Search

Type: Posts; User: TMiller

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    41
    Views
    5,801

    All those cool new gadgets....I just threw up in...

    All those cool new gadgets....I just threw up in my mouth
    I am confused about the headlights . Around here you cant ride after sundown or has that changed?
  2. Replies
    47
    Views
    2,427

    Wait so you didnt change any parts this last go...

    Wait so you didnt change any parts this last go around? Could you post a short video of how the starter reacts with your new procedure if it s not too much trouble?
  3. Replies
    18
    Views
    595

    did you try removing the boots, trimming the...

    did you try removing the boots, trimming the wires back and re-installing the boots?
  4. Replies
    12
    Views
    286

    what do the spark plugs look like?

    what do the spark plugs look like?
  5. Replies
    47
    Views
    2,427

    Doesnt someone have capability to change timing...

    Doesnt someone have capability to change timing map on the oem box? Maybe in australia ?
  6. Replies
    47
    Views
    2,427

    Didnt you send the ecu out to have the cranking...

    Didnt you send the ecu out to have the cranking timing checked/adjusted ? What was it/is it at now?
  7. FS What is the deal with the dual exhaust? How did...

    What is the deal with the dual exhaust? How did they set that up?
  8. Replies
    9
    Views
    899

    Make sure to check dimensions against the...

    Make sure to check dimensions against the replacement. I remember hearing someone tried an LX fitting in a 310 and the cable was to too big to pass through.
  9. Replies
    6
    Views
    629

    SOLD Bearings/shaft in the 15f are also bigger than in...

    Bearings/shaft in the 15f are also bigger than in the older 2 stroke pumps
  10. Replies
    9
    Views
    899

    Best would be find a part out hull. Possible you...

    Best would be find a part out hull. Possible you could find the next size down nut and have the machine shop thread the fitting to match if there is enough material to support.
  11. Replies
    10
    Views
    814

    Cases that have been through sbt shouldnt be any...

    Cases that have been through sbt shouldnt be any different aside from the color. Just watch out for repairs, I have seen alot of them with the bottom half welded. SBT cylinders on the other hand will...
  12. I guess first verify that jumping the 2 wires...

    I guess first verify that jumping the 2 wires will shut the light off. If that works you could either find a junk/cheap kawasaki part with the same oil tank side connector and jump that out or you...
  13. Replies
    9
    Views
    447

    SBT ? complete motor or just the top end?...

    SBT ? complete motor or just the top end? Everyone here wants to see more pics after it is all apart
  14. obvious signs of pump failure would be rough...

    obvious signs of pump failure would be rough bearings or water in rear cone upon inspection. Always a good idea to pull pump and check at least once or twice a season.
  15. check the resistance across the sender with the...

    check the resistance across the sender with the floats in the up/full position that should give you the value.
  16. Replies
    30
    Views
    1,994

    I was going to ask how long you have owned this...

    I was going to ask how long you have owned this thing. Was going to say looked like the last owner stuck #3 -put a new piston it in and sent it on its way.
  17. Replies
    30
    Views
    1,994

    was the battery in good condition?

    was the battery in good condition?
  18. If the cases are damaged you will have to send...

    If the cases are damaged you will have to send them a good set with your core or they charge extra. Same with crank if it is beyond repair
  19. Dont need to pull the motor to check for wasted...

    Dont need to pull the motor to check for wasted thrust bearing. Use a large prybar between the motor and coupler pry back then bar between both couplers and pry forward. There is a spec in the manual...
  20. Replies
    0
    Views
    247

    FS - Parts ADA domes for Ultra 150/STXR

    I have a few sets of ADA domes for a Kawi 1200 that I looking to sell separate from the heads I have for sale. I have 3/44cc domes 2/42cc domes both for stock pistons and 3/26cc domes for flat top....
  21. Replies
    10
    Views
    1,914

    FS Bump

    Bump
  22. Replies
    3
    Views
    482

    Best way to get the old valves out is drill with...

    Best way to get the old valves out is drill with 1/8" bit then run a screw in and use a slide hammer.
  23. Replies
    11
    Views
    596

    There is also a large opening in front of the...

    There is also a large opening in front of the steering under the cowl. I have an extra hull or 2 if I was really bored I would like take it and put it in the water upside down. If everything on the...
  24. Replies
    9
    Views
    1,028

    East coast watercross has most of the 2021 dates...

    East coast watercross has most of the 2021 dates posted. Looking good - https://www.facebook.com/ECWatercross
  25. Replies
    5
    Views
    1,434

    Not sure a stock motor will turn that 155. 13/26...

    Not sure a stock motor will turn that 155. 13/26 maybe in a 148 pump
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4