Search

Page 1 of 16 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    5
    Views
    258

    8040 rpm is the limiter and has been for many...

    8040 rpm is the limiter and has been for many years. Momentary overshoots above and below are completely normal.What you are seeing is normal.

    Read this Sticky thread, it is old but still...
  2. Replies
    6
    Views
    322

    The first tool you need is a Shop Manual,...

    The first tool you need is a Shop Manual, www.brpmanuals.com.

    The 2010 RXT-X manual in pdf does NOT exist, get a 2011 RXT-X manual as they are exactly the same.

    All parts can be found right...
  3. Replies
    28
    Views
    1,492

    http://greenhulk.net/forums/attachment.php?attachm...

    http://greenhulk.net/forums/attachment.php?attachmentid=466857&stc=1

    This is my M130 setup showing the electronic boost controller behind it and the plumbing from the GRF Turbo.

    The Black Beast...
  4. Replies
    28
    Views
    1,492

    http://greenhulk.net/forums/attachment.php?attachm...

    http://greenhulk.net/forums/attachment.php?attachmentid=466853&stc=1http://greenhulk.net/forums/attachment.php?attachmentid=466852&stc=1http://greenhulk.net/forums/attachment.php?attachmentid=466851&s...
  5. Replies
    2
    Views
    194

    https://www.dynotunenitrous.com/store/scripts/prod...

    https://www.dynotunenitrous.com/store/scripts/prodView.asp?idproduct=130

    This is what we used to monitor tunnel pressure. Blue backlight works well in sun and get a PWC/ waterproofing version.
    ...
  6. Replies
    5
    Views
    359

    Well now I am caught up with your build(s), which...

    Well now I am caught up with your build(s), which are fascinating! I am convinced that anything you come up with will be well thought out and over kill performance wise.

    Well done.
  7. Replies
    10
    Views
    418

    A lake test is mandatory before $$$$ exchanged!...

    A lake test is mandatory before $$$$ exchanged!
    You should see at WOT very close to 8040 rpm max and 68-70 mph with a GPS. The dash will round up the speed 1-2 mph. The SC has probably not been...
  8. Replies
    3
    Views
    156

    That is because you are making great power and...

    That is because you are making great power and performance!

    I suggest you get a Lucky 13 cone and play with the spacers that come with it and leave the impeller alone.

    I sure hope you have...
  9. I have 05 GTX 185. The only time I have seen this...

    I have 05 GTX 185. The only time I have seen this happen is water intrusion into the back of the ski. 1 you should install a bilge bump in the rear if the ski. There is a flat spot next to the pump...
  10. https://www.amazon.com/EASYBERG-Manual-Changer-Ext...

    https://www.amazon.com/EASYBERG-Manual-Changer-Extractor-Remover/dp/B0863BD5J2/ref=asc_df_B0863BD5J2/?tag=hyprod-20&linkCode=df0&hvadid=416926807659&hvpos=&hvnetw=g&hvrand=6591347633161275138&hvpone=&...
  11. Replies
    4
    Views
    235

    Had a crash down after hitting a monster wake a...

    Had a crash down after hitting a monster wake a few years ago, fried the stator, relay, fuses, and VR. Replaced everything with aftermarket parts.......big mistake.....and nothing but electrical...
  12. Replies
    6
    Views
    945

    Towing 2018 RXT-X 300

    Right in your pics, top left of pump tunnel(right side in pic), the hose with the T fitting. Pull that hose off the transom fitting, add some hose as long as you want, place shutoff valve inline,...
  13. Replies
    1
    Views
    681

    Definitely! Requires all driveline components...

    Definitely!

    Requires all driveline components to be replaced: PTO bearing seal, carbon ring, floating ring, c-clip, drive shaft, and bellows.

    Check engine to pump alignment and all 3 engine...
  14. Replies
    20
    Views
    580

    Yes it is there! 2007 Sea-Doo PWC Series Repair...

    Yes it is there! 2007 Sea-Doo PWC Series Repair and Maintenance $9.50 to download.

    Main Menu
    Manuals
    Seadoo
    scroll up
    they are all there since 1989!!!!
  15. No you do not have to pull motor. 1. get a...

    No you do not have to pull motor.

    1. get a Shop manual at www.brpmanuals.com
    2. Remove the exhaust manifold. use 1/4” ratchet set, long extension and torx sockets, stand on the right side of ski...
  16. Replies
    35
    Views
    2,008

    Have you taken the RRFPR apart and inspected the...

    Have you taken the RRFPR apart and inspected the diagram and spring? It is not uncommon for both to deteriorate!

    If they are ok, pull the fuel pump and inspect all hoses very closely. I have seen...
  17. Replies
    106
    Views
    12,251

    A highly modified Turbo ski is capable of a lot...

    A highly modified Turbo ski is capable of a lot of boost, generating a tremendous amount of HP that smaller pitched impellers just can’t handle. Low end acceleration on this specific type of ski is...
  18. Replies
    106
    Views
    12,251

    Uh, mine is a custom 15/26 tuned by Glen at Skat...

    Uh, mine is a custom 15/26 tuned by Glen at Skat years ago. What does that tell ya?
  19. Replies
    1
    Views
    238

    Believe you are talking about the throttle lube...

    Believe you are talking about the throttle lube hose, and are not necessary.

    Get a Shop Manual here www.brpmanuals.com. Everything you need to know is in the manual.

    Pictures are worth a...
  20. See post 19,...

    See post 19, http://greenhulk.net/forums/showthread.php?t=184177

    left impeller is correct for 2006, which is SRX style hub

    right impeller is NOT correct for 2006, but is for 2009+. It can be...
  21. Replies
    8
    Views
    413

    You need to get your ski out of that stealership...

    You need to get your ski out of that stealership right now and never go back!

    I gave you everything you need to know to replace the TOPS yourself. The ECU and TOPS just don’t fail at the same...
  22. Replies
    10
    Views
    533

    If and when you get this ski back, I would trade...

    If and when you get this ski back, I would trade it in or sell it immediately, and never deal with this incompetent stealership again!
  23. Replies
    3
    Views
    309

    Good advice from splash. The most important...

    Good advice from splash.

    The most important tools to have is your Owners Manual and a Shop Manual. So many mistakes by others here could be avoided by simply reading and following step by step...
  24. Read this old thread from the How To section: ...

    Read this old thread from the How To section:

    http://greenhulk.net/forums/showthread.php?t=167159
  25. Replies
    19
    Views
    3,336

    http://greenhulk.net/forums/showthread.php?t=26162...

    http://greenhulk.net/forums/showthread.php?t=261624

    see post 18 for picture.

    Cut off the tabs, drill a hole, slide in a bolt with washers and nuts. Too easy.

    Post 19 shows another option by...
Results 1 to 25 of 400
Page 1 of 16 1 2 3 4