Search

Type: Posts; User: Pacer

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    8
    Views
    244

    View Post

    The ďrubber sleeveĒ was leaking where it mounted to the PTO cover and the bearing. I used sealant on both surfaces and the hull is clean now.
  2. Replies
    8
    Views
    244

    I have the same ski and had the same problem. It...

    I have the same ski and had the same problem. It was the rubber driveshaft boot on the back of the motor. I pulled the shaft, and the supercharger. Cleaned the boot and the rear cover and...
  3. Replies
    8
    Views
    239

    View Post

    Iím calling it. Itís a joke post. The pic was put up to get a rise out of you guys.
  4. Thread: Surprise

    by Pacer
    Replies
    6
    Views
    512

    460432 Moose out front shoulda told you!!!

    460432
    Moose out front shoulda told you!!!
  5. Replies
    5
    Views
    295

    View Post

    Check the wires in the MPEM plugs. Iíve had those slide back in the plug, and give issues similar to what you are having.
  6. Thread: Coronavirus

    by Pacer
    Replies
    13
    Views
    544

    And wash your damn hands.

    And wash your damn hands.
  7. Replies
    1
    Views
    182

    Make sure the reducing washer with the O-Ring...

    Make sure the reducing washer with the O-Ring around it is in the right place on the pump so you arenít loosing cooling water between the pump and the hull.
  8. Replies
    115
    Views
    15,937

    You could spend some time braiding your beard. ...

    You could spend some time braiding your beard. Maybe put some beads in it. That should kill half a day.
  9. Replies
    0
    Views
    97

    2012 analog tach quit working

    I fired up my 2012 GTR and the analog tach isnít working. The digital tach works, and the analog speedometer is working. Iím going to swap in the gauge from my 2015 and see if the tach needle will...
  10. Replies
    28
    Views
    1,459

    That sounds a little overboard? Am I reading...

    That sounds a little overboard? Am I reading that right? Do you check the oil pressure with a gauge 3 times every ride? Do you have the gauge permanently mounted in the glove box? Do you do this...
  11. Replies
    3
    Views
    330

    It doesn't idle high every time I start it. It...

    It doesn't idle high every time I start it. It seems like the throttle is sticking, but that should make it throw a code if that was happening??
  12. Replies
    3
    Views
    330

    The ECU isn't corroded. The ECU plug was in the...

    The ECU isn't corroded. The ECU plug was in the bottom of the hull in water, but the ECU is OK. It was in a separate box.

    Thanks
  13. Replies
    3
    Views
    330

    2015 GTI LTD high idle problem

    I put a rebuilt motor in a 2015 GTI LTD 155. It cranks and runs, but it idles between 3,000 and 4,000 rpms? I got the boat after it had been taken apart and sat with water in the hull for over a...
  14. Replies
    5
    Views
    717

    Your not spinning the flywheel. Your spinning...

    Your not spinning the flywheel. Your spinning the bendix with it not engaged.
  15. Replies
    14
    Views
    1,080

    If SeaDoo produced a four stroke XPL, they could...

    If SeaDoo produced a four stroke XPL, they could discontinue every other model because nobody would buy anything else.
  16. Replies
    38
    Views
    3,558

    I call BS on this resurrection. Nobody is gonna...

    I call BS on this resurrection. Nobody is gonna try to tighten that 5 mm to 75 ft lbs and not realize they have an issue well before it breaks. People are bored with not riding so they troll.
    ...
  17. Replies
    29
    Views
    1,989

    View Post

    I havenít done it in a few years, but if you ground the blue and yellow wire that goes to the gauge it will take it out of slow mode.
  18. Replies
    9
    Views
    498

    What happens when you push the start button? ...

    What happens when you push the start button? With or without the key. Does the gauge light up?
  19. Replies
    4
    Views
    448

    View Post

    Thatís what he is asking. Both the crankshaft and crank case donít have markings requiring a different bearing size (shape). Heís asking someone to look in the manual and confirm the bearing color...
  20. Replies
    13
    Views
    1,344

    View Post

    Like rainbows!! Canít we all love rainbows???
  21. Thread: Baitcasting reel

    by Pacer
    Replies
    6
    Views
    531

    I think you guys just got hooped by an...

    I think you guys just got hooped by an advertising bot for that link in his post.
  22. Replies
    3
    Views
    315

    View Post

    Iíve had water in the stater housing do that. You can pull the glove box out and get the starter apart on that model. Itís tricky, but do-able.
  23. Thread: pipe for 951 XP

    by Pacer
    Replies
    7
    Views
    304

    WTB - Parts View Post

    Iíve had good luck with SBT cranks and ballancers. They have built enough 951 engines to know how to do it. Iím not a fan of everything they make, but Iíve never had a problem with a 951 crank from...
  24. What happened to the rider that had the heart...

    What happened to the rider that had the heart attack? Hoping the guys on the pontoon boat saved him??
  25. Replies
    49
    Views
    4,016

    I started at sea-doo.net in 2001. How about PWC...

    I started at sea-doo.net in 2001. How about PWC central? Anyone remember those guys?

    Who was Blingbling? He was helpful back in the day then he disappeared. And there was that guy making a...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4