn't bore the venturi (nozzle), I wasn't aware of that recommendation. As far as mods, I was only trying to improve the acceleration and handling. I never tested or paid attention to the...
  8. FS - Parts https://www.4-tecperformance.com/index.php?main_pa...

    https://www.4-tecperformance.com/index.php?main_page=product_info&cPath=192&products_id=1971&zenid=ep19cpsff7qdinmkll512ttaj3
    This is the sensor that is required and in the parts list that came with...
  9. Replies
    23
    Views
    1,099

    The situation is not that simple. There are...

    The situation is not that simple. There are multiple failure modes with regards to the carbon ring shaft sealing design and not all of them can be prevented. The c-clip that holds the retaining...
  10. Replies
    9
    Views
    419

    I'll relate my experience with a '17 RXT-260 used...

    I'll relate my experience with a '17 RXT-260 used in the Gulf of Mexico. Although the conditions aren't as abusive as they are in the Atlantic, they can be severe enough to test the durability of...
  11. This is a very confusing procedure to follow. ...

    This is a very confusing procedure to follow. They used to recommend removing the IC outlet tube and running the engine to look for water discharge. The last time I did this I thought I had a leaky...
  12. FS - Parts Bump-any interest?

    Bump-any interest?
  13. Replies
    10
    Views
    424

    If the oil is getting into the coil pack it could...

    If the oil is getting into the coil pack it could cause a problem but if it is just sitting in the spark plug tube it shouldn't cause running issues. To stop this oil intrusion you need to have the...
  14. FS - Parts FS Complete Dynojet AFR Monitor (less sensor)

    https://www.4-tecperformance.com/index.php?main_page=product_info&cPath=192&products_id=1962&zenid=ad8lrpqooas7kuc5i3osqdqrk7
    ...
  15. Replies
    11
    Views
    681

    These two hulls couldn't be more different. The...

    These two hulls couldn't be more different. The GTR bounces like mad and the RXP cuts through anything. I have the GTR-X and if the seat didn't have Ergolock (the standard GTR doesn't) it would be...
  16. Replies
    3
    Views
    191

    Your carbon ring may not be sealing, allowing air...

    Your carbon ring may not be sealing, allowing air into the pump on hard acceleration. Check for water in the hull or "wobble" of the ring with the engine running.
  17. There's some very weird things going on here. ...

    There's some very weird things going on here. Why would someone on the assembly line cut the PTO shroud? This alignment issue is driving me nuts...I got ONE ride out of a carbon ring that a dealer...
  18. Have you ridden the ski since you aligned the...

    Have you ridden the ski since you aligned the engine? Is the vibration gone? How was the longitudinal position of the engine-did you have to push it forward? You're lucky that you have the tools...
  19. Replies
    7
    Views
    350

    Not necessarily, the carbon seals on my '17...

    Not necessarily, the carbon seals on my '17 RXT-260 are lasting anywhere from 10-60 hours but the failure mode is different each time and I think I am cursed. As someone who has also been burned by...
  20. Replies
    21
    Views
    1,113

    This-don't look a gift horse in the mouth. We...

    This-don't look a gift horse in the mouth. We will never know what goes on behind closed doors at these companies. They know you could have been seriously injured and they would have had a large...
  21. Keewaydin is one of our favorite stops when...

    Keewaydin is one of our favorite stops when riding south from Fort Myers Beach. It's about a 40 mile ride so we're ready to have some refreshments and there are plenty to choose from. If the water...
  22. Replies
    5
    Views
    228

    Then why are you looking at aftermarket...

    Then why are you looking at aftermarket impellers? Just replace the damaged parts with new stock ones.
  23. Yes.

    Yes.
  24. It sounds like a clogged fuel system. The dead...

    It sounds like a clogged fuel system. The dead battery is probably unrelated.
  25. Replies
    42
    Views
    2,365

    This is a HUGE victory for you and I would be...

    This is a HUGE victory for you and I would be very happy. There is something very wrong with those machines and you should not have to put up with it. I hope you have better luck with whatever skis...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4