Search

Type: Posts; User: K447

Page 1 of 8 1 2 3 4

Search: Search took 0.35 seconds.

  1. Replies
    6
    Views
    94

    These are old machines. During the ignition...

    These are old machines. During the ignition upgrade the engine was messed with, the electrical box was tugged around, etc.

    The pitot tube runs down through the steering assembly and through the...
  2. Replies
    19
    Views
    809

    Fogging the engine has little to do with the...

    Fogging the engine has little to do with the temperature during storage, and more to do with protecting the metal from corrosion during storage. Fogging the engine is not done because the machine...
  3. Replies
    6
    Views
    94

    For the speed reading on MFD, as far as I know it...

    For the speed reading on MFD, as far as I know it self-calibrates at each ‘wake up’. The speedo function is independent of the voltage calibration and the hour counter. I do not know what you are...
  4. Replies
    7
    Views
    134

    I do not remember whether the 146mm pump base on...

    I do not remember whether the 146mm pump base on the early hulls will directly bolt up to the 148mm jet pump.

    Or does the entire old 146mm pump unbolt from the hull and be replaced by the 148mm...
  5. Replies
    6
    Views
    94

    The speedo reading is entirely determined by air...

    The speedo reading is entirely determined by air pressure. There is a differential air pressure sensor inside the MFD. It compares ambient air pressure with the air pressure coming from the connected...
  6. Replies
    11
    Views
    407

    Make sure you removed the small single bolt along...

    Make sure you removed the small single bolt along the left side of the jet pump.

    I forgot about that small bolt once, ended up bending the little bolt before I realized my error. Bought a...
  7. Sticky: Those that need the info can try again...

    Those that need the info can try again.

    During the coming winter season, perhaps the Polaris PWC community can get together and get some/most of the site converted, updated and hopefully improved....
  8. Replies
    5
    Views
    84

    There are time limits on running the engine with...

    There are time limits on running the engine with the jet pump out of the water.
  9. Replies
    19
    Views
    809

    Which flash?

    Which flash?
  10. Replies
    11
    Views
    407

    How long has it been since you last put the pump...

    How long has it been since you last put the pump on?

    Is the pump body stuck in place?
    Can you get the pump body to separate from the forward portion and move a few mm rearwards?
  11. Replies
    19
    Views
    809

    Thank you for that Yamaha Tech Exchange PDF...

    Thank you for that Yamaha Tech Exchange PDF

    WCA2011-003
    Engine Fogging Recommendations for Current Waverunners and Yamaha Boats

    Written for the SHO engine, looks like it would directly...
  12. Replies
    8
    Views
    169

    My Garmin will read to depths beyond 500 feet...

    My Garmin will read to depths beyond 500 feet (and I have seen that on my own screen) and will report depth while traveling at speeds of 50mph.

    The depth sensor is at the rear of the hull but...
  13. Replies
    19
    Views
    809

    Where is this documented?

    Where is this documented?
  14. Replies
    2
    Views
    89

    Vertical rubber flaps? They can be deleted....

    Vertical rubber flaps?

    They can be deleted. They provide a degree of sound reduction for the exhaust.
  15. Replies
    8
    Views
    169

    There are in-hull transducers available. The...

    There are in-hull transducers available. The trick is finding a spot inside the hull where there is no inner liner (sonar requires attachment directly to the inside surface of the actual outer hull...
  16. Replies
    14
    Views
    136

    http://polarispwcknowledge.shorturl.com/first-thin...

    http://polarispwcknowledge.shorturl.com/first-things-to-do

    Did you use this link to find the PVL Ignition Upgrade Kit instructions?

    The thin Black wire from the stator does need to connect to...
  17. Replies
    7
    Views
    134

    My suggestion would be to source an entire...

    My suggestion would be to source an entire 1994-1995 SL650 jet pump assembly. The impeller should be reasonably close to a match for your 1993 engine power (the 650 engine HP rating increased a bit...
  18. Replies
    2
    Views
    101

    View Post

    You are asking about what is often called a ‘pump seal kit’.
    Why it is called that, I cannot say. :smt102

    I prefer to use a manufactured kit that consists of molded ‘rubber’ inserts that slide...
  19. Replies
    8
    Views
    169

    Have a look in the Fishing section on GH. There...

    Have a look in the Fishing section on GH. There are threads that discuss chartplotter and fish-finder equipment and related.

    I have also posted in several threads regarding the Garmin EchoMAP 95SV...
  20. Replies
    14
    Views
    136

    The stator came with the CDI from SBT?

    The stator came with the CDI from SBT?
  21. Replies
    7
    Views
    134

    The impeller outer edges are binding against the...

    The impeller outer edges are binding against the surrounding wear ring surface, correct?

    If so, it sounds like corrosion may have occurred between the stainless steel inner liner (the actual wear...
  22. Replies
    14
    Views
    136

    Photo of the black wire problem?

    Photo of the black wire problem?
  23. The correct MFD fuse is 1/4 Amp, not 3 amps. It...

    The correct MFD fuse is 1/4 Amp, not 3 amps. It is over an inch long.

    The factory bilge pump, if you have one, uses a 3 amp fuse. This is a stubby fuse.
    It feeds from Orange and then goes to...
  24. Replies
    19
    Views
    809

    Fogging the engine is about protecting metals...

    Fogging the engine is about protecting metals inside the engine from risk of rusting. That has little to do with cold temperatures, other than cold storage tends to be for long duration.

    Storage...
  25. Replies
    1
    Views
    115

    That looks about right, going from memory. You...

    That looks about right, going from memory.

    You can view the Polaris Industries online parts diagrams via this link.
    http://polarispwcknowledge.shorturl.com/first-things-to-do
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4