Search

Page 1 of 5 1 2 3 4

Search: Search took 1.00 seconds.

  1. Looks to be an aftermarket Riva stinger pipe. I...

    Looks to be an aftermarket Riva stinger pipe. I guarantee you Riva will not have any info on it anymore.
  2. .004

    .004
  3. A supercharger is not a pump. It is a...

    A supercharger is not a pump. It is a centrifugal compressor. The reason the leaf blower RPM goes up when you cover the outlet is because you remove the load from the pump. A leaf blower is...
  4. just search Yamaha SHO clutch tool on ebay. Its...

    just search Yamaha SHO clutch tool on ebay. Its the first hit that comes up.
  5. Replies
    11
    Views
    937

    If you have a gas smell in your hull you have a...

    If you have a gas smell in your hull you have a fuel leak somewhere. It MUST be found and repaired before you take it out!
  6. You are correct. The SVHO is safe with the stock...

    You are correct. The SVHO is safe with the stock valve train to 8650. Any higher than that and you need retainers.
  7. Replies
    61
    Views
    6,909

    At the end of the day I went with the Fizzle. ...

    At the end of the day I went with the Fizzle. After reading James' bio on the Fizzle website... how he got into jet skiing...sounds alot like me.....and like someone else said on this thread....I...
  8. Replies
    23
    Views
    1,664

    Sounds like your clutch is going out. It...

    Sounds like your clutch is going out. It happens. They will seem to hesitate some , especially at WOT just before failing completely.
  9. Replies
    23
    Views
    1,664

    I read the post wrong, I thought it said you bent...

    I read the post wrong, I thought it said you bent the prop to achieve more fuel efficiency, I didn't realize you said you got a properly pitched one.
  10. Replies
    23
    Views
    1,664

    That's a big mistake bending the impeller and...

    That's a big mistake bending the impeller and lowering your RPM's like that. You're lugging the engine, and detonation is a real.possibility, especially if you're using anything less than race gas. ...
  11. Replies
    23
    Views
    1,664

    You are looking at it all wrong. If you have not...

    You are looking at it all wrong. If you have not reflashed the ECU you should not touch the impeller. The stock impeller is sized for WOT at factory setup. What you're experiencing now is expected...
  12. Replies
    1
    Views
    220

    Genuine mikuni only NO SUBSTITUTIONS!

    Genuine mikuni only NO SUBSTITUTIONS!
  13. IIRC the 13/19 was stock for 1200r's. The 13/20...

    IIRC the 13/19 was stock for 1200r's. The 13/20 was stock for the 1300r's. Pitching it to 14 on the front side will diminish your holeshot a little. You should be fine with the 14/20. Before...
  14. That larger line is the oil pump supply line. It...

    That larger line is the oil pump supply line. It feeds the pump. Why do you want to replace the oil pump with a block off? The oil pump is super reliable. The lines, however need periodic...
  15. Replies
    14
    Views
    758

    Right now it's not much over stock. You're...

    Right now it's not much over stock. You're wasting your time putting avgas in it right now. That ski can burn 89/93 octane and obtain the same speeds. If you want to make more power you need a new...
  16. Replies
    16
    Views
    1,330

    I'm surprised Yamaha is covering it with the WSM...

    I'm surprised Yamaha is covering it with the WSM pistons in it. I would personally not use WSM pistons. Clearly they didn't fail here, but I have had alot of problems with them in the past on my 2...
  17. Replies
    7
    Views
    469

    You're lucky it didn't run out of gas. The choke...

    You're lucky it didn't run out of gas. The choke cable is attached to the bottom of the front carb. The exhaust has to come out to access it. While you're in there go ahead and rebuild the carbs...
  18. Replies
    7
    Views
    316

    That's quite a bit of turning over to get oil to...

    That's quite a bit of turning over to get oil to the carbs. I always remove the pump and turn it with a drill to get oil through the lines. The pump turns CCW.
  19. Replies
    8
    Views
    535

    That manual is for a SBN 44, the PV engines have...

    That manual is for a SBN 44, the PV engines have an I body carb. Just a little different. Always use genuine parts. Don't get bogged down on pop off. Everyone is pop off crazy. Mikuni gives a...
  20. By tilting the trailer down and tilting the craft...

    By tilting the trailer down and tilting the craft to starboard you can get almost all of it out. What is left is a trivial amount. To keep from having a mess...use an oil absorbent pad under the...
  21. Replies
    11
    Views
    600

    The GPR platform has an inherent rock to it at...

    The GPR platform has an inherent rock to it at speeds somewhat below 28 mph. Just like the 2012 and up FX has an inherent lean to it at lower speeds. You'll learn to deal with it.
  22. Break in procedure as follows: mix oil in tank...

    Break in procedure as follows: mix oil in tank 50:1 if running oil injection, if not mix about 25:1. Start with a full tank of fuel. First 30 minutes of runtime no more than 1/4 throttle,...
  23. I've read that nothing but the recipe as...

    I've read that nothing but the recipe as documented works correctly if you are rejetting. Jets are super cheap....no reason not to do the job correctly.
  24. Replies
    4
    Views
    415

    I would say yes to the clips...but no to the...

    I would say yes to the clips...but no to the couplers in that kit. Had a set on my ski....had more slop than the OEM couplers. The late great Barry Lee gave me a piece of flat stock to make...
  25. FS - Parts I appreciate the correction! NIB....great deal...

    I appreciate the correction! NIB....great deal for someone!
Results 1 to 25 of 122
Page 1 of 5 1 2 3 4