Search

Type: Posts; User: Gus13letter

Search: Search took 0.02 seconds.

  1. Replies
    53
    Views
    20,272

    Sticky: I did not reinforce the tunnel. In my FZ skis I...

    I did not reinforce the tunnel.
    In my FZ skis I did reinforce the tunnel. I still did not seal the grate in. Something like Right Stuff gasket maker works awesome if you decide to seal it. I know...
  2. Replies
    53
    Views
    20,272

    Sticky: About the water in the hull. Jim , Jim's...

    About the water in the hull. Jim , Jim's Performance started a thread informing everyone to check where the intake grate mounts. He found some skis had a crack around the mounting bolts. Mine was...
  3. Replies
    53
    Views
    20,272

    Sticky: Some folks I know have sealed the grate in the...

    Some folks I know have sealed the grate in the tunnel area. I have not sealed my grate because I am still undecided what to do for a permanent grate yet.
  4. Replies
    53
    Views
    20,272

    Sticky: :lmao: I remember you doing that. I tried that...

    :lmao: I remember you doing that. I tried that meathod and it didnt work.
    Then I used a torch to heat the inside of the transom plate nice and evenly, got it hot enough to allow a screw driver to...
  5. Replies
    53
    Views
    20,272

    Sticky: Good tip about filling the voids. I forgot to...

    Good tip about filling the voids. I forgot to mention that. I use fiberglass resin for that too.
  6. Replies
    53
    Views
    20,272

    Sticky: Sorry I am late to the party, but I found that...

    Sorry I am late to the party, but I found that when I installed a WORX grate on a friend's ski, I also saw daylight between the intake grate and transom plate. The WORX fitment sucks and cavitated so...
Results 1 to 6 of 6