Search

Type: Posts; User: chris96338

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    552

    gas is new plugs are new wires are not new. I...

    gas is new plugs are new wires are not new. I think im losing spark because if I pull out a plug to see if it's firing it's not. but if I reset the ECU the spark comes back. it appears I am losing...
  2. Replies
    3
    Views
    552

    2005 gp 1300 wont stay running

    I have a 2005 GP 1300 that will start run for 15 seconds or so and then shut off it wont restart unless i wait for the bilge pump to stop running and remove the kill lanyard. then i replace the kill...
  3. Replies
    0
    Views
    258

    2005 PG800R misfireing or fuel problem

    Took my 2005 Gp800R out over the long weekend and it ran great until Sunday. It started to run rough (like only on one cylinder) when the throttle was transitioned from idle to full then it would all...
  4. Replies
    3
    Views
    1,276

    i see the 2 o-rings thats what keeps the water...

    i see the 2 o-rings thats what keeps the water out? what is the felt packing for?
  5. Replies
    3
    Views
    1,276

    2005 GP1300R taking on water

    I have a 2005 GP1300R that is taking on water at the shaft where it comes the hull can some one tell me what is supposed to keep the water out. All i can fine is a piece of felt packing on the...
  6. Replies
    3
    Views
    684

    all fixed it was a bad connector thanks guys

    all fixed it was a bad connector thanks guys
  7. 2005 gp1300 taking on water and broke all 4 motor mounts.

    Hi guys. I was out yesterday and it was a little rough lol. look like i ripped all four motor mounts and the engine shifted forward about 2 inches. I started taking on water i know i need 4 mounts...
  8. Update the entire motor has shifted forward about...

    Update the entire motor has shifted forward about 2 inches any suggestions.
  9. Also cylinder filled up with water also while...

    Also cylinder filled up with water also while sitting on anchor
  10. 2005 gp1300 water leaking at drive shaft

    Ok guys I need your help one more time. I have water leaking into my engine compartment around my drive shaft. I can feel it leaking how do I fix this please help thanks

    Chris
  11. Replies
    3
    Views
    684

    2005 gp800r powerbalves

    My power valves do not cycle when the ski is turned off. I also cannot get to full power in the water. I'm assuming that this is because the power valves are not cycling but I'm not sure. Could use...
  12. Replies
    1
    Views
    625

    2005 GP 800r bogging down

    My 2008 GP 800r will go full throttle then after a few seconds boggs down if i feather the throttle it will respond back to full speed but only for a few seconds. any thoughts on what the problem...
  13. Replies
    5
    Views
    601

    not the carbs just had them rebuilt. last time i...

    not the carbs just had them rebuilt. last time i had this issue WFO had me disconnect the temp sensor and it restored full throttle a Yamaha ski mechanic told me that the oil level sensor would put...
  14. Replies
    0
    Views
    593

    meter assebbly

    F0W-6820A-00-00 and F1G-6820A-10-00 both my skis meter assembly don't work is there a place i could send them for repair or do i have to bite the bullet and buy new ones?

    2005 GP800r
    2005...
  15. Replies
    5
    Views
    601

    2005 GP 800r limp mode

    I have a 2005 800r that will not go full throttle. It idles fine i bypassed the temp sensor. is there any other sensor that would put the ski into limp mode? tia
Results 1 to 15 of 15