Search

Search: Search took 1.00 seconds.

  1. Glad you found the source of the leak. If you...

    Glad you found the source of the leak. If you would of cut open the fiberglass region near the drive shaft holder, you might have been able to get a better line of sight (and easier working space)...
  2. You're always gonna get a little water in the...

    You're always gonna get a little water in the engine bay due to the waves and splashing so don't go too crazy trying to achieve bone dry status lol. I like to get wet when I ride and after each ride...
  3. I'm not sure how much help the glassing would do....

    I'm not sure how much help the glassing would do. its tight to work down there to begin with and if you spread the 5200 out right, it will create a glass like bond (i think?). FWIW, I used these...
  4. Replies
    9
    Views
    1,202

    When i had this issue last summer, I went flying...

    When i had this issue last summer, I went flying across the garage when the shaft snapped and all the torque on my 6ft sent me sailing. I was dumb and didnt use heat, but even with heat, I don't...
  5. My ski's are kept in Levittown, but I live in...

    My ski's are kept in Levittown, but I live in Philly. I do a lot of my troubleshooting at the Yardley boat ramp on River Road, but its can be really shallow and theres not much room to go explore....
  6. Whatever ski you end up keeping on the water, you...

    Whatever ski you end up keeping on the water, you should think about throwing a bilge pump in. No sense not spending the ~$100 on the pump versus sinking the ski.
Results 1 to 6 of 6