Search

Page 1 of 2 1 2

Search: Search took 1.00 seconds.

  1. FS Maptuner x handled with protective case and cables. $300

    I sold my ski so I no longer need the tuner. I have the tuner, seadoo cable, data logging cable and a rubber protective case to prevent damage. $300 shipped.
  2. Does anyone know what this engine noise could be?

    Took it out last week and everything was fine. Went home and changed the oil and plugs and started it up and it was fine. Went to start it then next day and after about 15 seconds of idling, I heard...
  3. 142 guys...whats your top end timing and AFR?

    What are you guys running on pump gas with the 142? I'm running 8oz of torco per every 5 gallons of 93 to make 97 octane. The base riva XXX 9200 tune says 30* of timing up top. What are you guys...
  4. Replies
    42
    Views
    8,313

    Mine is the opposite.

    Mine is the opposite.
  5. Replies
    11
    Views
    1,030

    I already purchased a fizzle with a custom open...

    I already purchased a fizzle with a custom open loop setup. 445848445849445850
  6. Replies
    14
    Views
    1,118

    I have aluminum IC pipes.

    I have aluminum IC pipes.
  7. Replies
    86
    Views
    9,659

    View Post

    Iíll try that.
  8. I did...431991

    I did...431991
  9. 431954 88 on a full tank on a lake. No...

    431954

    88 on a full tank on a lake. No current. Getting closer.
  10. Maybe the hose from the bottom of the exhaust...

    Maybe the hose from the bottom of the exhaust manifold was left loose and came off.
  11. Replies
    31
    Views
    3,067

    The logger is useless. I initially had it and had...

    The logger is useless. I initially had it and had them change it to the monitoring app so I could program my learners key to a regular key.
  12. Replies
    86
    Views
    9,659

    Got to 87mph(on dash) with 1/2 tank and 6620rpms....

    Got to 87mph(on dash) with 1/2 tank and 6620rpms.

    https://youtu.be/Ju9RaTSAA2k
  13. https://youtu.be/Ju9RaTSAA2k

    https://youtu.be/Ju9RaTSAA2k
  14. Picked up 150RPM by adjusting AFR from 11.9 to 12.2

    Dialing in my new setup, Iíve been playing with fuel to see what kind of gains I can make. I spoke with Jesus and he said with my XX charger/cam setup, 12.2-12.8 AFR is where the skis like it. I was...
  15. Replies
    49
    Views
    2,883

    View Post

    Before or after, it doesnít matter. The air coming out of the BOV is nowhere near as hot as the entire engine itself. If anything, the air being cooler than the engine itself would actually cool the...
  16. Replies
    23
    Views
    1,605

    View Post

    [emoji23][emoji23] Iím going to go with the condensation. Itís freezing cold out and the can is vented to the outside of the hull. Most likely pulling moisture in from there as well.
  17. Replies
    86
    Views
    9,659

    https://youtu.be/nlpnqXuwlZ8 First time over...

    https://youtu.be/nlpnqXuwlZ8

    First time over 8k rpm. Down 7į of timing from where I will be when itís fully broken in and ready. It feels good. Strangely, itís making about 18lb of boost from the...
  18. Replies
    11
    Views
    1,596

    I went to Home Depot and bought a longer...

    I went to Home Depot and bought a longer stainless bolt, some thick washers, and a nylock nut. I screwed in the bolt, put some washers over the protruding portion of it and then tightened down the...
  19. Replies
    86
    Views
    9,659

    View Post

    Installed my fuel pressure regulator yesterday. The fittings were wrong as the fuel rail fitting on the 300 is different than what comes in the kit. I had to cut the ends off and swap them...which...
  20. MapEdit..which table controls startup/cold fueling?

    Thatís what Iím trying to figure out. There is a warm map and a ďpsĒ map. Iím just going to edit the one that doesnít say warm and hope for the best.




    Cmon now! I donít go into boost for a...
  21. Replies
    86
    Views
    9,659

    https://youtu.be/zZCreZ0TiNY

    https://youtu.be/zZCreZ0TiNY
  22. Replies
    86
    Views
    9,659

    View Post

    Iím from Connecticut, they are in Cali. Sent it out last week. Took about 8 days.
  23. Replies
    86
    Views
    9,659

    428993 Impros has my vote.

    428993

    Impros has my vote.
  24. Replies
    17
    Views
    2,188

    I did it through the front and if I had to do it...

    I did it through the front and if I had to do it again, Iíd pay for the Riva kit.
  25. Replies
    42
    Views
    5,720

    418341

    418341
Results 1 to 25 of 50
Page 1 of 2 1 2