Search

Type: Posts; User: ProZadoX

Page 1 of 8 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    17
    Views
    1,815

    125 hours on mine and no issues. Under normal...

    125 hours on mine and no issues. Under normal use... define normal ... and proper owners’s care and maintenance, you should not have any issues.
  2. Replies
    11
    Views
    882

    This is a tough call. Both are going to be great....

    This is a tough call. Both are going to be great. Of course the GTX is bigger, therefore more space on deck and better ride, but ultimately, you won’t notice that much of a difference between them.
  3. Replies
    6
    Views
    411

    Same deal. Have the GTX LTD, but 2018.

    Same deal. Have the GTX LTD, but 2018.
  4. How about the acrylic finish on the outside in...

    How about the acrylic finish on the outside in that area, is it cracked?
  5. Thread: 19 gtx 155

    by ProZadoX
    Replies
    1
    Views
    167

    Did you check your intake grate for any foreign...

    Did you check your intake grate for any foreign object that may obstruct the flow of water, and wear ring and/or impeller for damages? That would slow you down for sure. Disconnecting the battery...
  6. Replies
    37
    Views
    2,794

    120 hrs on my 2018 GTX LTD and no issues. All...

    120 hrs on my 2018 GTX LTD and no issues. All clamps were tight, never any water in the hull and only have a very slim carbon seal line which is normal. I do have a 2 square inches area with some...
  7. The guide provides the color codes.

    The guide provides the color codes.
  8. Sea-Doo Structural and Cosmetic Repair Guide for CM-Tech

    The introduction video: https://youtu.be/xfub2lbgkpA


    The guide: http://www.operatorsguides.brp.com/OperatorsGuidesAttachments/OwnersManuals_SSA/attach/01/2020/220024EN.pdf
  9. Replies
    8
    Views
    478

    That residue is not normal. I have a 2018 and...

    That residue is not normal. I have a 2018 and just a small thin line - which is normal.
  10. Replies
    10
    Views
    629

    Loose intake grate maybe??

    Loose intake grate maybe??
  11. Replies
    8
    Views
    478

    The black residue is more likely coming from the...

    The black residue is more likely coming from the carbon seal (ring around the shaft that is actually covered by the rubber boot). Your friend should go to the dealer to have this problem fixed ASAP...
  12. Replies
    31
    Views
    917

    A prior event must have weakened the bracket,...

    A prior event must have weakened the bracket, perhaps during assembly, dealer prep., or loading/unloading the ski, etc.?
  13. Replies
    4
    Views
    415

    It says maintenance in 7h (hours). The light will...

    It says maintenance in 7h (hours). The light will come on when at 50 hours or so.
  14. Replies
    6
    Views
    439

    I ride with a few friends who have 155, 230...

    I ride with a few friends who have 155, 230 (mine), 260 and 300s. We mostly do touring. Fuel consumption is very close for ALL models. It is only when you start pushing it (hard accelerations, WOT...
  15. Completely normal. You’re all good. If you start...

    Completely normal. You’re all good. If you start to see black dust spread all over the bottom of the hull, then you have issue.
  16. Replies
    9
    Views
    420

    No need to remove the top for regular maintenance...

    No need to remove the top for regular maintenance (e.g. oil change). Because it is not a supercharged engine, you won’t be faced with the same maintenance requirements which require to remove the...
  17. Replies
    17
    Views
    844

    Go for it... I’d give anything to see your face...

    Go for it... I’d give anything to see your face once you have ridden it! Seriously, the GTR-X 230 (or any GTI hull) has a very playful hull. Fun to toss around.
  18. Replies
    8
    Views
    349

    I find that overall mechanical reliability has...

    I find that overall mechanical reliability has improved when assembled properly, but the quality of the materials (CM-Tech, plastics, etc.) has gone down.
  19. Replies
    8
    Views
    349

    Same here, bubbles.

    Same here, bubbles.
  20. Thread: ST3 vs T3?

    by ProZadoX
    Replies
    14
    Views
    1,123

    I owed a rxp-x 260 (t3 hull) and now own a gtx...

    I owed a rxp-x 260 (t3 hull) and now own a gtx ltd 230 (st3 hull). The t3 hull sucks 2up at lower (cruising) speeds. No space onboard either. The st3 hull is very stable. The st3 platform does not do...
  21. What a clown.......

    What a clown.......
  22. If you look at the video Sea-Doo Tour the World...

    If you look at the video Sea-Doo Tour the World in this thread (women doing yoga on a GTX LTD) you will see them.
  23. View Post

    There is a clear cover on the handlebar of the GTX LTD that seem to protect the hands...
  24. Its obvious there is an issue with the CM Tech......

    Its obvious there is an issue with the CM Tech... we rarely heard of hull cracking issues before regardless of use.
  25. Hummm.... the RXP-X continues to use fiberglass...

    Hummm.... the RXP-X continues to use fiberglass and gelcoat hulls.... this machine was developped for racing in mind, right? BRP decided to use “traditional” materials for it.........
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4