Search

Page 1 of 2 1 2

Search: Search took 1.00 seconds.

  1. Replies
    5
    Views
    533

    SOLD www.watcon.com

    www.watcon.com
  2. Replies
    10
    Views
    4,551

    I also like and use Amsoil in all our skis....

    I also like and use Amsoil in all our skis. Excellent protection, less smoke. I use the HP marine.

    All oils are NOT created equal. Do your home work, and find / use a BIA (boat industry...
  3. Try running it on the trailer, in the water, with...

    Try running it on the trailer, in the water, with the seat off. See if you can get it to "die".

    I always start with the basics. You need, Spark, Fuel, and compression to run. Determine what is...
  4. Replies
    78
    Views
    4,457

    Diagnosing the start system on your Polaris is...

    Diagnosing the start system on your Polaris is one of the EASIEST things to do....

    1st, PLEASE find another shop to take your PWC to next time, as this particular shop has no idea of what they are...
  5. Replies
    29
    Views
    4,600

    I have, and strongly recommend Genuine Mikuni...

    I have, and strongly recommend Genuine Mikuni brand kits, needles, and seats, ect in stock here.

    Should easily be able to get you a bolt.
    Pretty sure I have the cable.
    Already have looking into...
  6. Replies
    15
    Views
    1,263

    Just a FYI when the time comes, I have new...

    Just a FYI when the time comes, I have new pistons, rings, can bore your cyls to match, also have gaskets, crank seals, case sealer, etc.

    Have genuine Mikuni brand carb rebuild kits, fuel pump...
  7. I think I have some used... ( will have to look...

    I think I have some used... ( will have to look when I get into the shop)

    I sell for 100.00 + s&h for good, fresh water used.

    Send me an email watcon@watcon.com or call the shop 608-743-1305...
  8. Your 700 has Kehin carb(s) and the restrictor is...

    Your 700 has Kehin carb(s) and the restrictor is built into the carb, not in the line.
  9. Replies
    6
    Views
    1,371

    Welcome to the site. Were do you ride? Salt...

    Welcome to the site.

    Were do you ride? Salt water?

    It is not uncommon for the wear ring, ( where your impeller resides) to "swell up" and hit the impeller blades. It happens more on machines...
  10. I have standard pistons IN Stock. Please be...

    I have standard pistons IN Stock. Please be sure to read up on the Polaris Fuji engines, upgrade the fuel system, and determine why your engine failed in the first place. ( lean condition from fuel...
  11. Replies
    11
    Views
    6,028

    Be careful with Wiseco's. They are an excellent...

    Be careful with Wiseco's. They are an excellent piston, light and strong, BUT they are a forged piston, and will expand at a quicker rate. If not properly set up, they will seize. Because of the...
  12. Replies
    5
    Views
    367

    Personally I have NEVER had any luck with the...

    Personally I have NEVER had any luck with the cheap, aftermarket starters. You will be lucky if they last 1/2 a season..... ( and this is the $100.00 ones, I have NEVER seen a 50.00 NEW starter, I...
  13. You need a clamp on the fitting cap. Your 750...

    You need a clamp on the fitting cap.

    Your 750 motor is pretty much self draining, no need for antifreeze. Pull that boot/cap off of the flush fitting, and blow here with the air compressor while...
  14. Discount at watcon.com for greenhulk memebers

    Get a 10% discount at www.watcon.com if you enter coupon code GREENHULK in the box at check out when ordering.

    Discount applies to online orders only.

    Thank you
  15. Replies
    445
    Views
    24,596

    Remember also, different brands of impellers have...

    If you can collect and collate your notes perhaps I can organize a table or chart for future reference by everybody.

    Of course if you can just post it up as a ready to use thing, that would be...
  16. Replies
    8
    Views
    1,365

    we run 2 gals of pink -50 deg antifreeze through...

    we run 2 gals of pink -50 deg antifreeze through the flush fitting at the front, while the ski is running. ( I have a tank that is pressurized to blow antifreeze through)

    Treat the fuel ( do this...
  17. You should NOT double up on head gaskets. You...

    You should NOT double up on head gaskets. You can on the base, ( better to order a special thicker gasket though) but this will raise your port timing and affect the tune of your motor.

    Better to...
  18. Replies
    16
    Views
    1,367

    unplug the red wire on the rectifier, and retest....

    unplug the red wire on the rectifier, and retest. I also bet it will now run fine. replace the VR if you find it does.

    ALSO, go through the carbs again, make sure all parts are there, and...
  19. Replies
    4
    Views
    433

    Cheap bendix drives can, and WILL explode. I...

    Cheap bendix drives can, and WILL explode. I have seen parts damage the magneto, flywheel, crank cases, and even front seal.

    It is the old saying, you get what you pay for. Good clean, used...
  20. I will say, I DID that piston / cyl here, and I...

    I will say, I DID that piston / cyl here, and I go .0005 OVER Spec as a safety measure. Things are checked, and double checked before they leave. I have a hard time believing it was tight to begin...
  21. Yes, it will fit in your 03. switch over your...

    Yes, it will fit in your 03.

    switch over your electrics, and single intake manifold and carb.
  22. I have PJS throttles in stock, and they are the...

    I have PJS throttles in stock, and they are the only ones with the correct adjustment for Polaris.

    http://watcon.com/Handling.htm
  23. Glad I was able to help your project.... I...

    Glad I was able to help your project....

    I would NOT put any sealer on the crank case seals. There is no need, they are rubber, and designed to seal against the case halves dry. Use 1211 on the...
  24. Replies
    2
    Views
    1,379

    The rubber boots on the cables will come off. ...

    The rubber boots on the cables will come off. Then, if you slide a hose over the cable, and fill the hose with a penetrating oil, and move the cable back and forth, oil will be drawn into the inner...
  25. Yes, clear valves are IN the kits. They are hard...

    Yes, clear valves are IN the kits. They are hard to see, and I seal them in their own section of the package, look carefully.

    You definately need them, and they NEED to be in erfect condition....
Results 1 to 25 of 32
Page 1 of 2 1 2