Search

Type: Posts; User: TimeBandit

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Sensors can go bad, sure. But 9-of-10 its...

    Sensors can go bad, sure. But 9-of-10 its typically an obstruction. Did you physical take a look at the intake screen on the jet pump body? An easy 2 bolts removes the cover to permit cleaning and...
  2. Replies
    24
    Views
    523

    Correct. It's been long understood with Yamaha's...

    Correct. It's been long understood with Yamaha's to stick with marine carpet bunks, because the hulls are simply painted - no gel coat, or any other protective "coating". Simply physics - which is...
  3. Replies
    4
    Views
    141

    Feed the mooring line through a pool noodle or...

    Feed the mooring line through a pool noodle or several of them perhaps, tie wraps ... thinking out loud.
  4. Sticky: ^^^ Can you confirm the part number in your...

    ^^^ Can you confirm the part number in your photo? We're trying to get relevant information here, which includes being accurate about specific make & model of this thread's title and categorized...
  5. Replies
    198
    Views
    139,942

    Sticky: Dimensional (width/depth) there are about the...

    Dimensional (width/depth) there are about the same - yet as you refer, they are roughly twice as wide. So, the two issues I foresee is, having trouble getting the gun powerful enough to get that...
  6. Replies
    64
    Views
    1,785

    Consider "back-filling" the entire cable(s) with...

    Consider "back-filling" the entire cable(s) with grease... i.e. using a small length of scrap hose, hose clamps, and a typical grease gun, "adapt" the gun nozzle to one end of the cable sheath...
  7. Replies
    1
    Views
    87

    Aircraft paint remover work fast & won't hurt the...

    Aircraft paint remover work fast & won't hurt the aluminum. You can spray it on an literally rinse it and the paint right off in less than 10 minutes. Old tooth brush for the stubborn areas. PPE -...
  8. Replies
    4
    Views
    165

    Spark plugs can be intermittent faulty with...

    Spark plugs can be intermittent faulty with temps. That rough idle simply could be one cyl dropping out. I'd rotate a spare set in just because. Injector could do that too. Sometimes even the ECU...
  9. Replies
    36
    Views
    1,720

    Service Manual states : Measurement steps: -...

    Service Manual states :

    Measurement steps:
    - Turn the drive coupling counterclockwise, and then check if cylinder #1 is at TDC of the compression stroke with a dial gauge.
    - NOTE: TDC on the...
  10. Replies
    3
    Views
    169

    Mahalos - I lived in Hawaii for 12 yrs once -...

    Mahalos - I lived in Hawaii for 12 yrs once - miss the islands.
    On clear coat... I almost 100% certain Yamaha does not apply clear coats to their skis. Rather, its likely a single-stage color gloss,...
  11. My vote, is a demon. Although we called them...

    My vote, is a demon. Although we called them gremlins usually.
    Oh, and make sure that's a genuine Yamaha original MR1 you have in that ski . . . . as the engine has been out of production for many...
  12. Never bow down?

    Never bow down?
  13. The good thing about a wedge, is that you'll not...

    The good thing about a wedge, is that you'll not loose thrust as compared to having to a trim system to achieve the same angle, hence why I've seen wedges mainly marketed to speed on glass conditions...
  14. Here's a picture of a MR1 HO (slightly different,...

    Here's a picture of a MR1 HO (slightly different, yet the same...
    Port side. Find the ACCT (A) ... the oil switch is right next to it (B). See the single wire coming of it.
    463956
    A) Automatic cam...
  15. That's an MR1 engine. So if you are looking at...

    That's an MR1 engine. So if you are looking at the oil filter (which is screwed into the lower crankcase), go exactly straight up vertically, has a black cover and one wire (screwed into the upper...
  16. =D> Congrats - looks like a lot of thought was...

    =D> Congrats - looks like a lot of thought was put into this.

    Couple of my observations ...
    The way the filler port is located on the aux tank is brilliant. The not only affords seamless filling,...
  17. Replies
    36
    Views
    1,720

    Motoseal by Permatex

    Motoseal by Permatex
  18. Yes - They *should* add fresh grease to the IB...

    Yes - They *should* add fresh grease to the IB housing (intermediate shaft bearing), and I'd highly suggest you make sure they do, as it's kinda a PITA to get at, because you typically need to move...
  19. Depends on where and what measured that value -...

    Depends on where and what measured that value - but generally "yes" that's too low. A healthy batt on a DVM should read 12.8v minimum.
    But if that was read on the dash - could be the just circuit...
  20. Replies
    5
    Views
    149

    I already know you can not spin the motor by hand...

    I already know you can not spin the motor by hand . . . hence likely not a "dead spot" if the motor comes back alive after your repeated attempts to power it up.

    "volts" is one thing ......
  21. Replies
    5
    Views
    149

    I've been on this forum quiet a while, and the...

    I've been on this forum quiet a while, and the statistical-odds likely not - not seen anyone have such an issue like that before, but anything is possible.
    Context in DC motors, a "dead-spot" where...
  22. Replies
    21
    Views
    755

    Correct, marine engines do work harder, and...

    Correct, marine engines do work harder, and that's the main reason to use the oil change interval denominator, as the manufacturers/engineers of cars and water crafts have already done that...
  23. Replies
    21
    Views
    755

    Basically yes - you got it. It's the way "I" do...

    Basically yes - you got it.
    It's the way "I" do it ... and my rational is based on a "total "use" concept. AKA, if you use a car, you're putting miles on it. If you're using a watercraft, you're...
  24. Replies
    21
    Views
    755

    View Post

    Iíve discussed this in another thread somewhere, but the easiest conversion formula to use, is the typical oil change intervals as the common denominator.
    For example, a gasoline car would be every...
  25. Replies
    38
    Views
    1,659

    Hmmmmm.... I'm not seeing any big changes to the...

    Hmmmmm.... I'm not seeing any big changes to the IB as per the fiche (2008-2020) ... perhaps you are referencing the "other" IB unit Yamaha made ??
    i.e., I see in your sig-line you own both FZ and...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4