Search

Type: Posts; User: nmpeter

Page 1 of 8 1 2 3 4

Search: Search took 0.07 seconds.

  1. And....

    And....
  2. Replies
    66
    Views
    1,770

    I was insinuating that the stator was damaged by...

    I was insinuating that the stator was damaged by the PO removing or attempting to remove the flywheel and that damage finally caused stator failure

    Fact that the flywheel was quite troublesome to...
  3. Replies
    66
    Views
    1,770

    most likely now that my long term storage has...

    most likely now that my long term storage has finally come on line I have the answer on your stator issue

    Using bolts that are too long when running the flywheel puller will do that exact type of...
  4. Replies
    66
    Views
    1,770

    well that;s some absolute fookery..may have been...

    well that;s some absolute fookery..may have been some previous damage that finally failed if you didn't find anything bouncing around in there, not even any metal bits on the magnets

    how was it...
  5. Replies
    22
    Views
    761

    sorry to say your problems are just beginning,...

    sorry to say your problems are just beginning, since running DI pumps are a pretty tough find these days. Do lots of research on the topic before plunking down for any pump that claims to "work in a...
  6. Pesky liability insurance, actually I'm boat...

    Pesky liability insurance,

    actually I'm boat shop competitive at $135
  7. Sticky: UPDATE with a side order of WTF Frankly I'd be...

    UPDATE with a side order of WTF
    Frankly I'd be taking a stink eye to any HF product that has welded bits, including presses and engine cranes...
  8. you must unbolt the exuast from the manifold,...

    you must unbolt the exuast from the manifold, remove the rubber muffler strap and move the entire exhaust back a few inches or you will be in there for a few days. I'm poretty sure there are some how...
  9. https://www.countrycat.com/oem-arctic-cat-parts/ar...

    https://www.countrycat.com/oem-arctic-cat-parts/arctic-cat-part-0675-090-ring-steering-sc-mach
  10. the book value (KBB) on a 2010 is $4585 that...

    the book value (KBB) on a 2010 is $4585

    that means it needs NOTHING except some fuel and a quick wipe down with a wet rag to run all day long. Sitting for a long time damages the value,...
  11. Thread: 2000 GTX Help!

    by nmpeter
    Replies
    9
    Views
    180

    that's a couple of battery bolts and more...

    that's a couple of battery bolts and more worrisome, the rubber damper for the exhaust pipe.

    looks like the bushing was not replaced at least from what I noticed in the picture. The bolt must not...
  12. that shaft is toast, and the driveshaft has to be...

    that shaft is toast, and the driveshaft has to be able to jink in the pto or really bad things will happen to the engine

    you'll get maybe a couple of hours out of it, then boom.
  13. Wow $1100 for a plastic bag infestation? WTF ...

    Wow $1100 for a plastic bag infestation?

    WTF

    was it a full roll of 99 gallon contractor grade bags?

    Iím raising my labor rate to $300 an hour next season!
  14. Replies
    7
    Views
    205

    ApprovedAF

    ApprovedAF
  15. Replies
    15
    Views
    377

    voltage over 14.4 is indicative of a bad voltage...

    voltage over 14.4 is indicative of a bad voltage regulator and that can spike the emm and cause all sorts of problems

    connectors are difficult to source, I'd not worry about it too much

    I...
  16. Replies
    9
    Views
    299

    can go get it to throw a code while its on the...

    can go get it to throw a code while its on the hose?

    the IBR is one of the most sensitive bits of electronic gear I've ever encountered

    if it over or under volts for a millisecond it drops off...
  17. Replies
    66
    Views
    1,770

    6v is way under spec. might have thrown a magnet,...

    6v is way under spec. might have thrown a magnet, pull and inspect
  18. Replies
    15
    Views
    377

    a broken ground wire would cause an ignition coil...

    a broken ground wire would cause an ignition coil fault to be thrown. Not quite sure if that is retained after the fault is corrected

    I'd measure the running voltage at the battery to be on the...
  19. Replies
    10
    Views
    1,072

    the candoo has a better resale value since it can...

    the candoo has a better resale value since it can be programmed to support other brands

    You should communicate your model year concerns with the seller of the yamaha yds system to be exactly sure...
  20. that's rather odd that the splines would fail...

    that's rather odd that the splines would fail shortly after the intake grate came off. anything that is big enough to cause a sudden engine stop and spline strippage is going to as we say "leave a...
  21. Replies
    9
    Views
    299

    did you check the max battery voltage while the...

    did you check the max battery voltage while the engine was running?

    under what circumstances do these codes appear?

    and where exactly did the replacement IBR come from?
  22. Replies
    3
    Views
    87

    welcome aboard GH. The message sure sounds like...

    welcome aboard GH. The message sure sounds like the maintenance timer, especially since as you say the ski is running well. Consider it a reminder to drink a bottle of water or to reapply sunscreen...
  23. I don't think it's possible for the grate to be...

    I don't think it's possible for the grate to be ingested by the pump unless there is some significant under hull damage and the grate was broken. You'll see a big chunk of the prop missing and likely...
  24. Vegas Casino President Killed in Jetski Accident

    Yet another high profile PWC accident

    He was hit by a 77 year old man driving a 27 foot boat

    Most of the reports called the jetski a "watercraft" for some reason, this one didn't:...
  25. Replies
    22
    Views
    761

    not shaving the rave valve after installing...

    not shaving the rave valve after installing oversize pistons on a di is a classic mistake

    if I'm not mistaken doesn't the DI only run on one cyl at idle, or was that the RFI?

    other things to...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4