Search

Type: Posts; User: casey67

Page 1 of 8 1 2 3 4

Search: Search took 0.03 seconds; generated 22 minute(s) ago.

  1. Should have a hooded rubber grommet, either near...

    Should have a hooded rubber grommet, either near front of seat or under rear of hood. Vent hose will connect there if still present.
  2. Replies
    12
    Views
    209

    Polaris manual states 6500 operating rpm. Good...

    Polaris manual states 6500 operating rpm.

    Good job on diagnosis so far.

    Correct advice would be to perform a pressure test of the engine/exhaust.
    In my opinion, if it is rock solid-duplicate...
  3. Replies
    7
    Views
    104

    Remove spark arrester, start engine for a couple...

    Remove spark arrester, start engine for a couple seconds. With engine off, squeeze throttle , should see a solid stream of fuel into carb opening.
  4. Pull the jet pump and recheck for rotation. The...

    Pull the jet pump and recheck for rotation.
    The cylinders are Nycasil plated, in theory shouldn't rust.

    Most of these were race ski's, rare to find them stock.So pictures are a MUST inorder to...
  5. Replies
    7
    Views
    104

    https://www.ebay.com/itm/New-Polaris-NOS-OEM-700-S...

    https://www.ebay.com/itm/New-Polaris-NOS-OEM-700-Stator-SLH-Octane-Virage-Freedom-Ignition-4010172-00-04-/172792040086
    This guy also sold stuff on this site, Search his contact info, I believe he...
  6. Replies
    20
    Views
    5,134

    Welcome to GreenHulk. It would probably be...

    Welcome to GreenHulk.

    It would probably be best to start your own thread with a WTB.
    Post pictures of the seats and damage you have.

    The 98 was a one year only 2 piece design. All other models...
  7. The SLT had the choke lever on the handle bar...

    The SLT had the choke lever on the handle bar switch-so NO, it will not work on a Virage.
    This is the official parts site to look stuff up.; http://parts.polarisind.com/Assemblies.asp
  8. Replies
    7
    Views
    104

    Welcome to GreenHulk. Yes it can be tested on...

    Welcome to GreenHulk.

    Yes it can be tested on the bench. The piece that triggers the sensors it the magnet that is pressed into the black plastic ring at the center of the flywheel. That ring is...
  9. Replies
    1
    Views
    62

    John at Watcon.com / Rock county Jetski

    John at Watcon.com / Rock county Jetski
  10. Replies
    9
    Views
    209

    What makes you think it "seems to stop flowing" ?...

    What makes you think it "seems to stop flowing" ?
    Some models had a thermostat and bypass valve installed on the end of the water bar/manifold. See if that has those parts and if stuck. By the way...
  11. Replies
    29
    Views
    886

    Honestly I don't know what the Gen2 is. IIRC it...

    Honestly I don't know what the Gen2 is. IIRC it was a change in CDI.
    As far as I know/all I have ever worked with, there are only 2 versions. Old style is old style and only works with Gen1 stuff.
    ...
  12. Thread: Won't restart

    by casey67
    Replies
    1
    Views
    112

    Does the choke help with starting ? Post a...

    Does the choke help with starting ?
    Post a picture of the carbs. Is the idle set ?
  13. Welcome to GreenHulk. The 97 gas tank will not...

    Welcome to GreenHulk.
    The 97 gas tank will not come out the front. Need to remove the engine.

    If the gas left the stain and trash, I would bet Gas should desolve/clean it.
    Probably need to find...
  14. heystretch ! Welcome to GreenHulk. It would...

    heystretch ! Welcome to GreenHulk.

    It would probably still make sense to make sure the cylinders are equal in temperature after running.
    But from your description, More likely not misfire....
  15. Replies
    29
    Views
    886

    the 2873022 # is for THE update kit- stator CDI...

    the 2873022 # is for THE update kit- stator CDI and 2 cyl coil w/plug wires. Update is GEN3 stator and CDI.Everything needs to be replaced together/only works with Gen3 components. Stator should have...
  16. Good to hear. What exactly did you find in the...

    Good to hear.
    What exactly did you find in the carbs ?

    I'm still wondering about impeller pitch.
  17. Yes blk/yel is from the STOP switch. When...

    Yes blk/yel is from the STOP switch. When grounded by switch, it shuts off CDI entirely. Once it is disconnected at CDI-stop switch will not cause no start.

    Need to get mag piston to top dead...
  18. It stopped running because it lost spark. Now it...

    It stopped running because it lost spark. Now it has spark , but still does not run ?
  19. Replies
    13
    Views
    158

    I tested crankcase pressure on a 700 2 cyl. And...

    I tested crankcase pressure on a 700 2 cyl. And had 4-5 psi and 4-5 inhg suction. If I remember correctly.

    You will need spark plugs installed. Crankcase is open to combustion chamber depending on...
  20. Try to be more specific. It does not have...

    Try to be more specific.
    It does not have "vacuum hoses". Only fuel hoses. If pressure builds up in the gas tank-that pressure will push fuel out of the supply fuel hose UNTIL all pressure it...
  21. Replies
    27
    Views
    744

    Take the battery back to where you bought it, ask...

    Take the battery back to where you bought it, ask them to test it.
    Ask them for the actual cold cranking amps and voltage from the test.
  22. We heard of a couple popping out of the...

    We heard of a couple popping out of the aftermarket "roller bearing" thru hull seal.
    And that was caused by grease pushing it out.

    There isn't a "genuine" Polaris made seal. The seals have an...
  23. Replies
    31
    Views
    739

    Trim location will not affect running/starting. ...

    Trim location will not affect running/starting.

    There are 2 grey wires, the one with flat blade connector is for "limiter" or "warning" circuit. IT was originally a tan wire- there are a couple...
  24. Replies
    31
    Views
    739

    Is the idle about 1200 in the water ? Might as...

    Is the idle about 1200 in the water ?
    Might as well do the TSB jumper to take that out of diagnosis.

    My friends 96 sometimes has issues with the stop/start switch-he took it apart and found...
  25. Replies
    4
    Views
    96

    Same diagram as Polaris industries. And you...

    Same diagram as Polaris industries.
    And you found, identified the fuel sender tube marked "ON" for the fuel supply ?

    The center carb fitting for pulse hose has to be hooked up for fuel pump to...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4