Search

You can clean the intercooler. Also put a catch can on there and help eliminate that from happening again.

I know people say its "normal" to see carbon dust but imo this is not "normal". I have had and seen many sea doos and never seen carbon dust like I do on the new ones. Even ones with failures. I'm...

At 8800 rpm I would say high 80s. I would also recommend at least retainers to be safe.

Having tested different plates my self the extended dean cut plate wasn't the fastest on flat water, but...

What is your Dean's reflash limiter?

if the engine alignement is good there should be no dust.

Awesome project you got going on with your son! Keep us posted

They dont last long on a car. I cant see them lasting in a totally damp environment. It would only worth with a dual exhaust.

If you want some more mph then yes. Will it void warranty yes and no. It will depend on what the issue you have and the dealer.

As for tunes I recommend Dean's teams reflashes. You could also get...

I would assume its built in. Just from my experience with car audio. It's a option so leads me to believe the amp is built in because every ski is not coming with an amp.

I have not seen one yet...

Jerry is the site owner. Message Green Hulk. May not get much back from your core but will be cheaper then 8k.

Get a reman from sea doo. It will be well under 8k for sure. Can contact jerry and he can point you in the right direction.

Just use expoxy resin and call it a day

Use some epoxy resin and go over it.

Remove.

Running a different springs.

Wire it to a switch directly to the battery. If you do it this way the sensor will last since you can switch it on to warm up before the engine starts and when the engine stops You can keep it on for...

Bump price change

If you want the sensor to last hook it up to a switch. If you dont warm the sensor before starting the ski it shortens the life of the sensor. Also when shutting the ski off should leave the sensor...

About 20hours

I'm selling my set for 1.8L Dean's Team titanium retainers off my gp. The set has roughly 20hours.

Looking to get $240.00 shipped with pay pal fees or $230.00 gifted. Obo 469435469436469437

Breaker bar I made 468803

Make sure you tighten it as much as you can to torque spec. The closer you are the easier they come off I have found. If you dont, because its reverse thread the torque of it spinning will tighten...

Set up I made hasn't failed me yet468773

Could be low voltage from battery also.

Looking to buy 04 05 engine parts case, crank, ect. Ecu whatever you may have.