Search

Type: Posts; User: jetdave56

Search: Search took 0.01 seconds.

  1. Hope this helps anyone who tackles this project...

    Hope this helps anyone who tackles this project ..

    Keep in mind the job is ONLY necessary if your SURE you are leaking in the driveshaft or have many hrs on ski like over 200 and are rebuilding...
  2. After releasing the hoist You now need to put...

    After releasing the hoist You now need to put everything back like before I did it in this order...

    1) Intake manifold
    2) fuel injectors O rings fuel rail
    3)top part exhaust manifold and down...
  3. With a good amount of marine silicone put on...

    With a good amount of marine silicone put on thick both the driveshaft plate and transom Mating surfaces and importantly the bolts have silicone as it was in the factory then Tighten down the bolts...
  4. Now it’s time to rebuild the driveshaft plate ......

    Now it’s time to rebuild the driveshaft plate ...

    Have marine grease ready and importantly follow service manual steps which is
    First lube the first small oil seal and hammer or press it in...
  5. Since the oil seals and bearing need to be pushed...

    Since the oil seals and bearing need to be pushed in and out a short distance there’s no real need for the press , a hammer and sockets or bearing drivers will do..
    Its best to have the service...
  6. With the driveshaft pulled under the engine block...

    With the driveshaft pulled under the engine block Now you remove the 4 bolts on the driveshaft plate and get ready to either hammer them out or press them out , Then rebuild ...
  7. Lift engine with enough height and swing it just...

    Lift engine with enough height and swing it just slightly and be careful not pulling any wires or smashing and sensors Your gonna also have to remove the fuel rail those 4 Phillip screws as the...
  8. I lifted the engine th tilt towards the intake...

    I lifted the engine th tilt towards the intake manifold side where there is more space as you will need clearance to get height enough ..
  9. The Jet Pump will need to be removed ,also...

    The Jet Pump will need to be removed ,also Intercooler ,catch can ,top of the exhaust manifold ,Intake manifold , Fuel rail , and SC belt .

    You will need to push engine forward to separate the...
  10. View Post

    Tools youíll need...

    1) a variety of 14,12,10,8,6 mm sockets ,spanners or also known as open end and box wrenches
    2)Stubby ratchet with many extenders ,elbows
    3)new 2 large seals 2 small seals...
  11. How to change the Driveshaft Thru Hull Bearings Seals on Ultra 300/310

    After 265 hrs and a noise in the driveshaft housing and a oil seal torn out from a snapped SC belt it was time to dig in and change it out and it was quite a job and will walk you thru it step by...
Results 1 to 11 of 11