Search

Type: Posts; User: JFizzleJR

Page 1 of 8 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    9
    Views
    467

    Yes adding a cam still gets good gains on a stock...

    Yes adding a cam still gets good gains on a stock supercharger. 2+ MPH and improved acceleration for most of the cams on the market.
  2. Replies
    2
    Views
    160

    The Fizzle F1000 with pipes or Fizzle Gen X to go...

    The Fizzle F1000 with pipes or Fizzle Gen X to go with your stock hoses both fit your ski. They're both sold out right now. The Gen X will be ready first and it's my recommendation for your ski....
  3. Replies
    4
    Views
    245

    Yes the Fizzle F1000 and Fizzle Gen. X do use the...

    Yes the Fizzle F1000 and Fizzle Gen. X do use the same core. The difference is the air tanks. F1000 works with Fizzle aluminum pipes and Gen X uses with factory hoses.
  4. Replies
    14
    Views
    787

    I searched my email for anything from your aol...

    I searched my email for anything from your aol account in the last 12 months and nothing comes up. Sorry, not sure what's going on with that...Your order shipped yesterday. Thank you
  5. Replies
    14
    Views
    787

    Let me know where you sent the message. I haven't...

    Let me know where you sent the message. I haven't been able to find it.
  6. Replies
    21
    Views
    2,206

    Definitely on the rev limiter. You don't want to...

    Definitely on the rev limiter. You don't want to be anywhere near the limiter.
    Pitch for 8650 max on a 8800 RPM tune.
  7. Replies
    11
    Views
    816

    Lol good luck with that... I have had a couple...

    Lol good luck with that... I have had a couple reports of 400 RPM gains. Chances are the ski was taxing the stock cooler in a major way or it simply wasn't a back to back test. You can expect 250-300...
  8. Replies
    11
    Views
    816

    With the Fizzle Intercoolers on the 260 we have...

    With the Fizzle Intercoolers on the 260 we have seen 60-120 RPM increases and on the 300 we have seen 40-60 RPM increases.
  9. Replies
    26
    Views
    2,635

    The Pro Series Cooling Kit is compatible with...

    The Pro Series Cooling Kit is compatible with Fizzle Intercoolers as well. I typically run a dedicated line to the intercooler, dump the intercooler through the 2 pissers on the right side of the...
  10. Replies
    26
    Views
    2,635

    Thanks for the kind words guys. I try to do...

    Thanks for the kind words guys. I try to do what's in my power to make everyone happy!

    There's a lot of great points in this thread. 2 quick things I want to mention are the Fizzle Intercoolers...
  11. Replies
    26
    Views
    2,635

    I think you will be surprised how the Fizzle...

    I think you will be surprised how the Fizzle Y1000 can outperform bigger cores :) We found this out for the first time during testing in 2012-2013. First on Sea-Doo, then on Yamaha.
  12. I think it's important to point out here that...

    I think it's important to point out here that there's a difference between back pressure and spinning backwards. It's like hitting the brakes as opposed to shifting into reverse.
  13. The blow off valve is venting pressure that the...

    The blow off valve is venting pressure that the engine is not accepting at low RPM, with the throttle plate almost closed.
  14. Replies
    19
    Views
    1,429

    That's a Worx clone. They can't even advertise...

    That's a Worx clone. They can't even advertise the knock off correctly and some people trust putting this stuff on their engine :facepalm: I bet they don't even know what a jetski is.
  15. Replies
    19
    Views
    1,429

    By the time you're done sourcing all the hoses...

    By the time you're done sourcing all the hoses and hardware, developing and fabricating a mount, you could just buy the Fizzle 500 to stay on a tighter budget. Then you'll have a warranty and...
  16. Thread: Fizzle BOV

    by JFizzleJR
    Replies
    4
    Views
    407

    The fitting is 1/8" NPT and requires a tap and...

    The fitting is 1/8" NPT and requires a tap and 21/64" drill bit. My recommended way is this way. On the other hand, many people are using the map sensor tee without any issues.
  17. Replies
    9
    Views
    611

    Yes it's an o-ring. A newer, thinner o-ring can...

    Yes it's an o-ring. A newer, thinner o-ring can be used. Or you can remove it altogether. I recommend checking the pressure on the incoming line with a pressure gauge just to make sure it's not...
  18. Replies
    9
    Views
    611

    I would enlarge the restrictor in the pump shoe...

    I would enlarge the restrictor in the pump shoe to match any increase you make in the intercooler feed. That way the exhaust feed won't be sacrificed to feed the intercooler.
  19. Replies
    9
    Views
    611

    You'll have a way adjust the volume in dump line...

    You'll have a way adjust the volume in dump line since you're adding a ball valve, so you'll be good to go. The SuperCooler does even better with a bigger water supply, so feel free to give it more...
  20. Well, in reality the bigger supercharger produces...

    Well, in reality the bigger supercharger produces both (more vacuum pressure and more boost pressure) at opposite extremes of the RPM range than the smaller wheels. The blow off valve spring...
  21. Thank you CJK for the kind words. Our...

    Thank you CJK for the kind words.

    Our recommendation is the 8 psi spring on stock superchargers or superchargers equipped with a 17 lb wheel. Typically superchargers with a 19 lb wheel or higher...
  22. Replies
    70
    Views
    5,780

    Bring it on down to Florida and we'll get it...

    Bring it on down to Florida and we'll get it flying for you!
  23. Replies
    46
    Views
    9,012

    The Solas impeller and a tune will get you the...

    The Solas impeller and a tune will get you the biggest acceleration gains. Next in line would be an air intake and intercooler. Raising the rev limit on these skis really helps them shine!
  24. Replies
    9
    Views
    432

    SOLD Yes, plus it says you would need to show that you...

    Yes, plus it says you would need to show that you have one of their hoses that's been damaged in order to be eligible for a replacement from them...
  25. Replies
    9
    Views
    432

    SOLD The Fizzle hose fits the HKS blow off valve. Just...

    The Fizzle hose fits the HKS blow off valve. Just request the HKS flange for it. I'll include it for you, no extra cost.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4