Search

Type: Posts; User: RXP-SWE

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Thread: weird noise

    by RXP-SWE
    Replies
    11
    Views
    705

    Pulled the pump today and took it apart, bearings...

    Pulled the pump today and took it apart, bearings are shot and lots of water inside. I'll check what needs to be replaced and order the parts.
  2. Thread: weird noise

    by RXP-SWE
    Replies
    11
    Views
    705

    OK, I'm at about the same hours, but I have had...

    OK, I'm at about the same hours, but I have had no previous work done to the pump, will be interesting to see what it look like.
  3. Thread: weird noise

    by RXP-SWE
    Replies
    11
    Views
    705

    Thanks for the update, I'll be pulling my pump...

    Thanks for the update, I'll be pulling my pump and take it appart soon.

    How many hours are you at?
  4. Replies
    9
    Views
    696

    I think it's only fuel, that would make the...

    I think it's only fuel, that would make the Maptuner superior from a performance perspective, it's much more expensive though.
  5. Replies
    1
    Views
    178

    If you PM me your email address, I can send some...

    If you PM me your email address, I can send some wiring diagram and trouble shooting guide.
  6. OK, so it seems ECO mode just keeps the engine...

    OK, so it seems ECO mode just keeps the engine below the rpm where the SC kicks in, which makes sense I would say.
  7. Thread: weird noise

    by RXP-SWE
    Replies
    11
    Views
    705

    Mine started sounding something like that now at...

    Mine started sounding something like that now at the end of our season, not that bad yet though. My plan was to take the pump apart and also check driveshaft and engine mounts during the winter. Mine...
  8. In general, during cruising, about the same...

    In general, during cruising, about the same amount of power would be needed to keep a given speed, and then it comes down to engine efficiency. Obviously drag depending on hull design, pump design...
  9. Replies
    3
    Views
    390

    Good news, I guess only the motor is not...

    Good news, I guess only the motor is not available as Seadoo spare part? How did you fix it and what motor did you use?
  10. Replies
    26
    Views
    3,584

    Well, I guess that depends on the reason you...

    Well, I guess that depends on the reason you bought a Spark in the first place, I did it because it's totally unique on the market today and I wanted something light and nimble to jump waves and have...
  11. Replies
    26
    Views
    3,584

    2021 will be the 8th year of the Spark, and apart...

    2021 will be the 8th year of the Spark, and apart from the Trixx nothing much has really happened. I'm not sure what lifespan BRP calculates for a Spark, I would have thought that many early buyers...
  12. Replies
    13
    Views
    907

    Did you need to replace the impeller as well, or...

    Did you need to replace the impeller as well, or was it repairable?
  13. Replies
    13
    Views
    907

    There's nothing wrong with plastic per se, it's...

    There's nothing wrong with plastic per se, it's what's there from the factory and it will work fine and it's cheaper, you will need to replace it again at some point though.
  14. Replies
    13
    Views
    907

    There are pros and cons with both, but thinking...

    There are pros and cons with both, but thinking that a plastic ring would save your impeller is mostly wishful thinking, just look at the pics in this thread.

    SeaDoo makes a ton of money selling...
  15. Found this: "As a general rule, a naturally...

    Found this:

    "As a general rule, a naturally aspirated combustion engine will lose 3% of its power for every 1,000 ft of elevation gain. If you have 100 horsepower at sea level by the time you get...
  16. Replies
    1
    Views
    487

    You have PM.

    You have PM.
  17. Replies
    4
    Views
    513

    I put a clamp on the water hose that cools the...

    I put a clamp on the water hose that cools the exhaust manifold, to be able to tow the Spark. Then I forgot to remove it when I started and it only took a minute or so before I got an over heat...
  18. Replies
    3
    Views
    671

    I had the same issue, even though I did not...

    I had the same issue, even though I did not realize it before. I have not had access to my old seat now, but as soon as I do I will swap that rubber thing.
  19. Replies
    3
    Views
    671

    Thanks for the information, I haven't really...

    Thanks for the information, I haven't really noticed anything while riding, now I'm going to take a closer look.

    However, my Spark is a 2015, and the comfort seat is from 2019, so it might be that...
  20. Replies
    4
    Views
    418

    They make a totally different sound out of the...

    They make a totally different sound out of the water, like a metallic sound. Inspect the impeller and wear ring through the intake grate underneath the ski, if everything looks OK then try it out in...
  21. First ride of the year, my take on the upgrades I've done this winter!

    So, finally I went for the first ride of the year, still very cold in the water, but decent in the air. So now I have tested all the new upgrades I did during the winter, I'll rank them below from...
  22. Replies
    2
    Views
    399

    Also, if you are rebuilding the complete engine...

    Also, if you are rebuilding the complete engine you should really have the shop manual, PM me your email address and I'll send it to you :)
  23. Replies
    2
    Views
    399

    From the shop manual: Also the rods are a...

    From the shop manual:



    Also the rods are a cracked design and each one is unique and has to be put back together with the same bottom half oriented according to the marks made up of a dot on...
  24. Replies
    6
    Views
    649

    I have the stock intake but otherwise similar...

    I have the stock intake but otherwise similar mods, no issues. Also if it worked OK before, it seam strange if it suddenly doesn't.

    Maybe have a dealer check with BUDS if it shows any error codes.
  25. Replies
    6
    Views
    649

    What hours are you at? Any modifications done? I...

    What hours are you at? Any modifications done? I replaced my plugs now after 5 years and just above 100h, I never noticed any issues like that and the plugs still looked fine.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4