Search

Page 1 of 2 1 2

Search: Search took 1.00 seconds.

  1. Replies
    36
    Views
    1,396

    I’ve always find it difficult to have a nice afr...

    I’ve always find it difficult to have a nice afr WOT and also have the perfect afr in the low rpm and cruising areas

    I will post some fuel maps tonight if I get time. There is a lot of info there....
  2. Replies
    36
    Views
    1,396

    You still need those guys to start you out with a...

    You still need those guys to start you out with a good flash, set your rpm limit, put you a good timing map on the ecu and give us a good starting point for a fuel map. The PCV will fine tune the...
  3. Replies
    36
    Views
    1,396

    It's my ski that has the PCV on it. The site does...

    It's my ski that has the PCV on it. The site does show 2008 - 2010 compatibility. My ski is a 2016 FZR. The newer skis need 2 wires switched to the MAP sensor to work with the Powercommander. Dynojet...
  4. Anybody like to mess with the bass boats??

    https://www.youtube.com/watch?v=Ynw4txSPVcA&t=1s
  5. Go straight to the source. Check with Glen at...

    Go straight to the source. Check with Glen at Skat Trak 909 795-2505 He can answer any questions.
  6. Thread: gprxp

    by dlf2001
    Replies
    1,444
    Views
    132,404

    That's a nice piece there Steve. I think that...

    That's a nice piece there Steve. I think that item kept me from breaking flywheel bolts at high rpm.
  7. Replies
    2
    Views
    455

    SOLD It is my prop. Don't remember speed and rpm. I...

    It is my prop. Don't remember speed and rpm. I tried many combinations then ended up with a turbo on the ski.
  8. SOLD 2012 RXT-X 260 TURBO MOTEC Check it out!!! $10500

    It's getting close to time for some of you guys to start thinking about going fast on the water.
    I have too many skis. Something has to go. Lots of goodies on this ski!!

    2012 Seadoo RXT-X turbo,...
  9. Thread: Barry Lee

    by dlf2001
    Replies
    14
    Views
    1,492

    Barry was not a forum poster. Barry was what I...

    Barry was not a forum poster. Barry was what I would call a legend with the Yamaha Gpr's. He had fast single and triple pipe skis. He was great at hull / ride plate setup and tuning. Barry took a...
  10. Thread: T-45 Build.

    by dlf2001
    Replies
    465
    Views
    82,700

    She resides at Badin Lake in NC.

    She resides at Badin Lake in NC.
  11. Replies
    120
    Views
    57,617

    Looking to do some bearing maintenance on my...

    Looking to do some bearing maintenance on my trailer. I found I can buy the complete hub assembly from Knott in Wisconsin. The assemblies are only $25 each, includes nut, seal and all. May be worth a...
  12. Replies
    17
    Views
    2,480

    Not sure you should be cutting on the resonator....

    Not sure you should be cutting on the resonator. The resonator is below the water line. Any kind of leak there and you could have a big problem.
  13. Here are recent gps readings from 2 conversion...

    Here are recent gps readings from 2 conversion skis in my area.



    http://i265.photobucket.com/albums/ii239/dlf2001/IMG_1152_zps3a7v6xnn.jpg
    ...
  14. Replies
    99
    Views
    12,082

    Nice Steve!

    Nice Steve!
  15. Replies
    99
    Views
    12,082

    2012 RXT-X 9000+ rpm GRF turbo, not sure of the...

    2012 RXT-X
    9000+ rpm
    GRF turbo, not sure of the boost on this run

    Made one run at 86+ mph but didn't get a gps picture
    ...
  16. Replies
    14
    Views
    2,511

    I thought the idea was to see who could use the...

    I thought the idea was to see who could use the most gas.
  17. Replies
    120
    Views
    57,617

    The large nut that holds the bearing in place...

    The large nut that holds the bearing in place tightened to 207 ft lbs. Manufacturer claims do not reuse it. I'm guessing most guys reuse it anyway.
  18. Replies
    35
    Views
    11,686

    Here is an old one for you. I wasn't around at...

    Here is an old one for you. I wasn't around at this time but have since met up with these guys. They still ride like this, wide open!!!

    ...
  19. Replies
    195
    Views
    68,707

    Here is a video of the iControl version. I don't...

    Here is a video of the iControl version. I don't have a wideband sensor on this ski so there is nothing to see there. You can see the boost get pulled back on the top end.
    ...
  20. Replies
    422
    Views
    56,063

    It also has multiple cup holders. It's a really...

    It also has multiple cup holders. It's a really nice grandpa ski. It's right up your alley !!

    Keep talking about it and I may fall madly in love with Yammi also.

    You guys can test different...
  21. Replies
    95
    Views
    13,963

    Bigger hoses running to a bigger throttle body on...

    Bigger hoses running to a bigger throttle body on the new skis maybe.
  22. Replies
    12
    Views
    3,596

    Had that issue with my ski also. Anode wedged...

    Had that issue with my ski also. Anode wedged between the bracket and rideplate. It was a quick fix.
  23. Replies
    19
    Views
    3,415

    My ski had one of the zinc anodes come loose and...

    My ski had one of the zinc anodes come loose and get caught under the ibr bracket.
  24. Agree my bone stock 255 GPRXP was 82mph all day...

    Agree my bone stock 255 GPRXP was 82mph all day the new owner wicked it up some and she is running low 90's.

    Steve, your old ski is the one Blue Notch rode that made him have to have a conversion...
  25. Thread: Turbo-Tastic

    by dlf2001
    Replies
    128
    Views
    16,999

    Nice work Steve. Pictures of my stuff usually...

    Nice work Steve. Pictures of my stuff usually shows a lot of coat hangers and duct tape.
Results 1 to 25 of 40
Page 1 of 2 1 2