Search

Type: Posts; User: steve45

Page 1 of 8 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    2
    Views
    31

    No, and DON'T LOSE THE KEY! Keep the SLO key...

    No, and DON'T LOSE THE KEY!

    Keep the SLO key in a safe place to you can get a replacement made if you ever lose the fast key.
  2. Replies
    14
    Views
    288

    I'm fairly certain that the cases are different. ...

    I'm fairly certain that the cases are different. I know the 900 and 1100 heads are different. I think the cylinder spacing is different, but I don't remember for sure. If that's the case, then the...
  3. Now that you've got the 1200 engine sorted out,...

    Now that you've got the 1200 engine sorted out, look for an Ultra 150.
  4. Replies
    19
    Views
    358

    With an air leak, the engine runs very lean at...

    With an air leak, the engine runs very lean at idle. This will also cause it to run very fast when on the trailer because the carbs are adjusted to run under load in the water. This combination, no...
  5. Replies
    5
    Views
    165

    Good! Glad you got it running right!

    Good! Glad you got it running right!
  6. Replies
    5
    Views
    177

    What are you going to delete?

    What are you going to delete?
  7. Ask one of the moderators to move this to the...

    Ask one of the moderators to move this to the 2-stroke section. You'll get more responses.
  8. Replies
    44
    Views
    1,477

    Loosen the driveshaft holder, slide it forward...

    Loosen the driveshaft holder, slide it forward and clean both surfaces. Apply sealant (NOT 5200!) and snug the screws. Wait for the sealant to dry, then tighten the screws.
  9. Replies
    212
    Views
    44,028

    Awesome! I'd love to keep up with my wife's...

    Awesome!

    I'd love to keep up with my wife's 310!
  10. Replies
    212
    Views
    44,028

    I'm glad to see that you're still working on this...

    I'm glad to see that you're still working on this project!

    Are you able to keep up with the 310s?
  11. Replies
    22
    Views
    848

    That's why neoprene bottoms are recommended.

    That's why neoprene bottoms are recommended.
  12. Replies
    19
    Views
    498

    Avoid the 250! The 260s had some problems fixed....

    Avoid the 250! The 260s had some problems fixed. The 300 was a lot better, the 310 is better than that.

    Depends on your budget and location.
  13. Replies
    9
    Views
    123

    Disconnect one of the battery cables and check...

    Disconnect one of the battery cables and check the battery voltage. Should be 12.6 V or more. Next, re-connect the battery cable and check the voltage again. A drop in voltage indicates that...
  14. Replies
    22
    Views
    848

    Because a few people have been unfortunate enough...

    Because a few people have been unfortunate enough to take a direct hit in the rectum/vagina with the jet stream. It can cause massive, severe, and debilitating internal injuries--or death. You...
  15. Replies
    6
    Views
    190

    Have you checked the strainer on top of the jet...

    Have you checked the strainer on top of the jet pump?
  16. McMaster-Carr has everything, but I didn't know...

    McMaster-Carr has everything, but I didn't know they had strainers. I should have known. And they've got the best pricing!

    Thanks for posting!
  17. Replies
    135
    Views
    16,773

    Here's one that's bound to sell fast! A...

    Here's one that's bound to sell fast!

    A Tigershark that runs about 75 MPH! Also, a Polaris that runs 55 MPH, PLUS a trailer with new tires! All for the low, low price of only $1595!
    ...
  18. Kawasaki actually offered a small strainer for...

    Kawasaki actually offered a small strainer for the Ultra 150 as a dealer installed option. They were the same kind readily available under a number of different names. They have very small screens...
  19. Replies
    22
    Views
    848

    You ride with the SLO key???

    You ride with the SLO key???
  20. Replies
    19
    Views
    404

    Rather than trying a new one, just bypass the...

    Rather than trying a new one, just bypass the current one by hooking the two hoses together and try it.
  21. Replies
    6
    Views
    167

    Well, so much for trying to help somebody...

    Well, so much for trying to help somebody...
  22. Replies
    25
    Views
    468

    Yes, that's what you do when you break it in, but...

    Yes, that's what you do when you break it in, but at this point you really don't have to run pre-mix, too. The pre-mix won't hurt it, but you'll have to avoid prolonged idling or increase the idle...
  23. Replies
    17
    Views
    440

    I agree with the dealer. Don't worry about it,...

    I agree with the dealer. Don't worry about it, go play!
  24. Replies
    25
    Views
    468

    If you're running 50:1 pre-mix and oil injection,...

    If you're running 50:1 pre-mix and oil injection, then yes, it will foul plugs if you let it idle very long.
  25. Thread: 2021 Rumors?

    by steve45
    Replies
    30
    Views
    2,893

    Here's another idea for Kawasaki: how about a...

    Here's another idea for Kawasaki: how about a display that can toggle between metric and imperial units of measure? Now, when your display fails, you have to order the correct one. It seems like...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4