Search

Type: Posts; User: Jarek

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    19
    Views
    1,388

    Great adventure. Thx for sharing :))

    Great adventure. Thx for sharing :))
  2. Replies
    5
    Views
    1,218

    I bet salty build up supercharger. Remove yours...

    I bet salty build up supercharger. Remove yours and itll start right away. Just close a hole after sc by hand.
    Cheers
  3. Replies
    7
    Views
    419

    Great news. Another one sorted. I just found...

    Great news. Another one sorted.
    I just found similar thing in my ibr plug. 1m long just replaced. And main power cable for it too.
    J
    469174
  4. Replies
    6
    Views
    462

    Is the power comming to the pump plug? Its...

    Is the power comming to the pump plug? Its straight forward.
    Do you have buds or any other diag? You can activate fuel pump as far as I remember.

    Small hint. If youll be using a needle pin to...
  5. Replies
    6
    Views
    462

    Best would be to get a fuel pressure gauge. It...

    Best would be to get a fuel pressure gauge.
    It should be around 3 bars anyway. And check it if after while when pump warm up its not cutting. If its quiet hit a tank with hammer like its commonly...
  6. Replies
    7
    Views
    419

    Get the service manual and follow all electrics....

    Get the service manual and follow all electrics. I had a similar problem in my old 05 rxt. Power line between mpem and dash gives trouble. It was coroded inside, under insulation 30 cm from plug. It...
  7. Thread: Rxp-x300rs xxx

    by Jarek
    Replies
    20
    Views
    1,850

    May i ask what was the symptoms of upper bearing...

    May i ask what was the symptoms of upper bearing failure? Knocking in engine? Oil pressure light?
    Cheers
  8. I would also check slip moment on sc. When sc...

    I would also check slip moment on sc. When sc fails (basically no boost) engine revs up to 6700-6800 max. And You can feel loose of power. It might be on partial boost. So as it was said check boost...
  9. Thread: Rxp-x300rs xxx

    by Jarek
    Replies
    20
    Views
    1,850

    Thx for this hint. I know there will be lot of...

    Thx for this hint.
    I know there will be lot of test.
  10. Thread: Rxp-x300rs xxx

    by Jarek
    Replies
    20
    Views
    1,850

    Strange with this impeller. But I got it with 25h...

    Strange with this impeller. But I got it with 25h so its possible it was replaced. But hard to imagine.
    About fuel -european 95 octanes. Ireland doesnt sell any other.
  11. Thread: Rxp-x300rs xxx

    by Jarek
    Replies
    20
    Views
    1,850

    My one is rxpx300 2017. And stock is smaller. Sxx...

    My one is rxpx300 2017. And stock is smaller. Sxx cd 13/18 is 161mm and it wouldnt fit stock wear ring.
  12. Thread: Rxp-x300rs xxx

    by Jarek
    Replies
    20
    Views
    1,850

    Its not about keeping stock impeller. Problem was...

    Its not about keeping stock impeller. Problem was stock is 159mm and sxx 13/18 is 161mm. I already removed stock ring and waiting for 161 one to fit it with sxx
  13. Replies
    14
    Views
    703

    ic cleaning

    I have used a bit of brake cleaner into the IC and then pour boiling water into it. Brake cleaner starts boiling in around 45 degrees and works as active depressant. Done that couple of times and 2...
  14. Thread: Rxp-x300rs xxx

    by Jarek
    Replies
    20
    Views
    1,850

    Actually Riva forced me to fit 13/18. I wanted to...

    Actually Riva forced me to fit 13/18. I wanted to keep stock. stainless - only because its locally available. Getting stuff from overseas is pain in the axx. And customs holds packages without a...
  15. Replies
    1
    Views
    326

    And one question, Does anyone know how is it...

    And one question, Does anyone know how is it mounted?
    What I mean is one place is the broken neck, its attached to hull. Second place should be probably some bracket which support whole unit, but...
  16. Replies
    1
    Views
    326

    iBR failure RX 300 pics

    Hi All.
    For anyone who need I disassembled Ibr part no 278003478.
    here are pics of it for anyone who needs.

    Ill be fixing it so once the parts will come Ill post progress.

    iBR was working...
  17. Thread: Rxp-x300rs xxx

    by Jarek
    Replies
    20
    Views
    1,850

    Rxp-x300rs xxx

    Hi all.
    Just wondering your experience about FPR on tune. I know its recomended to fit 4 bar regulator with vt1100. but anyone wo tested it without it?

    After my sc bearing in 300 failed few...
  18. FS Would u still have it?

    Would u still have it?
  19. Replies
    5
    Views
    782

    thx for advice. And You hit the point. I wouldnt...

    thx for advice.
    And You hit the point. I wouldnt advice that to anyone but I want to try things on my own taking a risk, to learn and relearn etc.

    Thats why Im getting info before Ill do too...
  20. Replies
    5
    Views
    782

    Great stuff. Start searching. Thx

    Great stuff.
    Start searching.
    Thx
  21. Replies
    5
    Views
    782

    Rxp-x 300 mod advice

    hi.
    Have a RXP-X 300 2017 48 hours on it.
    Just issued sc bearing failure.
    So have to replace whole one due to excessive damage of supercharger.
    So decided to make some upgrades.
    1. Purchuased...
  22. Replies
    33
    Views
    7,290

    Is that matters??? Warranry is comming with a...

    Is that matters???
    Warranry is comming with a ski, and its out anyway.
    Bought it with 25h. And a dealer who sold it checked it for me.
    I make and enquiry about the situation and we will see.
    J
  23. Replies
    33
    Views
    7,290

    seadoo 300 SC fail

    Same happend to me.
    2017 RXP-x300 48h.
    SC failed on the water after 1,5h cruising.
    Bearing must have seized causing shaft to become blue. Compressor in pieces.
    PWC had to be towed due to no start...
  24. Hi. About catch can - i thought so. Its for...

    Hi. About catch can - i thought so. Its for engine breather.

    Intercooler ans hoses pressure tested. No issue.

    Now weather is so great in Ireland (20 celcius) so we need to use it for barbecue....
  25. Salt catch and build up between compressor back...

    Salt catch and build up between compressor back side and hosing.
    Bearing sound ok after cleaning. No noise whatsoever, and spinning like a dream.
    Ill leave it so far but ill get kit for it for...
Results 1 to 25 of 31
Page 1 of 2 1 2