Search

Type: Posts; User: fx160

Page 1 of 8 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    65
    Views
    2,816

    So did you find a problem

    So did you find a problem
  2. Replies
    65
    Views
    2,816

    Let us know what he finds please

    Let us know what he finds please
  3. Great outcome But are you any wiser as to what...

    Great outcome
    But are you any wiser as to what the cause was ?
  4. Replies
    65
    Views
    2,816

    A valve being stuck shut would stop the motor...

    A valve being stuck shut would stop the motor turning
    The piston would have been sticking in the bore pulling the pin out leaving it to high and giving the valve something to hit
    The other...
  5. Replies
    65
    Views
    2,816

    For the rings to be melted to the piston it had...

    For the rings to be melted to the piston it had to be running lean
    If it hit the valve that could cause a keeper to come loose
    Giving the dealer something to blame
    But probably a result of...
  6. Replies
    8
    Views
    440

    View Post

    I think they have a problem with ecuís going bad
  7. Replies
    27
    Views
    1,326

    And I think that bung screws on So being alloy...

    And I think that bung screws on
    So being alloy it will have pulled the thread
    Might be easy to just buy a new bung and screw it on
  8. Replies
    27
    Views
    1,326

    You need a bearing clamp I can take a pic of...

    You need a bearing clamp
    I can take a pic of one tonight after work
    About 12 hours
  9. Replies
    27
    Views
    1,326

    It looks like it is just a bung So should be...

    It looks like it is just a bung
    So should be able to put it back in with sealer
  10. Replies
    27
    Views
    1,326

    I have replaced the bearings on one without...

    I have replaced the bearings on one without removing the coupling
  11. Replies
    18
    Views
    709

    View Post

    Iím guessing it has a recovery tank that youíre checking the level from
    And it can drain back into the sump from there when it is not being run
  12. Replies
    19
    Views
    5,441

    456198

    456198
  13. Replies
    19
    Views
    5,441

    456197 Yes I still have the ski

    456197
    Yes I still have the ski
  14. Replies
    7
    Views
    432

    I think worx still sell the adapter you are...

    I think worx still sell the adapter you are talking about
    But it has been a couple of years since I have bought one
  15. If the drain valve was open on the water...

    If the drain valve was open on the water separator, fuel vapour could exit there
    But as said it would still require an ignition source
  16. I have done it this way a couple of times When...

    I have done it this way a couple of times
    When going from single trailer to double
    It works well
  17. View Post

    They are all built in the US
    Unless itís a superjet they are built in Japan
  18. Replies
    2
    Views
    106

    Sounds like there must be an issue with air...

    Sounds like there must be an issue with air getting through the intercooler
    If you have replaced the intercooler with a new
    You need to check the hoses are also clear
    And the air box
  19. Thread: Pounds of boost

    by fx160
    Replies
    23
    Views
    1,540

    View Post

    Iím pretty sure the gearing although different
    Spins the charger the same amount
    Also there are many wheels for the old style charger
    But your injectors will be close maxed out
    The svho has...
  20. Replies
    34
    Views
    1,917

    Did you find the problem I was thinking it...

    Did you find the problem
    I was thinking it could also be getting hot and going into limp mode
  21. Replies
    23
    Views
    1,340

    On the water Maybe get a friend to listen from...

    On the water
    Maybe get a friend to listen from shore
    Itís quite obvious when you are not on the ski
  22. Replies
    55
    Views
    4,325

    View Post

    Thatís awesome that youíve hit 90 and itís not setup for top speed
    Also shows how attention to detail gives great gains over just bolting stuff on
  23. Replies
    4
    Views
    194

    L would be the month The other numbers are just...

    L would be the month
    The other numbers are just the build number
  24. Assistance pls. Looking to purchase 05 FX seller cant get ski above 30mph

    By the looks of it
    It is the 1,000cc 140 hp motor
    Not the 1,100 cc 160 motor
  25. Replies
    4
    Views
    194

    Last 3 digits of hull no. 405 4 means built in...

    Last 3 digits of hull no. 405
    4 means built in 04
    05 means 05 Model year
    Not sure about engine
    But Yamaha mustnít have liked it to put anus on the end
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4