Search

Type: Posts; User: borcherta

Search: Search took 0.02 seconds.

  1. Thanks for your input and helping out the...

    Thanks for your input and helping out the amateurs :)
    I wish I had a "jetski tub" like the one you have on your website, would have saved me lots of unsuccessful trips to the launch.

    I have new...
  2. After playing more for a while, it was the gasket...

    After playing more for a while, it was the gasket of the seat.
    Its old, bad and brital ...
  3. Hello and sorry forum for bumping this up again....

    Hello and sorry forum for bumping this up again. I made 2 videos to hopefully now explain myself better ...




    Video 1: trying to pump, its not holding pressure, like *nada*

    ...
  4. yes, I did spray some WD40, I followed the...

    yes, I did spray some WD40, I followed the detailed pop-off video from SBT ... sorry I forgot to mentioned it, changed it in my original post.
  5. ** NO pop-off pressure on my 1993 Waverunner **

    Hello forum,


    we a yamaha waverunner 700 WBX from 1993.
    Carburetor (Mikuni 44mm) has been rebuilt now twice but still is giving us problems.


    Hard start (we now switched to primer which...
  6. Replies
    10
    Views
    1,729

    As far as I understand, the "diesling" is due to...

    As far as I understand, the "diesling" is due to air leaks. Depending on the make &model, to find & fix those leak might be very labor intesive.

    To compensate the lean running I was thinking of...
  7. Just use some paint stir sticks to hold the...

    Just use some paint stir sticks to hold the engine from cranking. When I tried ring clamps and other things I started to scratch the pistons with all the missed attemps. Not sure if the SBT exchange...
  8. Finally I took the whole engine out, its not...

    Finally I took the whole engine out, its not really so much more work. Having the engine on the workbench ... its so much easier to do. I would recommend.
  9. Which zip ties did you use? Do you prepare all 3...

    Which zip ties did you use? Do you prepare all 3 cylindersI have bigger one that could cover both rings, I tried to only zip the lower ring and tighten the top by hand.
    I have 1 in but no clue how...
  10. So now SBT Florida technical support has the...

    So now SBT Florida technical support has the following infos:

    "It is easiest to have a helper hold the cylinders while you squeeze the piston rings and rotate the crank while inserting each piston...
  11. Yamaha 1200SUV - problems with new cylinder install

    Hello,

    we are about to install a SBT top-end exchange kit on our Yamaha 1200SUV.

    The most tricky part seems to be installing the big cylinder core over the 3 piston and rings. Even with an...
  12. Thread: .

    by borcherta
    Replies
    2
    Views
    396

    .

    .
  13. Replies
    0
    Views
    6,349

    800 SX-R & Ultra 150 Service Manual

    Hi there!


    Since no one is willing to share ... well I will start to contribute:


    Service Manual KAWASAKI ULTRA 150 (239 pages - 6 MByte)
    Ultra
Results 1 to 13 of 13