Search

Type: Posts; User: slociviccoupe

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    208
    Views
    39,852

    Brice if even still on greenhulk, what programing...

    Brice if even still on greenhulk, what programing was done to make the gpr cluster work ? Already have fx sho cluster mounted in mine but existing 1300r cluster would have been noce. Was cluster...
  2. Replies
    3
    Views
    1,442

    I was wondering this as well. Flow and heat wise...

    I was wondering this as well. Flow and heat wise would the larger inducer/exducer svho based wheel and front cover be better than sho with aftermarket wheel? Or even better svho aftermarket wheel. ...
  3. And would have to go through the water jacket to...

    And would have to go through the water jacket to do so also. So welded on the inside and the outside of the manifold. The spacer is easier.
  4. Replies
    6
    Views
    504

    It's based off injector duty cycle, tps? And...

    It's based off injector duty cycle, tps? And engine rpm? That comes up with fuel consumption. This is same way obd2 diagnostic tools do mpg. It's not like a fuel flow sensor in the fuel line. That...
  5. Replies
    26
    Views
    1,493

    Introduce more water into the exhaust after the...

    Introduce more water into the exhaust after the water box. Or find/Make an inline resonator. A race muffler from burns stainless would probably work. Have them put a drain bung on it and pack with...
  6. So I'm interest in the programing the GPS module...

    So I'm interest in the programing the GPS module with cluster in kilometers. What I'm having trouble with is the value on the cluster in kilometers or is the number a new mph number. I don't want to...
  7. WTB 160mm stainless sho wear ring and 13/18 twin prop

    Looking for good condition sho 160mm stainless wear ring and
    A good condition used twin prop setup. 160mm 13/18.
    Going on gpr sho so no svho liners. I have Riva 12 vein pump so wear ring needs to...
  8. Replies
    10
    Views
    1,948

    What lower injector seals with svho injectors in...

    What lower injector seals with svho injectors in sho? Run the stock svho lower o rings/seals?
  9. Replies
    7
    Views
    856

    WTB - Parts Mind me asking what happened to yours or need one...

    Mind me asking what happened to yours or need one for something else?
  10. Replies
    4
    Views
    1,450

    Improved holeshot with less cavitation. And...

    Improved holeshot with less cavitation. And ability to step up to 160mm prop. Been told need 15 psi or more to push this pump setup though.
  11. Replies
    5
    Views
    1,019

    Might have to change map sensor to one from sho...

    Might have to change map sensor to one from sho or svho, not sure if na skis have different map sensor
  12. Replies
    5
    Views
    1,019

    Bigger injectors from svho or injector dynamics....

    Bigger injectors from svho or injector dynamics. Metal fx ho/vxr intake manifold, add turbo and aftercooler, then deans tune. Plenty of guys running high compression. High compression low boost is...
  13. Replies
    5
    Views
    1,422

    Deans tried the lumajet clutch and found didn't...

    Deans tried the lumajet clutch and found didn't last. Worked eith someone on their own style clutch and have them in their sponsored racee boats skis with 27-31 pounds of boost over 9k rpms and wide...
  14. Replies
    4
    Views
    3,126

    Spark engine will fit. Turbo it and have really...

    Spark engine will fit. Turbo it and have really nice ski. In my opinion the seadoo hx with spark engine would be ideal ski. But suppose xpl would be just as fun.
  15. Replies
    39
    Views
    4,861

    Dean spoke to me about it yesterday. They have...

    Dean spoke to me about it yesterday. They have found that when a clutch goes bad and locks up instead of slipping it tends to bend the shaft then the shaft breaks. Higher than stock rpm's and higher...
  16. Replies
    39
    Views
    4,861

    So to the people who have broke a shaft. Did Riva...

    So to the people who have broke a shaft. Did Riva stand behind their product and replace it as a whole kit or did they send replacement parts that were damaged/broken. I'm in a predicament where...
  17. Replies
    0
    Views
    435

    Supercharger shaft comparison

    Searched but couldn't find. Has anyone done a supercharger shaft comparison. Like Riva gen 3 vs. r&d vs. 2014 svho , engine tech.

    Also how to verify the stock sho shaft vs the svho shaft. ...
  18. Replies
    5
    Views
    1,024

    You need to check valve adjustment. Feeler gauge...

    You need to check valve adjustment. Feeler gauge between cam and bucket under it. There is specified clearance for intake and exhaust. If it's too tight valves may stay open, to loose not getting...
  19. Replies
    5
    Views
    1,024

    They have different part numbers but...

    They have different part numbers but dimensionally are same head. Have you installed the head aslready and looking power. What cams are in it, did you do valve adjustment or check it.
    And I know...
  20. Replies
    39
    Views
    4,861

    Has anyone seen wear on the rear cover piece like...

    Has anyone seen wear on the rear cover piece like the shaft has touched, also any wear like the one piece bushing has spun in the cover. I got supercharger with shaft in it and is showing wear...
  21. WTB - Parts But with ride and trim will work as well. Anyone...

    But with ride and trim will work as well. Anyone parting newer skis?
  22. Replies
    5
    Views
    1,024

    Yes you can use NA 1.8 head from fx ho, vxr. ...

    Yes you can use NA 1.8 head from fx ho, vxr. Can use your cams and reshim for those cams, or use the vxr /fx ho cams in the head they came in. Little bit of performance gain using vxr cams in...
  23. I would personaally not put transmission fluid in...

    I would personaally not put transmission fluid in an engine. It has detergents and friction modifiers in it and can wipe out main and rod bearings.
    I got a hurricane damaged ski with water in oil...
  24. WTB - Parts Bump to top, anyone? Need these asap to get...

    Bump to top, anyone? Need these asap to get project on a roll.
  25. Replies
    4
    Views
    784

    WTB - Parts I've got 2013 fx sho stock intake. 25$ plus...

    I've got 2013 fx sho stock intake. 25$ plus shipping?
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4