Search

Type: Posts; User: steve45

Page 1 of 8 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    5
    Views
    242

    Excellent! Thanks for sharing!

    Excellent! Thanks for sharing!
  2. I've done that. The problem is that the fading...

    I've done that. The problem is that the fading and cloudiness will return. I don't know how many times you can give it the heat treatment.
  3. Replies
    5
    Views
    242

    I'm reluctant to suggest this, but you might...

    I'm reluctant to suggest this, but you might carefully try to apply some heat on the collar with a pinpoint torch. Be extremely careful with any kind of flame around fuel and plastics. Adjust the...
  4. Replies
    5
    Views
    242

    Hmmm... Can you go through the front to get to...

    Hmmm...

    Can you go through the front to get to it? Take out the storage bin, then remove the access panel, remove the ECU and move the wires out of the way to get to it?

    Hard to imagine that...
  5. Replies
    14
    Views
    305

    Wearing Neoprene shorts is recommended, but I...

    Wearing Neoprene shorts is recommended, but I don't. Perhaps I should be more careful in my old age.
  6. That's good. It could really hurt you if it flew...

    That's good. It could really hurt you if it flew off at 60 MPH. Do you have any pics or the mod? I'm just curious.
  7. Has your front hatch been upgraded? I'm not even...

    Has your front hatch been upgraded? I'm not even sure that Kawasaki has a solution for the problem yet.
  8. Replies
    14
    Views
    305

    I just plugged the hose on mine. Ran it about 15...

    I just plugged the hose on mine. Ran it about 15 hours then sold it, but no problems during that time.
  9. Replies
    2
    Views
    112

    Don't jumper black to white if you want it to...

    Don't jumper black to white if you want it to spark.

    Make sure it's bolted down and wear earplugs.

    YJB isn't my website.
  10. Replies
    21
    Views
    894

    Thanks!

    Thanks!
  11. Replies
    4
    Views
    225

    While this is certainly true, I doubt that an...

    While this is certainly true, I doubt that an insurance company would consider it more than just a temporary spike. I bet they wouldn't actually pay more to replace a 'Ski now than they would a year...
  12. Replies
    2
    Views
    109

    Perhaps this? ...

    Perhaps this? http://greenhulk.net/forums/showthread.php?t=290966&p=3111133#post3111133
  13. So, you had one of those floating drive-up docks?...

    So, you had one of those floating drive-up docks? I thought they fell off of one of those electric lifts that hold the 'Ski a couple feet above the water.

    Are you in saltwater? If so, I'd...
  14. Well, I don't know, but I did a little...

    Well, I don't know, but I did a little investigating. Looking at the parts diagram, the '03 and '06 do take different part numbers for the oil pan.

    Sure enough, the '03 pan doesn't have a place...
  15. Bummer! Can't view the pictures.

    Bummer!

    Can't view the pictures.
  16. Agreed. Not a bad idea to re-winterize them. ...

    Agreed. Not a bad idea to re-winterize them.

    Saltwater? Definitely wash and flush out the jet pumps. Did they get water inside the hulls?

    How did they fall off the lift? Waves get that...
  17. Replies
    21
    Views
    894

    Thanks for the info! I had an unexplained...

    Thanks for the info!

    I had an unexplained seizure on the rear cylinder of an 1100 in my Exciter boat. Never was able to figure out what caused it. I'm guess that this also applies to the 1100...
  18. I'm sure you don't have any damage, but when the...

    I'm sure you don't have any damage, but when the temps go lower, you might.

    Here's what the book shows:

    http://greenhulk.net/forums/attachment.php?attachmentid=470058&stc=1
  19. If you check your owner's manual, you'll see a...

    If you check your owner's manual, you'll see a section on winterizing. There is a hose at the low point in the system where water collects. The book says to remove it and drain the water from...
  20. Replies
    2
    Views
    136

    Good story, Geeohhh! Don't know what you mean...

    Good story, Geeohhh!

    Don't know what you mean by "the accelerator was cut in half." Broken throttle trigger?

    Rebuilding the jet pump is probably a good idea. I don't know if the 3 bearing...
  21. Replies
    6
    Views
    302

    I've heard of people getting a fiberglass rod,...

    I've heard of people getting a fiberglass rod, like they mount driveway reflectors on, and cutting them down to a manageable size. If you get stick, put the shifter in forward and climb over the...
  22. Replies
    5
    Views
    163

    I just looked at the service manual and it's a...

    I just looked at the service manual and it's a joke. It says to test them all together. You need to test each carb individually. I don't know the pop-off pressure for the ZXi, but for the Ultra...
  23. Replies
    5
    Views
    163

    It's been almost 2 years since I worked on a CV...

    It's been almost 2 years since I worked on a CV carb, but I managed to do it. I probably made some plugs for the fuel rails, I don't remember. I did make some fittings with O-rings to hook up to my...
  24. Replies
    5
    Views
    163

    Don't do it with the fuel pump on.

    Don't do it with the fuel pump on.
  25. No, I'm talking about the main harness...

    No, I'm talking about the main harness connectors. Read this: http://greenhulk.net/forums/showthread.php?t=281195
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4