Search

Type: Posts; User: OP. LOCK

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Your ski is 260 limited. Not unlimited. Your hull...

    Your ski is 260 limited. Not unlimited. Your hull type is S3. Did the 2009 ski have S3 hull? What ski was it?
  2. I would install this for starters....

    I would install this for starters.
    https://www.4-tecperformance.com/index.php?main_page=product_info&cPath=18_43&products_id=8503&zenid=grm9f3q1h6rbvnsukiuoae04a1
  3. Replies
    7
    Views
    391

    A used one from audi 1.8T would also do the trick!

    A used one from audi 1.8T would also do the trick!
  4. Replies
    4
    Views
    211

    I agree with the guys above 100%. However i would...

    I agree with the guys above 100%. However i would cover the ski only after is dried insideout. You dont want to trap humidity inside a waterproof cover.
  5. Replies
    8
    Views
    304

    I dont think a 155 hp ski is powerful enough to...

    I dont think a 155 hp ski is powerful enough to strip that shaft splines. A little bit of surface rust is normal. Apply triple guard grease in the prop splines when winterize and you will be fine.
  6. Replies
    7
    Views
    346

    Removing original stickers is like you repaired...

    Removing original stickers is like you repaired the skis paint and you didn t want to pay for new stickers.
  7. Compressing the bellow so much puts a lot of...

    Compressing the bellow so much puts a lot of pressure on thrust bearings isn t it?
  8. Ok. Is possible but I check n clean sc and hoses...

    Ok. Is possible but I check n clean sc and hoses every winter. Also check all clamps carbon ring and engine mounts. I ride on sea.
  9. You will have to tilt the deck every winter for...

    You will have to tilt the deck every winter for winterizing....
  10. If sc passes slipping test and the washers are...

    If sc passes slipping test and the washers are not cracked no need to change washers. Min slipping torque is 8NM.
  11. I d get a repair manual. In addition I d check...

    I d get a repair manual.
    In addition I d check ibr actuator and pump bearing for water ingress.
    If sc bearings are older than 2 years or not sure how old. Change them.
    Must apply triple guard...
  12. Replies
    2
    Views
    136

    If for example reaches 70mph and after a few secs...

    If for example reaches 70mph and after a few secs settles down to 68 its restricted.
  13. Replies
    4
    Views
    297

    Drive shaft must have around 6mm of play without...

    Drive shaft must have around 6mm of play without floating ring on.
  14. Thread: Tops valve

    by OP. LOCK
    Replies
    8
    Views
    518

    Stops oil spil in case the ski turns upside down.

    Stops oil spil in case the ski turns upside down.
  15. Sticky: After tightening the nuts to correct slipping do...

    After tightening the nuts to correct slipping do we need balancing?
  16. Thread: IBR codes

    by OP. LOCK
    Replies
    13
    Views
    595

    Check battery connections. They must be clean and...

    Check battery connections. They must be clean and tight. Also battery must be charged well.
  17. Thread: Code p0524

    by OP. LOCK
    Replies
    8
    Views
    355

    Unchanged oil filter doesn t give a code. You can...

    Unchanged oil filter doesn t give a code. You can check oil filter with out lifting the deck.
  18. Thread: Demolition

    by OP. LOCK
    Replies
    2
    Views
    205

    There is a cheaper way. Pull the bellow to unvail...

    There is a cheaper way. Pull the bellow to unvail the shock chamber and unscrew it.
  19. Thread: Carbon hull

    by OP. LOCK
    Replies
    16
    Views
    1,100

    2020 rxpx has exactly the same design as yours....

    2020 rxpx has exactly the same design as yours. However If I were you I would make an 2018 rxtx 300 carbon hull that happen to be weak and some of them have cracked even with low hours. More have...
  20. Imagine what would have happened if a car company...

    Imagine what would have happened if a car company produced a new car and said if you spill the fuel (thats necessary for its operation) on it, it might disintegrate! Who would buy it?
  21. Thread: Code p0524

    by OP. LOCK
    Replies
    8
    Views
    355

    Check oil filter. If ok check resistance on oil...

    Check oil filter. If ok check resistance on oil presure sensor. Should be 1 ohm if i remember correctly.
  22. Replies
    3
    Views
    271

    Maybe you have corroded ecu pins.

    Maybe you have corroded ecu pins.
  23. Why dont you go to another dealer?

    Why dont you go to another dealer?
  24. They are all fiberglass hulls. Cm tech means...

    They are all fiberglass hulls. Cm tech means paint instead of gelcoat.
  25. Replies
    7
    Views
    496

    If you are good with wrenching and the price is...

    If you are good with wrenching and the price is low go for it.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4