Search

Type: Posts; User: K447

Search: Search took 0.11 seconds.

  1. Sticky: View Post

    Either a ‘12 volt’ integrated LED light or a simple bare LED with an inline resistor.

    I typically use a nothing special basic single LED with a 330 ohm resistor soldered in series, as shown in...
  2. Sticky: http://greenhulk.net/forums/showthread.php?t=10041...

    http://greenhulk.net/forums/showthread.php?t=100412&p=1139255&viewfull=1#post1139255

    There are three connectors involved.
    The 12-pin connector unplugged from the back of the dash display.
    The...
  3. Sticky: The check engine warning on the dash appears when...

    The check engine warning on the dash appears when an active fault is occurring that the EMM knows about. Not all trouble code conditions will trigger the check engine warning.

    The Ficht EMM...
  4. Sticky: I added more details to my prior reply.

    I added more details to my prior reply.
  5. Sticky: Look at this, Virage & Genesis MFI security...

    Look at this,

    Virage & Genesis MFI security bypass jumper

    http://www.greenhulk.net/forums/attachment.php?attachmentid=138481&d=1245738041

    ONLY the Virage and Genesis have a security mode in...
  6. Sticky: Welcome :) Where are you located?

    Welcome :)

    Where are you located?
  7. Sticky: Sometimes it has taken me several tries before...

    Sometimes it has taken me several tries before the EMM would actually clear old codes using the non-DW method, but I have not had the problem of the old codes never clearing.

    The timing cadence...
  8. Sticky: http://youtu.be/yfad0JKfF-A

    Videos are dead. Can they be reposted?[/QUOTE]
    http://youtu.be/yfad0JKfF-A
  9. Sticky: I don't think SPX will actually sell that to...

    I don't think SPX will actually sell that to anyone who is not an authorized Polaris dealer.

    That is why reading the EMM trouble codes with the LED is useful.
  10. Sticky: Corrected; Made using a Deutsch DT04-12P...

    Corrected;
    Made using a Deutsch DT04-12P connector, along with a few pins (example 16 AWG pin size 0460-202-16).

    In Deutsch connectors, the DT04 is the shrouded receptacle shape, and the DT06 is...
  11. Sticky: Check the hose routing against the online...

    Check the hose routing against the online diagrams, just to be sure nothing else is wrong.

    The way I think it works, is the cooling water under pressure from the jet pump flows through a large...
  12. Sticky: Overheated EMM - code 25

    Sounds like the machine was run without water cooling, either clogged water intake, or run out of the water.

    If the EMM gets too hot, it can cook the electronics. Sometimes the cooked EMM...
  13. Sticky: Ficht EMM Service code 144 - WATER INJECTION SOLENOID CIRCUIT MALFUNCTION

    There is one three digit code that is mentioned in the service code PDF attached to the first post;
    144 WATER INJECTION SOLENOID CIRCUIT MALFUNCTION

    The water injection solenoid is unique to the...
  14. Sticky: Reading the Ficht EMM diagnostic LED code flashes

    If the diagnostic LED is now blinking, you can read the EMM Service Codes.

    The EMM will start the pattern with a long 3 second LED on, followed by quicker flashes. Count the flashes. When the...
  15. Sticky: Now you hook up the diagnostic connectors. 1)...

    Now you hook up the diagnostic connectors.

    1) The Service Code Light 2872455, or your simple LED with two wires, connects to the wire harness connector for the MFI display.
    Note: This is not the...
  16. Sticky: How to make the Ficht EMM Service diagnostic connectors (PN 2872455)

    B) Next is the Polaris Ficht Service Code Light (PN 2872455)

    Made using a Deutsch DT04-12P connector, along with a few pins (example 16 AWG size 0460-202-16).
    It has a red LED plus a resistor in...
  17. Sticky: How to make the Ficht EMM Service Power jumper (PN 2872456)

    The Polaris diagnostic documents assume you have the official Polaris diagnostic connectors and such. You can make your own exact equivalent connectors, but you can also use short pieces of wire and...
  18. Sticky: How to read Polaris Ficht EMM trouble codes using Simple LED tool

    How to read Polaris Ficht EMM trouble codes using a simple LED tool, without special software or a computer

    I have not yet checked this on every Polaris Ficht EMM version, but so far it has worked...
Results 1 to 18 of 18