Search

Type: Posts; User: Teufelhund

Page 1 of 7 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    96
    Views
    9,093

    yes the wire just loops thru the 2 holes which...

    yes the wire just loops thru the 2 holes which holds it secure then, but is also easily removable.
  2. Replies
    96
    Views
    9,093

    View Post

    So, itís a completely smooth plastic case, the 2 small holes on side are where u run the wire from wrapped coil pack. I also used some clear gorilla tape to seal from to plastic case as itís...
  3. Replies
    96
    Views
    9,093

    Yeah that’s a good price I think I paid $208 for...

    Yeah that’s a good price I think I paid $208 for mine. I used this Velcro (plastic + waterproof) from Lowes, and attached it to the top of my glove box lid.

    3-in x 1-in 2-Pack Clear Fastener...
  4. Replies
    12
    Views
    489

    No, it’s the gp in my signature, we stopped and...

    No, it’s the gp in my signature, we stopped and got fuel at a marina. (Yikes on price!). Yes, it’s the same tank, only 18.5 gallons
  5. Replies
    96
    Views
    9,093

    ONLY place I could find mine was eBay. All...

    ONLY place I could find mine was eBay. All pretty similar at about $210, I tried to find the one with best seller and shortest time combo. It’s about 2-3 weeks shipping, coming from Japan. No one...
  6. Replies
    12
    Views
    489

    Here’s todays data, rode 112 miles on dash (which...

    Here’s todays data, rode 112 miles on dash (which the first stop was within .3 miles of google). Fuel used was 18.5 gal, at a rate of 5.9 mpg on dash. Was riding 45-55 mph for most of cruising, a...
  7. Replies
    21
    Views
    3,712

    Here is a previous thread on this subject, u can...

    Here is a previous thread on this subject, u can see the potential problem areas, but overall I’d think there’s no difference between this and tapping the manifold directly.
    ...
  8. Replies
    96
    Views
    9,093

    Very cool, nice to have that info for my build…u...

    Very cool, nice to have that info for my build…u just elongated the bolt holes to offset to the rear and that was all you needed? Glad to hear 85 mph, I’m hoping to be there +1-2 more. I’ll have to...
  9. I too use the motorcraft fl400s. ...

    I too use the motorcraft fl400s.

    https://www.amazon.com/dp/B000AS3D42/ref=cm_sw_em_r_mt_dp_SEZDB9WMDWWBACNGYKZA?_encoding=UTF8&psc=1

    Here’s an older link with a plethora of cross referenced...
  10. Replies
    96
    Views
    9,093

    Lol, u can seriously drill the hole for the thru...

    Lol, u can seriously drill the hole for the thru fitting with the pump in?? Haha I’m not putting a hole in my hull without like quadruple checking things and that pump gotta be out my way:smt119!
  11. Replies
    96
    Views
    9,093

    Just curious, if you think you don’t need to...

    Just curious, if you think you don’t need to remove the pump, does that mean you are not installing the pro cooling kit? Seems impossible to install without pump out… Ofc you don’t need the pro...
  12. Replies
    12
    Views
    489

    Yeah I haven’t logged total consumption but I...

    Yeah I haven’t logged total consumption but I also was averaging about 5-5.5 mpg from dash computer, I reset before each ride to follow tank to make sure I’m not actually on empty
  13. So I have the same basic mods as tucker…except...

    So I have the same basic mods as tucker…except haven’t done ribbon delete yet. I have gen 2 riva ride plate + intake grate. I never ran my stock ride plate on my stage 1+ so I can’t compare. Using...
  14. Replies
    96
    Views
    9,093

    View Post

    the coupler I refer to is the factory 90į coming off the hull is replaced with a very short straight piece by Worx. The hose then goes from water box to that new “coupler”. The tach I have now is the...
  15. Replies
    96
    Views
    9,093

    I left water box stock, added worx free flow...

    I left water box stock, added worx free flow going out factory hole in hull, only changed the coupler. I didn’t notice much top end speed, perhaps a tiny bit of extra pull…my prop is too tall, I...
  16. Replies
    96
    Views
    9,093

    Just rode tonight after adding a Worx free flow...

    Just rode tonight after adding a Worx free flow exhaust to my setup…gotta say, I’m not a big fan, fairly annoying drone thru 2500-5000 rpm, gotta be going near 45 before it subsides. My first...
  17. There’s a locking lever, you slide it and the...

    There’s a locking lever, you slide it and the socket will start to release
  18. Maptuner

    This one
  19. Lol, of course..that will be my next problem in...

    Lol, of course..that will be my next problem in my journey to stage 2, maptuner won’t work :facepalm:
  20. Replies
    96
    Views
    9,093

    K447, u are absolutely one of the best sources of...

    K447, u are absolutely one of the best sources of info here in the forums, with a wealth of knowledge just overwhelming at times. I agree in principle on what your saying, but the reality of exposed...
  21. Replies
    96
    Views
    9,093

    Dual battery vid

    Hereís a link to my description of my wiringÖlol, keep in mind Iíve no aspirations to be a YouTube star, hence my poor vid skills

    https://youtu.be/2NvalvG7w-A
  22. Replies
    96
    Views
    9,093

    Wiring schematic

    Hereís my wiring setup. Lol, donít judge my drafting skills, itís only one cup of coffee so far :)
  23. Replies
    96
    Views
    9,093

    https://youtu.be/JCHxkcBTUZ0 This video shows the...

    https://youtu.be/JCHxkcBTUZ0 This video shows the set of aluminum bars machined by Michael, and the extra battery box. I only bought the partial kit, and made my own wire. The battery is a deka...
  24. View Post

    FYI, A 1Ļ⁄₁₆ socket is approximately .01mm off the 27 mm size of the hex on the impeller, so virtually indistinguishable…
  25. FYI, I did actually remember this question...

    FYI, I did actually remember this question yesterday and intentionally left my screen on fuel page, it automatically switched to speedo page when I go into forward drive…
Results 1 to 25 of 152
Page 1 of 7 1 2 3 4