Search

Type: Posts; User: justforfun

Page 1 of 6 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    422

    FS - Parts http://greenhulk.net/forums/showthread.php?t=24806...

    http://greenhulk.net/forums/showthread.php?t=248062

    This setup uses stock 1300 spacer, I have the other adapter also that was bought on this site that can be bought.
  2. Replies
    1
    Views
    422

    FS - Parts Seadoo conversion pumps, adapter

    Seadoo conversion pumps, adapter drive lines and extra threaded bushings just need splines cut but never needed them.
    Pump with prop is 155 with like new prop cut down by Impro's... This setup I...
  3. Replies
    1
    Views
    338

    WTB I have it all plus some extras. IM me and we can...

    I have it all plus some extras. IM me and we can talk I'm also in Florida

    I have 2 pump adapters one complete bought from WFO here and the other just the plate. I have 2 drive lines, 2 extra...
  4. Replies
    3
    Views
    686

    WTB I sent a im I have the complete setup

    I sent a im I have the complete setup
  5. Replies
    6
    Views
    1,173

    http://www.greenhulk.net/forums/attachment.php?att...

    http://www.greenhulk.net/forums/attachment.php?attachmentid=415881&stc=1The top small one is oil temp with water below it they can be mounted anywhere and work great. I have the sender in the front...
  6. Replies
    9
    Views
    752

    Make sure the valve seat isn't stuck in the...

    Make sure the valve seat isn't stuck in the cover. Number 10 and 11
    http://fiche.worldofpowersports.com/wps/showmodel.asp?Type=13&make=seadoopwc&a=216&b=11&c=0&d=-MAGNETO-ASSY.-W/-PTO-COVER
  7. Replies
    9
    Views
    752

    Oil needs to be pumped back it's not like a wet...

    Oil needs to be pumped back it's not like a wet sump oil system with a single pump in the pan. You might be able to lift the engine up enough on one side to pull it I have done that inless someone...
  8. Replies
    9
    Views
    752

    If they had scratches in the valve or seat you...

    If they had scratches in the valve or seat you should have replaced them, You didn't clean the Mag pump and install the gears dry? Probably not but thought I would ask. There is a update for cleaning...
  9. Replies
    9
    Views
    752

    You didn't say if you replaced the oil pressure...

    You didn't say if you replaced the oil pressure relief springs and valve or even checked them. If not probably stuck open.
  10. Replies
    3
    Views
    1,232

    I can say with my setup when I had my RXP turbo I...

    I can say with my setup when I had my RXP turbo I tried the WSM pistons and cooked the rings every time I went WOT, Same setup with CP pistons and rings no issues at all.. same tune that engine is in...
  11. Replies
    11
    Views
    2,492

    FS This stuff is sold got picked up today. Thanks...

    This stuff is sold got picked up today. Thanks hybridGPR
  12. Replies
    6
    Views
    1,125

    WTB - Parts Where are you located? I have what you need.

    Where are you located? I have what you need.
  13. Replies
    19
    Views
    1,792

    I doesn't need to be that deep I have ran mine...

    I doesn't need to be that deep I have ran mine both ways with a heat sink extender you will get way more life out of the 02 then stuck deep in the manifold where it will over heat. The heat sink only...
  14. Replies
    22
    Views
    2,798

    Home made coil bolt down

    Well I did have coils problems and solved the problem with a simple rod over the top, then they came out with the 300 setup so i switched over.
  15. Replies
    13
    Views
    2,389

    You don't use the center hole in the new plug.

    You don't use the center hole in the new plug.
  16. Replies
    11
    Views
    2,459

    I like this one it sits flat in the rear of hull...

    I like this one it sits flat in the rear of hull under a bailer bracket and on auto it will just starts pumping. It was a must have on my gprxp using the versa plugs....
  17. Replies
    7
    Views
    1,030

    http://www.ebay.com/itm/SEADOO-RX-RXP-FRONT-HOOD-D...

    http://www.ebay.com/itm/SEADOO-RX-RXP-FRONT-HOOD-DROP-IN-STORAGE-TRAY-STORAGE-BIN-DI-951-947-NR-/401262289950?hash=item5d6d18a41e:g:MJMAAOSwTA9X2zyK&vxp=mtr
    35 bucks shipped. new one is 59.95 at the...
  18. Replies
    21
    Views
    3,162

    yeah the shoe is drilled. I ran the ski wide open...

    yeah the shoe is drilled. I ran the ski wide open it ran 95.9 with no issues the pressure was 60lbs. but would drop to the high 50's and go back up with a slight surge, I think i will plug off my...
  19. Replies
    21
    Views
    3,162

    Like I said in the post I changed to the SS grate...

    Like I said in the post I changed to the SS grate and starting over. I'm not that worried about stuffing so much it was more how hard it is on the tunnel with high pressures. I was out by myself...
  20. Replies
    21
    Views
    3,162

    tunnel pressure

    Interesting read I'm testing mine now I have HO pump 14/26 prop 3 3/4 pump reliefs, ss grate.. this is on turbo GPR @15LBS. of boost. Yesterday rolled the throttle slow and got out of it @88 with...
  21. Replies
    3
    Views
    1,367

    FS No I figured there was no interest in this hull...

    No I figured there was no interest in this hull so I will put it back together in a week or so and have a spare ski.
  22. Replies
    754
    Views
    78,147

    Going back with stock engine so I can sell it I...

    what happened to the RXP?[/QUOTE]
    Going back with stock engine so I can sell it I like the ride of the GP better and I haven't been tossed off yet.:)
  23. Replies
    754
    Views
    78,147

    GRF turbo

    So I take the turbo off my RXP and it's been sitting collecting dust tried to sell it but no takers so thinking what to do? Dusted it off and put it on my GPRXP so far 93+ with only 15LBs. of boost...
  24. Replies
    11
    Views
    1,208

    FS I will take the last 87MM if you still have it.

    I will take the last 87MM if you still have it.
  25. Replies
    3
    Views
    1,367

    FS 04 RXP hull with lots of extras

    04 Seadoo RXP hull no engine, pump, electronics. This was my turbo ski moved the parts over to a GP a/m parts on hull would cost over what I'm selling for.
    2500.00 Solid hull in very good...
Results 1 to 25 of 128
Page 1 of 6 1 2 3 4