Search

Type: Posts; User: Erierunner

Page 1 of 8 1 2 3 4

Search: Search took 1.42 seconds.

  1. Where the coil pack seats on the cam cover can...

    Where the coil pack seats on the cam cover can leak moisture/water sometimes. I use a Napa product called Sil Glyde. It's a silicone base grease that doesn't damage rubber. Stays like grease texture...
  2. As mentioned, you want the Deka ETX16L to match...

    As mentioned, you want the Deka ETX16L to match post position. I use then now and on my 4th year with 2 batteries. Load tests good. The battery is just a little shorter and you need to use the...
  3. I have used the normal Yuasa original dealer...

    I have used the normal Yuasa original dealer installed battery for 3 years on my first ski. Fluid was between the two fill lines. It was fine until it finally went bad and never had your problem. As...
  4. Replies
    4
    Views
    328

    On a 2013 VXR with the 1.8HO, I did the ribbon...

    On a 2013 VXR with the 1.8HO, I did the ribbon delete and TJ's exhaust mod. The ribbon delete gave better throttle response and a little better holeshot. So the Riva Power Filter was next. A waste of...
  5. It's been a few years since we shared some info...

    It's been a few years since we shared some info and I had the same ski as you in yellow. I loved how fast it was for an NA ski. My wife road a 2012 VX. We ride Lake Erie and it's very seldom smooth....
  6. I used Permatex Ultra Black. Plenty strong and...

    I used Permatex Ultra Black. Plenty strong and you can disassemble later if needed. 3M 4200 or 5200 would be a pita to disassemble later. Ride plate just needs circles of sealant around each bolt...
  7. Replies
    10
    Views
    431

    I had a 2012 VX Deluxe. Pretty much the same ski...

    I had a 2012 VX Deluxe. Pretty much the same ski but yours is better with the newer hull design. Something is definitely wrong and it shouldn't be doing anything as you mentioned. Sure does sound...
  8. Replies
    7
    Views
    394

    The 2020 VX Cruiser HO is $11,800 msrp. So they...

    The 2020 VX Cruiser HO is $11,800 msrp. So they are selling you a 2019 for $1,150 less which is OK but nothing special and it was $11,500 msrp. So your getting only $850 off. The trailer is high. You...
  9. My wife rides a 2018 FXHO. I've put about 5 hours...

    My wife rides a 2018 FXHO. I've put about 5 hours on it and have become used to it's overall ride/handling. I bought a 2019 FXHO last year and have 53 hours on it. The 19 is slightly wetter when it's...
  10. If your going to flip the ski over, yes, the gas...

    If your going to flip the ski over, yes, the gas and oil needs to come out.

    You should be able to do the repair without flipping it over. Do a search and you'll find numerous posts that members...
  11. Replies
    10
    Views
    671

    You can't really go by, I'll give it "X" number...

    You can't really go by, I'll give it "X" number of pumps a year or this many grams with it being brand new. My waverunners take a different amount each year and none are the same. As K447 advised,...
  12. Replies
    14
    Views
    1,374

    I have a 2013 VXR and run the 13/19 Solas. Same...

    I have a 2013 VXR and run the 13/19 Solas. Same engine but a slightly different hull. The only other mods are a cold air intake, ribbon delete, and Tommy Jordan's exhaust mod. The 13/19 keeps me just...
  13. If you do get the Deka, ETX16L, they come up to...

    If you do get the Deka, ETX16L, they come up to full charge faster than the Yuasa lead acid batteries. I have two Dekas in two FXHOs. Over Winter, the Dekas are in my house and I charge them once a...
  14. On my 2019 FXHO, I'm still able to give the start...

    On my 2019 FXHO, I'm still able to give the start button a very fast tap and you'll hear the fuel pump run and the screen will boot without starting. To make the starter spin from totally off, the...
  15. Replies
    7
    Views
    470

    On my 2013 VXR, I usually run 50-60 hours a...

    On my 2013 VXR, I usually run 50-60 hours a season. When Winterizing, the plugs still look like new with maybe just a very light beige tint on the porcelain electrode. I put in new after burning off...
  16. NGK CR9EB is the correct spark plug and NGK work...

    NGK CR9EB is the correct spark plug and NGK work well. I change mine every Spring/before ride season. I leave the old ones in to burn off the fogging oil with a two minute or less run on the hose....
  17. I just use the Yamaha oil filters but other...

    I just use the Yamaha oil filters but other members use Motorcraft, Napa, Mobile 1, etc. Also, I just use the Yamaha 4W oil but again others use other brands in the 10W-40 weight. The kit you posted...
  18. Replies
    16
    Views
    1,438

    My Yamaha Manual has a 2013 VXR, 1.8na engine,...

    My Yamaha Manual has a 2013 VXR, 1.8na engine, pressure at 49-52psi. So as mentioned, way low. Most fuel injection systems need that 40-50psi range.
  19. Replies
    9
    Views
    675

    When it's on the trailer, raise the front of the...

    When it's on the trailer, raise the front of the trailer up a good 25'. You won't need to much water put in the hull to see the possible leak and raising the front keeps the water off the engine.
  20. 2019 FXHO. It arrived at my dealer in...

    2019 FXHO. It arrived at my dealer in Pennsylvania first part of April 2019 and picked up May 1st. Mine starts, engine is running, within under two seconds when the start button is pressed. I have no...
  21. I realize that adding washers to the rear of the...

    I realize that adding washers to the rear of the plate is about the only way to shim because you can't add to the front and have it not match the grate. Cut ride plates seem to have the rear of the...
  22. Replies
    16
    Views
    1,188

    I bought a 2018 FXHO for my wife last year. I'm...

    I bought a 2018 FXHO for my wife last year. I'm glad she likes it because I liked the handling of my 2013 VXR better which isn't even as good 2015+ VXRs. When it was said the 2019 FXs turned and...
  23. If you give the start button a very quick tap,...

    If you give the start button a very quick tap, the screen will wake up but the engine won't crank. This is nice if you want to check info or just use the screen functions. Otherwise to start, press...
  24. .014-.018 inch is normal clearance. .024 inch is...

    .014-.018 inch is normal clearance. .024 inch is max. Impeller has a few nicks and the pump liner looks like it's a little sanded. I bet your clearance is the main problem.
  25. I have a 2018 and 2019 FXHO. The 2018 "cranks"...

    I have a 2018 and 2019 FXHO. The 2018 "cranks" instantly when the starter button is pressed. The 2019 may take only a second to "crank" after the start button is pressed. It has to do with it's link...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4