Search

Type: Posts; User: Hot_Water

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. FS SOLD

    SOLD
  2. http://www.greenhulk.net/forums/showthread.php?t=2...

    http://www.greenhulk.net/forums/showthread.php?t=252201

    http://www.nauticalcharts.noaa.gov/mcd/NOAAChartViewer.html

    http://www.charts.noaa.gov/OnLineViewer/AtlanticCoastViewerTable.shtml
    ...
  3. Replies
    11
    Views
    1,980

    Yes, drain old gasoline and then use fresh...

    Yes, drain old gasoline and then use fresh gasoline.

    If you get no performance increase, pull the rubber boot off of the manifold throttle body coming from the air filter box. Maybe the air filter...
  4. Heated and pressed.

    Heated and pressed.
  5. Replies
    4
    Views
    1,629

    Thanks for your reply, Erierunner !

    Thanks for your reply, Erierunner !
  6. Replies
    4
    Views
    1,629

    2006 Yamaha VX 110 speed

    2006 Yamaha VX 110 speedometer indicates 57 mph / 58 mph @ WOT. Anyone know how accurate the speedometer is?
  7. Maybe this would be a good estimate of prices? ...

    Maybe this would be a good estimate of prices?

    http://www.nadaguides.com/Boats/2013/Yamaha/WAVE-RUNNER-FX-SHO/32030665/Values
  8. Replies
    6
    Views
    1,897

    I have a CLYMER manual 1993 to 1996 that states,...

    I have a CLYMER manual 1993 to 1996 that states, for a Yamaha 1100 cc engine;

    concentric alignment should be .6mm / .024in or less

    shaft end gap 2 to 4mm / .079 to .157in

    These clearances...
  9. Replies
    26
    Views
    2,690

    I've read some where that the engine should not...

    I've read some where that the engine should not be cranked, unless the spark plugs are connected to the high voltage wires and the spark plugs are grounded to the block. If plugs are not connected...
  10. Compare the cylinder head part numbers? ...

    Compare the cylinder head part numbers?

    http://www.boats.net/parts/search/Yamaha/Waverunner/2008/parts.html
  11. Replies
    26
    Views
    2,690

    Maybe corrosion inside the wiring harness...

    Maybe corrosion inside the wiring harness connectors feeding the CDI box? Separate the plastic wiring connectors, check for corrosion, then rinse them out with WD40 and reconnect them?
  12. Replies
    26
    Views
    2,690

    Do you have the safety lanyard clipped onto the...

    Do you have the safety lanyard clipped onto the handle bars safety stop switch, "dead man" switch?
  13. Replies
    10
    Views
    1,371

    I don't think your plugs look excessively lean as...

    I don't think your plugs look excessively lean as they look a little tan and are not bone white. What was the air temperature the day you ran your plug test? With out turning a carburetor mixture...
  14. Replies
    12
    Views
    2,126

    I don't think your plugs look excessively lean as...

    I don't think your plugs look excessively lean as they look a little tan and are not bone white. What was the air temperature the day you ran your plug test? With out turning a carburetor mixture...
  15. Replies
    22
    Views
    2,222

    Maybe it is a bad tilt (roll over) switch? The...

    Maybe it is a bad tilt (roll over) switch? The purpose of the tilt switch is to cut out the engine if you roll the ski over or upside down. Maybe tilt switch is partially cutting out? I'm not...
  16. Replies
    22
    Views
    2,222

    Maybe it is a bad tilt (roll over) switch? The...

    Maybe it is a bad tilt (roll over) switch? The purpose of the tilt switch is to cut out the engine if you roll the ski over or upside down. Maybe tilt switch is partially cutting out? I'm not...
  17. Replies
    22
    Views
    2,222

    Maybe you have some water in the fuel / water...

    Maybe you have some water in the fuel / water separator? #5 in the diagram > http://<iframe width="560" height="315" src="https://www.youtube.com/embed/PdYRwsFl9w4" frameborder="0"...
  18. Replies
    5
    Views
    1,691

    Did they try to start the engine by using...

    Did they try to start the engine by using "starting fluid"? Starting fluid detonation can break piston rings and more.
  19. Replies
    13
    Views
    2,055

    Free, now that's a smoking deal. >...

    Free, now that's a smoking deal. > http://www.nadaguides.com/Boats/1992/Yamaha/WAVE-RUNNER-VXR-WRB650Q/10201854/Values
  20. Do you have any pictures of the back of the...

    Do you have any pictures of the back of the switch?
  21. Replies
    5
    Views
    1,521

    FS Whoa, you're in a difficult situation. I think...

    Whoa, you're in a difficult situation. I think most people would want a bill of sale and a vehicle title with purchase of the trailer.
  22. Replies
    0
    Views
    563

    NOAA Nautical Charts Online Viewer

    http://www.nauticalcharts.noaa.gov/mcd/NOAAChartViewer.html
  23. Replies
    1
    Views
    636

    I think the most important issue would be making...

    I think the most important issue would be making sure that the weight of the pistons are the same. This would be dynamic weight. You would probably have to adjust the air/fuel ratio a little for the...
  24. http://www.nauticalcharts.noaa.gov/mcd/NOAAChartVi...

    http://www.nauticalcharts.noaa.gov/mcd/NOAAChartViewer.html


    http://www.charts.noaa.gov/OnLineViewer/AtlanticCoastViewerTable.shtml


    http://www.charts.noaa.gov/OnLineViewer/12211.shtml

    ...
  25. Replies
    2
    Views
    484

    Maybe you have some water in the fuel /...

    Maybe you have some water in the fuel / condensation separator? Drain the fuel separator into a glass, let it stand and see if you have some water in the bottom. Ethanol fuel sucks. Figure #4 in the...
Results 1 to 25 of 100
Page 1 of 4 1 2 3 4