Search

Type: Posts; User: jpt7779

Page 1 of 8 1 2 3 4

Search: Search took 0.03 seconds.

  1. Great!

    Great!
  2. Replies
    3
    Views
    157

    Good advice from splash. The most important...

    Good advice from splash.

    The most important tools to have is your Owners Manual and a Shop Manual. So many mistakes by others here could be avoided by simply reading and following step by step...
  3. Replies
    13
    Views
    292

    Bill, get an Owners Manual and a Shop Manual,...

    Bill, get an Owners Manual and a Shop Manual, www.brpmanuals.com.

    The MAINT display is only a service reminder, typically every 100 hours. It will blink every startup for 10 seconds. You can reset...
  4. A Shop Manual and following step by step...

    A Shop Manual and following step by step instructions with proper tools were needed prior to this incident and definitely needed now!

    www.brpmanuals.com
  5. I am JT, Bob is my brother in law...

    I am JT, Bob is my brother in law 1tommygunner1927.

    Get the Shop Manual as it has all your questions answered!

    Now get to riding.
  6. Read this old thread from the How To section: ...

    Read this old thread from the How To section:

    http://greenhulk.net/forums/showthread.php?t=167159
  7. Replies
    19
    Views
    3,233

    http://greenhulk.net/forums/showthread.php?t=26162...

    http://greenhulk.net/forums/showthread.php?t=261624

    see post 18 for picture.

    Cut off the tabs, drill a hole, slide in a bolt with washers and nuts. Too easy.

    Post 19 shows another option by...
  8. Looking at the electrical diagram in my Shop...

    Looking at the electrical diagram in my Shop Manual, www.brpmanuals.com clearly shows the 30A Relay feeds the other fuse box.

    Take the 30A relay to any auto parts store and replace it. I keep a...
  9. Replies
    2
    Views
    90

    Get a Shop Manual at www.brpmanuals.com

    Get a Shop Manual at www.brpmanuals.com
  10. Replies
    10
    Views
    301

    Several of us here are using the M130 or M150...

    Several of us here are using the M130 or M150 ECU.

    As Dino said, a lot more info is needed to get you close. GRF kit, Garrett or Borg or other, type of waste gate internal-external, 1000 cc...
  11. Replies
    8
    Views
    355

    Martin, iBr is VERY sensitive to battery voltage,...

    Martin, iBr is VERY sensitive to battery voltage, too high and too low.

    I was chasing my ass about this subject and found the stator was bad and ultimately fried the wires.
  12. Replies
    16
    Views
    2,616

    OEM Parts link near the top of this page!

    OEM Parts link near the top of this page!
  13. Replies
    1
    Views
    86

    http://partsfinder.onlinemicrofiche.com/4tec/showm...

    http://partsfinder.onlinemicrofiche.com/4tec/showmodel.asp?type=13&make=seadoopwc&a=235

    Engine page
    part 31

    OEM Parts link above, order and replace the knock sensor!
  14. You will find the answer to this and everything...

    You will find the answer to this and everything else in a Shop Manual: www.brpmanuals.com
  15. Replies
    14
    Views
    1,028

    Very impressive! Glade Rider hit the same...

    Very impressive!

    Glade Rider hit the same 94.6 mph speed a few years ago on a 2010 RXT-X GRF Turbo (S3 hull) with lots of boost and 30% C-10 race gas.

    You did it much cheaper, well done!
  16. Always look at the OEM Tab above for parts.

    Always look at the OEM Tab above for parts.
  17. Replies
    18
    Views
    403

    Sum Ting Wong!

    Sum Ting Wong!
  18. Replies
    82
    Views
    3,951

    View Post

    BS! My wife’s 05 GTX dash indication is off by 4 mph consistently. My 10 TX Turbo dash rounds up 1.4-2.5 depending on speed, the faster you go the worse it gets. I have plenty of Motec data logs to...
  19. Thread: Water in oil?

    by jpt7779
    Replies
    7
    Views
    200

    The oil cooler is bolted to the block, right side...

    The oil cooler is bolted to the block, right side and oil flows through it, water/coolant also flows through passages to help control temp. Only way to check it, is to remove it. If either section of...
  20. There is no neutral gear on a PWC. The reverse...

    There is no neutral gear on a PWC. The reverse gate simply drops down deflecting the thrust of the water forward/down, just like a thrust reverser on an airliner. No you can not turn the driveshaft...
  21. Replies
    18
    Views
    418

    I have used these: ...

    I have used these:

    https://www.homedepot.com/p/Master-Lock-8155D-6-ft-Keyed-Braided-Steel-Cable-5-8-in-Dia-8155DCC/202311744

    you can run these through wheels, front and rear tow hooks, etc.
  22. Thread: Water in oil?

    by jpt7779
    Replies
    7
    Views
    200

    Yes that looks like water in oil. I suggest you...

    Yes that looks like water in oil. I suggest you check your oil cooler, especially since your using open loop cooling. Why did you have the engine out and what specifically did you have to do?
  23. Thread: Rxpx 300 died

    by jpt7779
    Replies
    11
    Views
    565

    Yup, been there done that. Stator wires destroyed...

    Yup, been there done that. Stator wires destroyed due to flywheel bolt failure. It is a real expensive mess.

    My fix: http://greenhulk.net/forums/showthread.php?t=227324
  24. Replies
    18
    Views
    403

    High Volume Fuel Pump Blown Fuse

    My ski is a 2010 RXT-X which is highly modified. I followed the Riva instructions and it just works.

    The kit Scott posted should work also. Grounds are critical and most likely your issue. Ensure...
  25. Replies
    18
    Views
    403

    well that was helpful!

    well that was helpful!
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4