Search

Years ago I had a Garmin 76 size model. The postage stamp screen was impossible to read at speed and showed far too little detail when zoomed out to show where I was going, and when zoomed in to see...

You probably should be looking at 4-stroke engines from a brand that is still making PWC. My own preference is Yamaha.

Unclear why this post was not refuted earlier. My bad, I suppose.

Lakeside does excellent EMM repair work. Darrin has developed multiple Ficht EMM specific repair methods, researched and refined...

How much money are you willing to spend getting them into reliable and good running condition?

Assume each needs EMM repair.
Plus the fuel pump regulator reinforcements.

All the original...

Last I heard that division of PVL had gone into bankruptcy or had ceased production of those old-school CDI ignition products. I have not verified whether this is accurate.

Apparently a few...

I posted some info in your other thread.
http://greenhulk.net/forums/showthread.php?t=291126&p=3112657&viewfull=1#post3112657

Hours do not matter much on a twenty year old watercraft.

Current condition and potential repair difficulty and repair costs matter more.

There are several common problems with Polaris Ficht...

I will mention that with stainless steel bolts and screws, especially the medium to smaller sizes, a power impact tool can twist the bolt head or snap the nut clean off using impact power.

Or...

Apparently nobody does anymore. :(
The last of mine were sold a year or two ago.

There is a workaround by retrofitting a non-pigtail (available from non-Polaris sources) TPS equivalent. Tricky...

Stock, there is just normal full power mode and Learner (power/speed limited) modes.

Normal mode on Yamaha is equivalent to Seadoo Sport mode.

Engine will start and run in whichever mode it...

It is 2021 and I do not want this stuff sitting around come springtime. If it is still listed below then I probably still have it, for now.

Make me an offer.

Shipping will be from Ontario,...

Link does not work for me.

This diagram?

http://greenhulk.net/forums/attachment.php?attachmentid=338684&d=1407962172

I do not know how many people have used the alternate 8/9 volt source. In a few cases the initial reports were good and no updates since. At least one case the CDI subsequently failed entirely.

If...

You going to leave the aftermarket supercharger wheel and impeller in place? With a stock tune?

Check whether there is a wiring short or crossed wires in the electrical box related to the Brown stator wire and Brown CDI wire. There may be other brown wires in there that have nothing to do with...

Stock ECU tune, stock fuel pressure regulator?

I have no information on this particular machine.

I do recall that some (I do not know how many) 2003 MSX 140 were assembled at the factory with bolts for the Ficht stator that were too long for...

:|

Welcome.

http://polarispwcknowledge.shorturl.com/first-things-to-do

Click on My Profile, top right of web site.

Add your location so others who might be nearby can offer help.

What country are you in?

A Ficht engine does not care much about mild crankcase or intake air leaks. The Ficht throttle plates have huge holes that intentionally allow plenty of air flow during partially closed throttle...

When running properly the Ficht system has tight control over the fuel:air ratio. The system works very differently to a tradtional carb engine, including how the fuel is mixed into the air. In...

Welcome.

Adding oil to the fuel tank on a Ficht fuel injected engine does not provide any additional lubrication to the engine. The fuel is injected directly into the combustion chamber, where it...

That would have been the actual jet pump thrust flow, not the visibility spout. Has happened multiple times to people on all brands of PWC.

Rapid acceleration (or just a loose grip at speed)...