Search

Type: Posts; User: woodsrider40

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    5
    Views
    130

    Thanks you guys !

    Thanks you guys !
  2. Sticky: I know this is an old post. Is the 98 XL 1200...

    I know this is an old post. Is the 98 XL 1200 same as the gp ? Is the N/S 1.2 or change, any jetting needs done and last what pop off pressure.
  3. Replies
    5
    Views
    130

    How do I go about the mod ? Link how to ? ...

    How do I go about the mod ? Link how to ?

    Thanks
  4. Replies
    5
    Views
    130

    98 XL1200 Yamaha pop-off pressure

    I'm trying to find the ideal pop-off pressure for this 98 XL1200 non power valve motor. I put new 1.2 needle and seats back in, did pop-off reading around 72 psi which I thought it was kinda high. I...
  5. I got mine from seadoo. It connects between the...

    I got mine from seadoo. It connects between the fuel rail and hose. Not cheap.
  6. Replies
    8
    Views
    266

    The oil is new so replace it when I checked the...

    The oil is new so replace it when I checked the pump. It doesn't hurt to check it again to be sure no binding, anything could happen from then till now. Money sent.
    Thank you
  7. Replies
    8
    Views
    266

    It doesn't hurt to try, I'll take it if it good I...

    It doesn't hurt to try, I'll take it if it good I will leave it in. PM me your PayPal. Thank you.
  8. Replies
    8
    Views
    266

    He bought the aftermarket I believe was a Rick...

    He bought the aftermarket I believe was a Rick stator if I remember correctly. You think it might be the stator ?
  9. Replies
    8
    Views
    266

    He bought the ski with a bad motor so he went...

    He bought the ski with a bad motor so he went with an SBT remain it ran good for a year and a half then the stator had a heat soak replaced that it did run better but shuts down so got an good low...
  10. Replies
    8
    Views
    266

    2004 Seadoo GTI le RFI not right

    Hello all, I am dealing with a GTI le RFI at frist the MPEM and ECU was bad replaced with a good used one and replaced the stator new. It runs good straight till I turn it struggles to get the RPM's...
  11. Replies
    3
    Views
    216

    I am dealing with the same issue it runs good...

    I am dealing with the same issue it runs good just hard starting after it get hot. I have read to check the fuel pressure which should be 58-60 psi and should hold this pressure for more then one...
  12. Thank you ! I will get it packed up and ready. ...

    Thank you ! I will get it packed up and ready. I'll let my customer know. I will be sending others to you if I get anymore that needs fixed.
  13. I finally got to swap EMM so the ski ran pretty...

    I finally got to swap EMM so the ski ran pretty good like it should. Now we know Harris didn't fixed the EMM that got sent back 3 times. Yeah I am eating my time.
  14. Replies
    10
    Views
    1,237

    Had this happened once I pulled the choke & full...

    Had this happened once I pulled the choke & full throttle. I adjusted the air screws to fix the problem.
  15. Replies
    9
    Views
    892

    Needs realined for sure & the port looks like...

    Needs realined for sure & the port looks like they need chamfer to keep from grabbing the rings.
  16. More likely the motor will have to be pulled to...

    More likely the motor will have to be pulled to swap fuel tanks.
  17. Thank you I just wanted to make sure. If this...

    Thank you I just wanted to make sure. If this will run with the swapped EMM then I will know that the one got sent back 3 or 4 times still not working right.
  18. Ok I have gotten the EMM back from Harris a week...

    Ok I have gotten the EMM back from Harris a week ago stuck it back in it's doing the same old thing. I know I can use another one for test only but is it ok if use for water testing just a short...
  19. Replies
    15
    Views
    657

    WTB Paid

    Paid
  20. Replies
    15
    Views
    657

    WTB Pm sent

    Pm sent
  21. Replies
    15
    Views
    657

    WTB I didn't see anything & moves freely but feels...

    I didn't see anything & moves freely but feels like it not got enough spring pressure like the others by feel.
  22. Replies
    15
    Views
    657

    WTB If you find it I'll take it. Thank you.

    If you find it I'll take it.

    Thank you.
  23. Replies
    15
    Views
    657

    WTB It has 18 PSI no higer so it must have a weak...

    It has 18 PSI no higer so it must have a weak spring.
  24. Replies
    15
    Views
    657

    WTB You give a price. I cannot find one any were...

    You give a price. I cannot find one any were unless I buy a whole fuel pump which I don't need, the fuel pump is working when I pinched the line showing 30 PSI. You give me a price tag before you go...
  25. Replies
    15
    Views
    657

    WTB Fuel pressure regulator

    I'm in need of a Fitch fuel pressure regulator.


    Thanks
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4