Search

I do not see why it wouldn't work.

Worst case scenario you can just put a scavenger pump on it.

Just wondering how i could bypass 3000 rpm reverse limiter on 09 fzr ?

Just discontent the plug and jump the two pins ?

You are probably right. Might have to look at different piping. Maybe run it under the rear seat.

Almost done


470863

Its the housing where your magnito is and the driveshaft coupler

Thats exactly where i put mine also.

Thank you 👍

Can you tell me what wire you have used from the cluster ?

I was also thinking of wiring it to the bilge pump. The bilge pump usually stays on with the engine off for about 30seconds.

Any thoughts ?

Hello, i was wondering what people are tapping in to for 12v power source.

I want it only to stay on when the engine is on.

Any help is greatly apriciated

Sti pink injectors will be ok ?

Sorry to bother you again.

As far as fuel system goes.

Do I need to replace factory fuel pump ?

Looking to run approximately 20psi

I assume I need to purchase a rrfr

Thank you, much apriciated

Thank you. Just to confirm its this one?

469461

Working on my turbo setup. Just wondering where you guys tap in to for the turbo drain line ? 469453469453469453

Does anyone know much power/boost you can you safely get out of the sho engine, before you need to use block guard, update pistons, rods, timing chain ?

I use 5200 on the transom plate. I would not use that on the intake grate. Will be difficult to remove

My ski did the same thing. I had an air leak around the mid-wall where driveshaft coupler...

Have some parts for sale. Going turbo

Riva supercharger upgrade brand new. Never installed #450usd shipped

Fizzle intercooler pipe $100usd shipped

Sho supercharger has 300 hours on. Still...

I would go with the FX. More stable.

VX the 2006 - 2014 generation nose dives when the fuel tank is full.

Looks like mr1.

Rare combo that only came in 2015.

First year of the new vx hull and last year of the mr1

These engine are usually very good. I have a couple almost at 700hrs

I...

Yes, there will be a step going from throttle adapter plate to manifold

Just thought I would share this as an alternative to buying the sleeve insert

All you need is an aluminum carbide bit, drill, and a cup full of engine oil to cool down the tip.

466882

Thank you

I just ordered one to upgrade from the 155mm

I am mostly interested in holeshot. So this is good news

Just wondering why nobody uses the solas 12 vane stainless race pumps

Are they just too expensive ?

466860

I had a simular issue to this. Ended up being wiring harness