Search

Type: Posts; User: TMiller

Page 1 of 8 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    5
    Views
    185

    I would have said hold on let me check, put them...

    I would have said hold on let me check, put them on hold for 30 min. then if they were still there quoted something rediculous like $150 for the used one.
  2. Most common issue with the holder is the rubber...

    Most common issue with the holder is the rubber cracks and/or separates from the metal frame then water enters by the bolts. I havent heard too many stories about the seals or bearings failing unless...
  3. Replies
    6
    Views
    147

    When is the last time the plugs were replaced?...

    When is the last time the plugs were replaced? Wouldnt hurt to check compression
  4. Replies
    4
    Views
    86

    First check to make sure the choke blades are...

    First check to make sure the choke blades are full open.
  5. Well wasnt sure if youd checked that, just didnt...

    Well wasnt sure if youd checked that, just didnt want to overlook something simple. If the plates arent being held open then like has been said sounds like a leak. I would check over whatever you had...
  6. [QUOTE=beekermartin;3029249]I haven't changed any...

    [QUOTE=beekermartin;3029249]I haven't changed any cables. This was not a problem before I replaced the burnt piston.


    You removed the motor..... Is the throttle cable set correctly? There...
  7. If it didnt act this way when you last rode it...

    If it didnt act this way when you last rode it something had to have changed. Did you change anything when you did the repair? Cables maybe? Look down the carbs to see if the throttle plates are...
  8. Replies
    26
    Views
    5,027

    That kit runs like what 14:1 compression? If you...

    That kit runs like what 14:1 compression? If you turn the motor over without the plug wires connected does it change at all? On cars with lots of compression and alot of advance always spin the...
  9. Replies
    26
    Views
    5,027

    Pm sent. Who did the endurance kits back in the...

    Pm sent. Who did the endurance kits back in the day Riva? Maybe try them
  10. Thought it is 7400. Some guy ran his triple pipes...

    Thought it is 7400. Some guy ran his triple pipes with a stock ignition and thats all he got.
  11. Replies
    34
    Views
    3,827

    You have 2 of these skis, 1 which has had this...

    You have 2 of these skis, 1 which has had this problem twice, you should call an attorney about the Magnusson-moss act. Sounds like you would have a good case.
  12. FS - Parts Pump was rebuilt new seals, bearings and orings...

    Pump was rebuilt new seals, bearings and orings never put in the water. I also have a bunch of different props I can include though most are pretty steep, more for modified boats....
  13. If you look on the backside just inside of the...

    If you look on the backside just inside of the raised rubber lip it is has cracks.
  14. FS - Parts Bump

    Bump
  15. Replies
    3
    Views
    202

    When I lived in Point I mostly rode out of the...

    When I lived in Point I mostly rode out of the Bay ave free launch. It is fine if you get there early, I always tried to get out before 7 am. That ramp is close to F-cove if your into that. Since I...
  16. Replies
    4
    Views
    227

    The stxr install does not mention removing the...

    The stxr install does not mention removing the oil pump. The ultra 150 install says the oil pump causes a fitment issue. I thought the mag pipes were the same on the ultra/stxr but have not fit these...
  17. Replies
    11
    Views
    497

    On the subject of burnt pistons. Does anyone know...

    On the subject of burnt pistons. Does anyone know of a inexpensive+reliable test for fuel octane? Would be a good tool to have in the box.
  18. is there a mark on the motor like it was rubbing...

    is there a mark on the motor like it was rubbing there? I remember Some people were having problems with the front mount pulling out of the hull on the 2002 model. Not saying that is what is going...
  19. Replies
    11
    Views
    356

    Guessing you have no power at the dash? Check for...

    Guessing you have no power at the dash? Check for 12v going in and out of the main breaker even though it shows red. Or check breaker for continuity.
  20. If you want to take the chance on having this...

    If you want to take the chance on having this happen again then absolutely get a cylinder and put it back together without doing the bottom. Take it apart and check it over, aside from the failure...
  21. That rear cylinder is hurt. I saw that you water...

    That rear cylinder is hurt. I saw that you water tested before changing the oil lines and going through the carbs and seemed to run ok. Did you run it hard at that point or were you going easy on it...
  22. compression test

    compression test
  23. Replies
    3
    Views
    237

    WTB The collector is different and pretty sure the...

    The collector is different and pretty sure the PTO pipe is a little different.
  24. Thread: 12 vane 15f

    by TMiller
    Replies
    17
    Views
    569

    Being full stainless they are great for use in...

    Being full stainless they are great for use in salt water. They are heavier than the stock unit. They don't offer a set back unit. I would not use solas impeller seen too many issues with them. Would...
  25. Replies
    3
    Views
    237

    WTB Speedwerx pipes

    Looking for a set of Speedwerx or factory triple pipes for an ultra/stxr
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4