Search

Type: Posts; User: TimeBandit

Search: Search took 0.01 seconds.

  1. Replies
    39
    Views
    2,007

    Hmmmmm.... I'm not seeing any big changes to the...

    Hmmmmm.... I'm not seeing any big changes to the IB as per the fiche (2008-2020) ... perhaps you are referencing the "other" IB unit Yamaha made ??
    i.e., I see in your sig-line you own both FZ and...
  2. Replies
    39
    Views
    2,007

    Trust me . . . you (or service dept) will need to...

    Trust me . . . you (or service dept) will need to grease that IB from time to time - it is after all a part of the prescribed service intervals.


    ///break///


    For discussion purposes, and all...
  3. Replies
    39
    Views
    2,007

    Please clarify your comments above . . . I'm...

    Please clarify your comments above . . . I'm assuming you are not referencing greasing via the Zerk fitting, and rather referencing the back of the IB housing, aka the void area that mates with the...
  4. Replies
    39
    Views
    2,007

    Not off hand, they are small. Doubt you'd need to...

    Not off hand, they are small. Doubt you'd need to replace them, yet I did with all 316 stainless last time I pulled my engine.
    Anyways, it's just not uncommon that they might need to be tighten-up...
  5. Replies
    39
    Views
    2,007

    Try pointing the camera at various coolant system...

    Try pointing the camera at various coolant system hose clamps - all the clamps underneath the exhaust manifold is a likely area.
    FYI, pressures in that system get considerably higher at and near to...
Results 1 to 5 of 5