Search

With the valve cover off, reach in there with a long screwdriver or a stick and just tap or bump the plastic guide which rests against the tensioner, this will release the tensioner and will apply...

I had the Worx sponsons on my GP1800 for two rides before removing them. They were very aggressive in low position or tame in upper position. I noticed that the ski was a bit less stable with a...

Can also fill the intake grate with an epoxy filler and retain the factory rubber strip, then seal it up with silicone, it really helped with cavitation. Transom leaking small amounts of water into...

I prefer to put it in the water and let it get warmed up a bit, make sure the ski is level, then just let it idle for 30 seconds, shut it off and wait one minute, now check the oil. If you add or...

The talked about volute which is pressed into the front half of the two part S/C housing...
http://www.greenhulk.net/forums/attachment.php?attachmentid=411626&stc=1

Drilled through the housing...

http://www.greenhulk.net/forums/attachment.php?attachmentid=408664&stc=1http://www.greenhulk.net/forums/attachment.php?attachmentid=408665&stc=1http://www.greenhulk.net/forums/attachment.php?attachmen...

Fizzle Y1000, plenty of room for BOV line fitting at front of intake...