Search

Page 1 of 4 1 2 3 4

Search: Search took 1.00 seconds.

  1. I guess my first thought is an honest question:...

    I guess my first thought is an honest question: if you took 4qt5oz out, how come you put 4qt11oz back in - to allow for whatever was in the oil filter, I suppose?

    Sounds like we do things...
  2. Don't even respond to this post everyone, we know...

    Don't even respond to this post everyone, we know what were dealing with here. Let keep it focused on the OP's issue and not drag this thread down because of this character. Set your fingers to...
  3. Sea-Doo rxp 300 oil capacity frustrations....

    I changed the oil in my rxp 300. I pulled out for 4 quarts 5 ounces. I added back in one gallon.

    The service manual states to already have the engine warm and let it idle for 30 seconds and then...
  4. Replies
    24
    Views
    1,929

    try to find the PPG writeup on installing the 951...

    try to find the PPG writeup on installing the 951 pipe. at the least, get the proper tap and clean ALL the bolt threads complete. Then tend to wear over time and leaks are deadly. Glens wroiteup...
  5. Hard to see how deep it is, but you might just...

    Hard to see how deep it is, but you might just tape around those area and sand them a little, clean with alcohol and fill it with Right Stuff and smooth it out with a razor blade. Don't worry about...
  6. Replies
    7
    Views
    535

    Perfect timing, I just saw a 2004 with a dead...

    Perfect timing, I just saw a 2004 with a dead cylinder for sale and wondered the same thing. Was thinking about making him an offer but, based on what I gave seen here and the fact that I have a busy...
  7. Replies
    7
    Views
    535

    Bearings, bolts, gaskets, piston, head (used head...

    Bearings, bolts, gaskets, piston, head (used head should get a valve job, maybe seals and guides), machine work (doubt that bore didn't get touched by two bouncing vales) for all 3 with hone at the...
  8. Replies
    23
    Views
    1,572

    Cheers for all the responses. I'm certain it...

    Cheers for all the responses.

    I'm certain it was not like this (water in oil) when it was left sit. It's happened in the last month or so.

    To be honest I didn't drop the fuel but did fill it...
  9. post a good video of it cranking, members will be...

    post a good video of it cranking, members will be able to tell from the sounds what you might be looking at.

    layoff the starting fluid and jump pack.

    dump a teaspoon of gas down each jug and...
  10. Replies
    7
    Views
    769

    No need to change rocker bolts/cam bolts or...

    No need to change rocker bolts/cam bolts or remove rocker assembly. Just remove head bolts in sequence. 2 small ones near cam gear as well and cam gear socket head bolts. Dont drop these into crank!...
  11. Replies
    25
    Views
    2,591

    [emoji6]

    [emoji6]
  12. Replies
    21
    Views
    1,629

    Change fuel, fog oil in the cylinders before you...

    Change fuel, fog oil in the cylinders before you turn it over, new spark plugs, change oil and filter & i would do the super charger because of the time that has past and don't want to take the...
  13. I don't think I've ever read a 14-page thread in...

    I don't think I've ever read a 14-page thread in entirety before....

    Best part? I'm a Yamaha guy - there's nothing I could gain from this post!! Well, I take that back. I did gain a lot of...
  14. Replies
    25
    Views
    2,591

    Dealer, warranty item there. Why mess with it. ...

    Dealer, warranty item there. Why mess with it.
    Unless you want to upgrade to a fizzle
  15. I bet this guy sleeps with a helmet on.

    I bet this guy sleeps with a helmet on.
  16. Replies
    4
    Views
    436

    Issues I think

    New to forum new to owning a seadoo it’s a 2012 rxpx 260
    the jet and the reverse mechanism seem to have some play in them is this normal?
    can add a video if I can figure out how
    thanks
    dave
  17. Well you don't know how to read or turn a wrench,...

    Well you don't know how to read or turn a wrench, so at least I 1 uped you. I guess when your 2005 Seadoo fucks up, you're gonna fix it all by yourself in your garage with all your specialized...
  18. The alarm would still go on whether you reved it...

    The alarm would still go on whether you reved it or not. May be a few seconds later tho.
    If you want to charge the batery without a charger the only way is at the ramp on the trailer and the pump...
  19. Replies
    34
    Views
    3,305

    So is it water in the oil or coolant? Oil cooler...

    So is it water in the oil or coolant? Oil cooler has coolant running through it so if it's actual H2O in the oil it's not coming from the oil cooler.

    Take off the intake manifold and check for...
  20. Replies
    10
    Views
    674

    It actually cleaned up really well using dish...

    It actually cleaned up really well using dish washing liquid and a dremel with a nylon brush. Alot of the paint was still there just coated in white residue that would not just rinse off.
  21. thats actually cheap for all 3 bumpers... thanks!...

    thats actually cheap for all 3 bumpers... thanks! im gonna try the Ultimate black or the back to black see how it comes out if it looks like sh*t ill just swap them out....


    BTW..... That site...
  22. Replies
    7
    Views
    976

    over torqueing I have seen pulls the threads...

    over torqueing I have seen pulls the threads right out of the block. I had a local guy torque them to 115ft by mistake and it pulled the last one out.
  23. HA! Thanks man! That’s the kind of post I needed...

    HA! Thanks man! That’s the kind of post I needed to see. :)

    You guys have been extremely helpful and I really appreciate it! I will continue to post up on the progress on the skis. Parts should be...
  24. Replies
    13
    Views
    1,063

    Check you harness connections there are two that...

    Check you harness connections there are two that can be swapped.
  25. They were used in both Salt and fresh water....

    They were used in both Salt and fresh water. Always cleaned when got out of the water. They got busy with a father that was sick and they just covered them and they sat. Up until that they were...
Results 1 to 25 of 79
Page 1 of 4 1 2 3 4