Search

Page 1 of 3 1 2 3

Search: Search took 1.00 seconds.

  1. Replies
    12
    Views
    960

    Add a water strainer and it will last a VERY LONG...

    Add a water strainer and it will last a VERY LONG TIME.. The intercoolers with a strainer installed will last the life of the pwc or longer.
  2. Replies
    17
    Views
    1,405

    YEAH!!

    YEAH!!
  3. Replies
    2
    Views
    232

    Rough idle solution x 2 different skis.

    If your having a rough idle issue between 1800-2500 rpms. We solved 2 problems on different skis by replacing the throttle body to intake manifold gasket.
  4. Replies
    4
    Views
    376

    Problem solved. It was the connector even though...

    Problem solved. It was the connector even though it was cleaned. Worn out connector pins which connects to the engine coolant sensor.
  5. Replies
    14
    Views
    834

    Block is trash. Get a used block and crankshaft.

    Block is trash. Get a used block and crankshaft.
  6. With a flat head screw driver, tap across the...

    With a flat head screw driver, tap across the threads on the cone to make small dents at 4 or 5 locations around it. Add red loctite and tighten it down. No more problems..
  7. Replies
    33
    Views
    4,471

    Oetiker are the best if sized and crimped...

    Oetiker are the best if sized and crimped correctly. They never fail..
  8. Replies
    7
    Views
    380

    Set it at 55 Psi. It should run like a beast at...

    Set it at 55 Psi. It should run like a beast at 12 afrs at wot. I run the et137+4 with 12 afr as a wot target, typically hitting 8500-8600 Rpms with 15 PSI boost on logs.
  9. Replies
    13
    Views
    793

    2004 RXP - Pump System 2005 Challenger 180 4-TEC...

    2004 RXP - Pump System
    2005 Challenger 180 4-TEC SC - Pump
    2005 Speedster 200 Twin 4-TEC SC - Pump
    2005 RXP - Pump
    2006 Speedster 200 Twin 4-TEC SCIC, Edition 1 - Pump
    2006 Speedster 200 Twin...
  10. Replies
    11
    Views
    925

    Those ignition coils are very expensive vs the...

    Those ignition coils are very expensive vs the new 300 coils. Get a 300 valve cover and 3 used ignition coils. The sparks use the same ignition coils as the 300s or from quite a few older suzuki...
  11. Replies
    8
    Views
    689

    Don't buy. Prices will come down.

    Don't buy. Prices will come down.
  12. Replies
    55
    Views
    7,820

    You'll need a logger to adjust tune. I would put...

    You'll need a logger to adjust tune. I would put minimum 93 in it at first. I would have used 8.4:1 pistons, best stable bet. If its a siemens ECU, you won't be able to adjust or view timing with a...
  13. Replies
    12
    Views
    1,511

    I take it back in regards to the ebay seller from...

    I take it back in regards to the ebay seller from Germany. Here is a you tube review..


    https://www.youtube.com/watch?v=BHTMPlmNWHo&ab_channel=Chuckjustforfun
  14. Replies
    24
    Views
    1,163

    Part it out. Don't waste your money on an old...

    Part it out. Don't waste your money on an old piece of junk..
  15. Pull out the spark plugs before flood cranking...

    Pull out the spark plugs before flood cranking it. Much less pressure on the dry bearings..
  16. Yes

    Yes
  17. Replies
    3
    Views
    516

    Pull the head and see if there is any damage..

    Pull the head and see if there is any damage..
  18. Replies
    6
    Views
    542

    Just put in under the press, press down on its...

    Just put in under the press, press down on its edge a little and it will slide fit in..
  19. Replies
    5
    Views
    845

    GROSS... Add a catch can.

    GROSS... Add a catch can.
  20. Replies
    7
    Views
    577

    You sell the one you have and buy the one you...

    You sell the one you have and buy the one you want is the best way.. And the difference is about 70 Hp..
  21. Replies
    2
    Views
    241

    Metric.. 1/4 inch socket should work as well..

    Metric.. 1/4 inch socket should work as well..
  22. Replies
    1
    Views
    230

    Carbon buildup on the pistons is about it.....

    Carbon buildup on the pistons is about it.. Idling is Less wear then riding constantly at 8000 rpms as long as oil pressure is fine..
  23. Replies
    1
    Views
    297

    Put in the original stock impeller and enjoy it...

    Put in the original stock impeller and enjoy it for many problem free years to come..
  24. Replies
    35
    Views
    3,416

    Never had an issue charging through the winter...

    Never had an issue charging through the winter with it still connected in the craft.
    Battery Tender 021-0123 Battery Tender Junior 12V, 0.75A
  25. A member off the forum was kind enough to PM me...

    A member off the forum was kind enough to PM me and walked me through a way they use, to check alignment without the tool. So I could check how well aligned it remains after moving the engine over...
Results 1 to 25 of 67
Page 1 of 3 1 2 3