Search

Type: Posts; User: K447

Page 1 of 8 1 2 3 4

Search: Search took 0.30 seconds.

  1. Replies
    14
    Views
    375

    This is the problematic Yamaha oil cooler I was...

    This is the problematic Yamaha oil cooler I was referring to.

    http://greenhulk.net/forums/showthread.php?t=284391&p=3059393&viewfull=1#post3059393
    ...
  2. Replies
    14
    Views
    375

    View Post

    Hmmm - oil that looks like ‘milkshake’ is indicative of water mixed into the oil. :-k

    Which type of oil cooler is on this engine?
    Is it the ‘stacked plate’ design, which is known to fail?
    ...
  3. Replies
    14
    Views
    375

    Water is a byproduct of gasoline combustion....

    Water is a byproduct of gasoline combustion. Blowby of combustion gases past the piston rings and into the engine crankcase is also normal.

    Typically when the engine is run hard for long enough...
  4. Thread: Motobatt Battery

    by K447
    Replies
    2
    Views
    123

    I know nothing about the Motobatt branded...

    I know nothing about the Motobatt branded product.

    I can recommend the Deka ETX type factory sealed AGM battery. I have used them for years in multiple watercraft. Excellent reputation and...
  5. Or put the rubber faucet washer on the impeller...

    Or put the rubber faucet washer on the impeller end of the driveshaft ;)
  6. Moved.

    Moved.
  7. In a pinch you can use a flat rubber washer,...

    In a pinch you can use a flat rubber washer, found in the hardware store plumbing section.

    Flat faucet washer about 2/1” or 5/8” in diameter, look for one about 1/4” thick, maybe a bit more.
    ...
  8. Replies
    33
    Views
    3,966

    Fixed now, I think.

    Fixed now, I think.
  9. My understanding is that the calendar rebuild...

    My understanding is that the calendar rebuild schedule imposes a maximum time between rebuilds (for the Seadoo supercharger generations with specific recommended rebuild intervals).

    Depending on...
  10. Replies
    33
    Views
    3,966

    Th-1890 ...

    Th-1890

    http://greenhulk.net/forums/attachment.php?attachmentid=458356&stc=1
  11. Replies
    33
    Views
    3,966

    Link goes to a page showing many fittings? ...

    Link goes to a page showing many fittings?

    TH-1890 would be the part number for the tight right angle fitting without the internal threads in the outlet, correct?
  12. Replies
    33
    Views
    3,966

    About 200 riding hours and three summers. No...

    About 200 riding hours and three summers. No issues with the bond holding the bilge pump in place.

    Two bilge pumps on two 2017 GP1800 installed the same way. No issues.
  13. Replies
    2
    Views
    98

    http://greenhulk.net/forums/showthread.php?t=28384...

    http://greenhulk.net/forums/showthread.php?t=283843&p=3054017&viewfull=1#post3054017
  14. Replies
    46
    Views
    8,168

    Stages of tune are directly related to the...

    Stages of tune are directly related to the installed hardware modifications.

    In Riva MapTunerX speak a Stage 1 tuned engine should have (almost) no hardware changes. Stock engine with the tune. ...
  15. Replies
    11
    Views
    487

    Would the ECU trouble code history be lost if the...

    Would the ECU trouble code history be lost if the battery was disconnected immediately after each 'reduced power' event?

    The OP is cycling a battery disconnect switch while afloat each time the...
  16. Replies
    11
    Views
    487

    Make sure the battery disconnect switch is NOT...

    Make sure the battery disconnect switch is NOT causing problems.

    When riding hard in rough water it is important that the switch itself and the extra cable connections are very solid contact.
    ...
  17. Hmmm. There ARE some old watercraft info type...

    Hmmm. There ARE some old watercraft info type things that it sure would be nice to see :-k
  18. Replies
    11
    Views
    487

    I would be suspecting either there is damage or...

    I would be suspecting either there is damage or some other (connector?) problem with the wiring that was moved/disconnected in the area around the intake manifold.

    OR the timing of the...
  19. http://greenhulk.net/forums/attachment.php?attachm...

    http://greenhulk.net/forums/attachment.php?attachmentid=458244&stc=1

    http://greenhulk.net/forums/attachment.php?attachmentid=458245&stc=1

    RAM-111BU
  20. The mount? The plastic part that holds the actual...

    The mount? The plastic part that holds the actual Garmin?

    Posted in the linked thread.
  21. Here are some details on how I mount my Garmin...

    Here are some details on how I mount my Garmin 95SV on GP1800.

    http://greenhulk.net/forums/showthread.php?t=271210&p=3058196&viewfull=1#post3058196

    I have two RAM ball mounts, one on each side...
  22. Thread: '19 fx svho

    by K447
    Replies
    10
    Views
    404

    This thread might help ...

    This thread might help

    http://greenhulk.net/forums/showthread.php?t=265447&p=2891795&viewfull=1#post2891795

    http://greenhulk.net/forums/attachment.php?attachmentid=420516&d=1504207082
  23. Replies
    5
    Views
    5,799

    Sticky: Must be wintertime ... somewhere ...

    Must be wintertime ... somewhere ...
  24. What model and year are you riding? Stock SVHO...

    What model and year are you riding?

    Stock SVHO GP1800 with factory engine tune? If so, there is a speed limiter that will reduce engine throttle just enough to bring speed down to about 69 mph.
    ...
  25. Replies
    2
    Views
    96

    The front edge of the ride plate? Right where...

    The front edge of the ride plate?

    Right where the intake grate meets the ride plate?
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4