Search

Type: Posts; User: henn

Search: Search took 0.00 seconds.

  1. Thread: GPRXP Hull Cuts

    by henn
    Replies
    59
    Views
    27,568

    Sticky: I used spray foam to fill it, then when I was...

    I used spray foam to fill it, then when I was doing the resin on my Pump, I painted the resin over the foam to harden it up, so I didnt get foam deteriorating and making a mess
  2. Thread: GPRXP Hull Cuts

    by henn
    Replies
    59
    Views
    27,568

    Sticky: my cuts are made, filled with foam, just going to...

    my cuts are made, filled with foam, just going to brush on apoxy resin over top to harden it up a bit, my mounts should be here tommorow aswell! Now I need my damn Doner boat to arrive so I can...
  3. Thread: GPRXP Hull Cuts

    by henn
    Replies
    59
    Views
    27,568

    Sticky: I thought it was needed, o.k, so I will quick...

    I thought it was needed, o.k, so I will quick foam the big holes, and then just apoxy the rest...to make myself feel better. When I cut out the middle cut, it basically stayed sealed all the way...
  4. Thread: GPRXP Hull Cuts

    by henn
    Replies
    59
    Views
    27,568

    Sticky: also wanted to know what you guys are...

    also wanted to know what you guys are fiberglassing the inside of the hulls with, I have heard that the sheets of glass with normal resin will NOT stick to the material on the inside of the hull, I...
  5. Thread: GPRXP Hull Cuts

    by henn
    Replies
    59
    Views
    27,568

    Sticky: right on, so If I did leave it where it was, and...

    right on, so If I did leave it where it was, and supported it, what are my options for I-shafts, I am running a skat pump 12 vein set back. I spent last night reading on this site, but all I could...
  6. Thread: GPRXP Hull Cuts

    by henn
    Replies
    59
    Views
    27,568

    Sticky: nothing is fool proof, i did the cuts today and...

    nothing is fool proof, i did the cuts today and all seems good, not sure what method Im goign to use for the mid wall, not sure if I should just cut the midwall out leaving the support for the...
  7. Thread: GPRXP Hull Cuts

    by henn
    Replies
    59
    Views
    27,568

    Sticky: Hey guys, Im starting my conversion aswell up...

    Hey guys, Im starting my conversion aswell up here in Canada. Jeust wondering, looking at the first picture where the plate has been drilled out leaving the 2 holes, what is the measurment from the...
Results 1 to 7 of 7