Search

Page 1 of 16 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    16
    Views
    910

    After owning a 2018 FX SVHO Cruiser and riding...

    After owning a 2018 FX SVHO Cruiser and riding several 2019 FX SVHO (Both similar mods), my choice would be the 2018 FX SVHO. You cant just say one is better than the other. It depends on what type...
  2. Pulled the ski almost all the way off the...

    Pulled the ski almost all the way off the trailer, looked at entire bottom, and all is fine. So liquid rollers seems ok. I put my ski on trailer while wet, but just make sure it dries first to be...
  3. Replies
    21
    Views
    1,048

    Hello again fellow SeaDoo family

    I am sure this will be a shock to many, but although I loved the Yamaha world, I have decided to step back into the SeaDoo family with a 2019 GTX 300 Limited. So far I am very pleased with the...
  4. Sticky: Absolutely. I had this setup on my 2018 FX SVHO....

    Absolutely. I had this setup on my 2018 FX SVHO. Dean's stage 1 tune with an 8750 limiter and ran ski 8500- 8600RPM, with air intake, ribbon delete, Solas 13/20, rideplate mod, 2 degree wedge, free...
  5. Replies
    8
    Views
    1,286

    Hello, I posted here...

    Hello, I posted here http://greenhulk.net/forums/showthread.php?t=278213&page=2&p=3010754&viewfull=1#post3010754 about the same thing. I ran the Lucky 13 cone with the 5 degree nozzle and 2 degree...
  6. Replies
    25
    Views
    1,347

    Oh, ok. I liked it and was happy with it.

    Oh, ok. I liked it and was happy with it.
  7. Replies
    20
    Views
    2,301

    Sounds like you made the job difficult and not...

    Sounds like you made the job difficult and not using the collar seems like it would cause potential stress on the individual bolts. Your issue is probably because you used gasket AND Right Stuff. I...
  8. . 446160

    . 446160
  9. Replies
    95
    Views
    7,708

    Cool. Nicely done. Maybe, but keeping my FX...

    Cool. Nicely done. Maybe, but keeping my FX around 8600 rpm as my riding ski. The GP will be the one I run higher and with more mods.
  10. Replies
    95
    Views
    7,708

    Nice work Jim. Makes sense, with similar mods, my...

    Nice work Jim. Makes sense, with similar mods, my FX ran 84.9 mph at 8740 RPM on the limiter at 3/4 throttle 3/4 tank gas with rough water P1 AquaX plate.
  11. Thanks guys. It doesn't come easy or cheap and I...

    Thanks guys. It doesn't come easy or cheap and I also learn more all the time.

    Previous time out, my stock shaft broke and took out the charger and had to get towed in by my FX. Maybe I had over...
  12. Update on my GP1800 with stock SC wheel. I...

    Update on my GP1800 with stock SC wheel. I pitched impeller and installed Riva Gen4 shaft since I planned to run over 9k holeshot and beat it up in the rough.

    Still needs little fine tuning for...
  13. Thread: Vxr Cams.

    by Gus13letter
    Replies
    7
    Views
    468

    SOLD Got you a buyer. Answer your messages. [emoji106]

    Got you a buyer. Answer your messages. [emoji106]
  14. Thanks. From my understanding, any 2014 and up NA...

    Thanks. From my understanding, any 2014 and up NA cams will work. If you have 2016 + with larger gears, you'll be to swap your gears over. If you get 2016 and up NA cams then you can install as is....
  15. Thank you. Very nice. I have that in my GP. In...

    Thank you. Very nice. I have that in my GP. In past experience NA cams only help with acceleration and saw no top speed gains. This is the first I've tried the VXR TB. From what I can tell so far...
  16. *~*~* Two is company: 2018 FX Cruiser & GP1800 *~*~*

    When you love both skis so much and you have to have both. :)

    I built both essentially as what most folks consider stage 2. The GP has a few more mods and tweak.

    FX ran a best of 84.9 mph at...
  17. I wont guarantee this, but this will not void...

    I wont guarantee this, but this will not void your warranty. It is undetectable and limiter remains as is. It is just removing the GPS limiter. By doing this with a few bolt on parts previously on my...
  18. Replies
    34
    Views
    2,716

    Good idea and better than my Gorilla Tape...

    Good idea and better than my Gorilla Tape...
  19. Replies
    47
    Views
    9,345

    Wish I would have posted my RPM in 1st post, I...

    Wish I would have posted my RPM in 1st post, I think it was about 9100 -9200 rpm.

    Lucky 13 cone helped my 2018 GP1800 too.

    I was on the 8850 limiter at half throttle due to cooler weather (78...
  20. Replies
    35
    Views
    4,959

    You need to fix the cavitation. That is what...

    You need to fix the cavitation. That is what killed your wear ring and pump. Get the Riva grate install it and make sure it is all sealed up and use the Lucky 13 cone.
    You can replace just the wear...
  21. Sticky: Yup, I saw when pouring the epoxy into the...

    Yup, I saw when pouring the epoxy into the brackets it was filling areas and seeping between the liner and hull. Had to keep filling the voids to keep it full.
  22. Sticky: Pic of brackets. Once ski is built she is getting...

    Pic of brackets. Once ski is built she is getting a good interior detail. :) Inside looking dirty.

    444180
  23. Replies
    192
    Views
    14,813

    Just trying to help out and provide the results...

    Just trying to help out and provide the results from our testing. I love doing back to back testing. I always find it interesting to see the differences.

    I'm not sure when he's going to release...
  24. Replies
    192
    Views
    14,813

    Went testing with Dean from Dean's Team all day...

    Went testing with Dean from Dean's Team all day trying various handling setups on the 2019 FX and must say, the FX is a nice all around ski. Good handling, acceleration, and holeshot The more I rode...
  25. Replies
    84
    Views
    8,089

    This was short clip of my GP1800 stock SC wheel,...

    This was short clip of my GP1800 stock SC wheel, Fizzle IC, Dean's tune, and supporting mods to run 91mph at 9300 rpm.
    The GP is an awesome platforms once you get it to stop cavitating with that...
Results 1 to 25 of 400
Page 1 of 16 1 2 3 4