Search

Type: Posts; User: K447

Search: Search took 0.11 seconds.

  1. Replies
    83
    Views
    34,970

    View Post

    What ‘this intake’ are you asking about?
  2. Replies
    83
    Views
    34,970

    Do you know about the Australian/New Zealand...

    Do you know about the Australian/New Zealand style Sprint racing boats?


    https://youtu.be/nv0pI_9JqaU


    https://youtu.be/GPZMUVfJS6k

    They also run on ‘braided’ shallow rivers.
  3. Replies
    83
    Views
    34,970

    Well, there is that effect too.

    Well, there is that effect too.
  4. Replies
    83
    Views
    34,970

    Have a look at how some performance ride plates...

    Have a look at how some performance ride plates on PWC have a sloped upward 'channel' recessed into the bottom rear portion of the ride plate.

    This creates vertical sides that help maintain...
  5. Replies
    83
    Views
    34,970

    Recess the cable base into the transom? ...

    Recess the cable base into the transom?

    Perhaps weld or thread a sleeve into the inside of the exiting transom hole, thread the sleeve to match the cable end, then thread the cable base into the...
  6. Replies
    83
    Views
    34,970

    BTW, one reason to not use a bottom connected...

    BTW, one reason to not use a bottom connected fuel feed tank fitting is to avoid the possibility of a leaking fitting causing the entire fuel tank capacity to drain into the hull.

    With a tank top...
  7. Replies
    83
    Views
    34,970

    For extended riding with an auxiliary dual tank,...

    For extended riding with an auxiliary dual tank, one common method is to connect the vent inlet on top of the primary tank to the fuel outlet on bottom of the auxiliary tank. The auxiliary tank top...
  8. Replies
    83
    Views
    34,970

    What is a one way valve? How would that allow the...

    What is a one way valve? How would that allow the fuel tanks to transfer fuel across?
  9. Replies
    83
    Views
    34,970

    I was thinking about a single Deka ETX16 AGM...

    I was thinking about a single Deka ETX16 AGM battery mounted against the underside of the front deck, mounted WAY forward in the point of the bow. I have found the factory sealed Deka AGM to work...
  10. Replies
    83
    Views
    34,970

    Consider locating the battery very far forward in...

    Consider locating the battery very far forward in the nose if you want to help keep the front down and reduce porpoising.

    That battery seems larger/heavier than is typical for a PWC engine.

    The...
Results 1 to 10 of 10