Search

Type: Posts; User: ncdoo

Page 1 of 8 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    11
    Views
    515

    Agreed

    Agreed
  2. Shop manual 2008_Seadoo_ShopManual...

    Shop manual 2008_Seadoo_ShopManual (mediafire.com)
  3. They're basically the same as the 04. Maybe a...

    They're basically the same as the 04. Maybe a little easier. I dont think you will need to move the waterbox with the newer style exhaust which eliminated the J pipe.
  4. Thread: Screw battery

    by ncdoo
    Replies
    8
    Views
    477

    Body Hardware Retainer, Clip, Fastener BK 6653155...

    Body Hardware Retainer, Clip, Fastener BK 6653155 | Buy Online - NAPA Auto Parts (napaonline.com)

    You need something similar to these. If they're the correct size, they shouldn't fall out. Any...
  5. Looks like someone dropped it and bent the case.

    Looks like someone dropped it and bent the case.
  6. This is the Sea Doo section, you'd be better off...

    This is the Sea Doo section, you'd be better off posting in the Polaris section.
  7. Replies
    6
    Views
    406

    Thats a good deal. Maybe he'll throw in a gasket...

    Thats a good deal. Maybe he'll throw in a gasket or sell you one so you dont have to order it separately.
  8. Replies
    6
    Views
    406

    You can remove the PTO with the engine in the ski...

    You can remove the PTO with the engine in the ski but its a lot easier just to pull the engine out IMO. Those supercharger washers are about 12 years old so I would definitely get it rebuilt asap.
  9. Replies
    2
    Views
    186

    To go premix you'll need to remove the oil...

    To go premix you'll need to remove the oil injection pump and its adaptor shaft and install a block off plate. And block off the intake fitting as you mentioned. The fitting in the photo is a vent....
  10. Replies
    5
    Views
    298

    Typical problem with the VTS is the reed switches...

    Typical problem with the VTS is the reed switches fail inside the unit, cannot be repaired normally. You will need new VTS if this is the problem. Make sure you check the rubber boot on the VTS...
  11. Replies
    3
    Views
    168

    If its not the magnets in the float, there is...

    If its not the magnets in the float, there is also a fuse that blows out on the sending unit, it can be repaired.
  12. Replies
    0
    Views
    157

    SOLD 2002 - 2005 Gauge Cluster

    $600 shipped. LCD has been replaced. Works great.
  13. Part#420827261 Should be available on eBay. I...

    Part#420827261 Should be available on eBay. I would definitely try to find the original, you dont wont it floating around inside your motor.
  14. Replies
    23
    Views
    2,100

    Once they start throwing codes, and look like...

    Once they start throwing codes, and look like that, time to replace. You can get a genuine Bosch replacement and save a ton on OEM. BOSCH 0280750009 You'll need a Mahle gasket Part # G31613 and (4)...
  15. Its a pain until you've done it a few times. ...

    Its a pain until you've done it a few times.

    https://www.youtube.com/watch?v=XJC9zDD64bA&feature=emb_logo
  16. How do you know it has milky oil on it if you...

    How do you know it has milky oil on it if you haven't already pulled it? Milky oil will not affect the sensor so cleaning it will not help. How do you know it bad? I have a similar ski but I've never...
  17. I had dual exhaust on a 96XP w/ a 951 motor. ...

    I had dual exhaust on a 96XP w/ a 951 motor. RIVA is proud of their products... Probably get a couple RIVA decals with it which makes it worth it... LOL
  18. Replies
    6
    Views
    511

    PM sent

    PM sent
  19. Thread: 4tec 185 vs 215

    by ncdoo
    Replies
    5
    Views
    388

    06 was the change over year. Some had the bad...

    06 was the change over year. Some had the bad valves, some didn't. Only way to tell is to pull the valve cover and look at the numbers on the valve stem. The bad valves start with 72, good valves...
  20. Replies
    58
    Views
    2,243

    Just because its been on the charger doesnt mean...

    Just because its been on the charger doesnt mean the battery is good. The battery could be weak (or connections bad) like I said. Its apparent that one cylinder has lower compression than the...
  21. Replies
    58
    Views
    2,243

    Make sure you have a new or fully charged...

    Make sure you have a new or fully charged battery. Also suspect would be the battery cable and associated connections. The lugs may look OK but internal corrosion will cause a current drop.
  22. Thread: 2009 rxt-x help!

    by ncdoo
    Replies
    15
    Views
    982

    It would be antifreeze if the oil cooler is...

    It would be antifreeze if the oil cooler is leaking.
  23. Replies
    20
    Views
    2,016

    That's some serious heat on the CB gear!

    That's some serious heat on the CB gear!
  24. Thread: 2009 rxt-x help!

    by ncdoo
    Replies
    15
    Views
    982

    Follow the bleed hose on the IC, it will lead you...

    Follow the bleed hose on the IC, it will lead you to the exit point. May be a dirt dobber nest in the outlet. And you're correct, manifold should not leak when tested as you did.
  25. Replies
    2
    Views
    200

    No tune required.

    No tune required.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4