Search

Type: Posts; User: turboman412

Page 1 of 8 1 2 3 4

Search: Search took 0.02 seconds.

  1. Do they both have stock heads or aftermarket?

    Do they both have stock heads or aftermarket?
  2. I believe it also says it on the spark arrester

    I believe it also says it on the spark arrester
  3. There is no orings for the holder, only thing it...

    There is no orings for the holder, only thing it could possibly be is an oring for the nose cone or something left behind from previous owner. Which i wouldnt worry about it.
  4. Its the same as the stxr

    Its the same as the stxr
  5. I have a few stock nozzles if you like, drop me a...

    I have a few stock nozzles if you like, drop me a pm
  6. These skis look pretty hooked up with a the...

    These skis look pretty hooked up with a the goodies! One of those nozzles are made.by r&d the other is home made modified. Wouldnt be a bad idea to ditch both those nozzles and go back to stock. From...
  7. Not accurate at all. They will do around 65

    Not accurate at all. They will do around 65
  8. I run a rule manual pump, i cannot remember the...

    I run a rule manual pump, i cannot remember the gpm been some time. With a switch mounted in compartment where the key is. I also run blowsion vacate drain valves. I wound leave stock system in place...
  9. No it wont, that system is useless

    No it wont, that system is useless
  10. I would replace it now, i have had one of those...

    I would replace it now, i have had one of those go bad while i was on the lake and the ski almost sank. Why chance this?
  11. I have just lifted it and pull the shaft out in...

    I have just lifted it and pull the shaft out in the past.
  12. Your driveshaft holder has ripped very common,...

    Your driveshaft holder has ripped very common, replace with a nice rhaas or wsm.
  13. When i purchased mt stxr the original owner...

    When i purchased mt stxr the original owner installed a aftermarket stinger kit and installed the gasket upside down so the water passage was on the bottom of the pipe and not the top. The cylinders...
  14. Replies
    2
    Views
    207

    Looks fine to me 600 dollar part? No way...

    Looks fine to me


    600 dollar part? No way maybe a 50 dollar used. I think i have 3-4 of those

    Always use a hydraulic press
  15. Maybe they switched through production? Maybe my...

    Maybe they switched through production? Maybe my cases were swapped at some point? Im just going off what years i have had. Only year i have never owned was an 04.
  16. My 01 has the smaller oem starter, my buddys 02...

    My 01 has the smaller oem starter, my buddys 02 and my stxr both have the bigger oem starters.
  17. 2002 up have the bigger starters..

    2002 up have the bigger starters..
  18. Try starting engine with drive shaft pulled back...

    Try starting engine with drive shaft pulled back and pump out. Sounds like your pump is trashed, is impeller hitting the wear ring? Normally starters works or it doesnt. I would not even bother...
  19. Replies
    29
    Views
    1,379

    Ada is starting to discontinue parts for the 150,...

    Ada is starting to discontinue parts for the 150, so of your after an aftermarket head buy one now. You wont have any fitment issues with the one peice head

    If your looking for stock heads let me...
  20. Replies
    29
    Views
    1,379

    Splish splash is right, looks like there is a...

    Splish splash is right, looks like there is a hole in that piston
  21. Replies
    29
    Views
    1,379

    Oh man, silicone with a head gasket thats pretty...

    Oh man, silicone with a head gasket thats pretty scary. I would be pulling that engine to look over everything that guy touched.


    Wsm head gaskets work very well,i have multiple sets on high hr...
  22. Replies
    29
    Views
    1,379

    R&d heads use head gaskets not orings

    R&d heads use head gaskets not orings
  23. Replies
    29
    Views
    1,379

    Why not run it on the hose let it burn off excess...

    Why not run it on the hose let it burn off excess oil and then perform a test?
  24. Replies
    29
    Views
    1,379

    Only thing about those heads if you have a...

    Only thing about those heads if you have a failure your gunna have a hard time finding a replacement.
  25. Agree on the doughnuts, my skis all have shreds...

    Agree on the doughnuts, my skis all have shreds and beach houses and my stxr will out handle my ultra any day of the week and have the pump stay planted. They did a really really good job for...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4