Search

Type: Posts; User: derick441

Search: Search took 0.00 seconds.

  1. Replies
    15
    Views
    1,279

    2-Stroke No doubt it's been a while since I rebuilt a wave...

    No doubt it's been a while since I rebuilt a wave venture 760. I also swapped out the fuel selector as it was not moving freely also put a new check valve at the tank. After I primed the fuel system...
  2. Replies
    15
    Views
    1,279

    2-Stroke I put the water temp sensor on and was able to...

    I put the water temp sensor on and was able to get the alarm off but still was not getting power or a click. Jumped the starter solenoid with a screwdriver and I got the starter to bump. Replaced...
  3. Replies
    15
    Views
    1,279

    2-Stroke Thanks for the instructions. I got the motor...

    Thanks for the instructions. I got the motor aligned. I bought this ski missing most of the exhaust parts so that information will come in handy. I hooked up the starter got the throttle,choke and pv...
  4. Replies
    15
    Views
    1,279

    2-Stroke Well I managed to pick this engine up with the...

    Well I managed to pick this engine up with the help of my son and get it back in. Didnt even use the hoist. Next got to get it aligned properly. Not sure how these shims work as they fell out when I...
  5. Replies
    15
    Views
    1,279

    2-Stroke I was able to pull the motor out and get the new...

    I was able to pull the motor out and get the new one redone last weekend. Going to get a chain hoist to put this in as it is way to heavy for me to drop in. The rebuild went pretty well its the...
  6. Replies
    15
    Views
    1,279

    2-Stroke I was considering getting one from them. Ended up...

    I was considering getting one from them. Ended up purchasing a good case and new wsm cylinder and 3 pistons. I got all the gaskets, seals, powervalves and carb kits. The only thing I need is the...
  7. Replies
    15
    Views
    1,279

    2-Stroke Well ive checked this engine out and I don't like...

    Well ive checked this engine out and I don't like the looks of it so I'm going to get another case and start fresh. This build will probably set me back $2000+ but at least I know it will be done...
  8. Replies
    15
    Views
    1,279

    2-Stroke Purchased a project 2001 xlt 1200

    Just purchased a new project. Looking at the damage to the middle cylinder I know I at least need new pistons, crank, cylinder and carbs rebuilt. You guys think im better off getting a remanufactured...
Results 1 to 8 of 8