Search

Page 1 of 14 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    3
    Views
    110

    Threebond if the surfaces are scratched or pitted...

    Threebond if the surfaces are scratched or pitted up. Otherwise clean surfaces with new gaskets require nothing, just assemble dry. If you just want extra insurance the copper spray is great.
  2. Replies
    41
    Views
    5,775

    Maybe I am just that old guy (at a staggering 31)...

    Maybe I am just that old guy (at a staggering 31) now that wants to yell at people to get off my lawn but isn't that what the mirrors are for? I have been towing tubers and wake skates since 2006 and...
  3. Replies
    24
    Views
    648

    And......the 1100 runs a divorced fuel pump. Buy...

    And......the 1100 runs a divorced fuel pump. Buy a new one or rebuild the stocker as well.
  4. Replies
    11
    Views
    345

    The grease is just to lube the seals. It doesn’t...

    The grease is just to lube the seals. It doesn’t take much. They use a sealed bearing in the housing. I put a few pumps in once a year or so.

    If you have a flexible hose on your grease gun you...
  5. Also... Check and see if they installed power...

    Also... Check and see if they installed power valve retainers. The pins have been known to fall into the engine causing damage. Modern 4 strokes, I would recommend over these older 2 strokes just for...
  6. Find out if the Oil Injection lines have been...

    Find out if the Oil Injection lines have been checked, replaced, or secured lately. These are reliable engines, so long as those oil injection lines are healthy and secured. Also, 2 Strokes need to...
  7. Same set up I had, '07 250 on one side 06 15f on...

    Same set up I had, '07 250 on one side 06 15f on the other... I wish you luck, but I'd find a new mechanic if he didn't pull the plugs while checking it over... You may get lucky... But you do need...
  8. Replies
    11
    Views
    730

    No replies so took things in hand with a hacksaw....

    No replies so took things in hand with a hacksaw. Average of 5mm wall thickness, it's cast.
    Good for figuring internal damage limits from pitting.




    ...
  9. Replies
    16
    Views
    1,125

    How much teeter-totter wobble movement is there...

    How much teeter-totter wobble movement is there with this configuration?

    What is the 3/4 bolt doing?
  10. Dude, if you can back out of the deal, it...

    Dude, if you can back out of the deal, it probably would be best if you did...
  11. I wouldn't run it at all till it was upgraded,...

    I wouldn't run it at all till it was upgraded, it's a well known issue that can take out the motor
  12. Replies
    108
    Views
    22,534

    Sticky: What? Do Seadoo and Yamaha take turns seeing who...

    What? Do Seadoo and Yamaha take turns seeing who can make the ugliest color combos?
    This year Yamaha wins!
  13. Replies
    2
    Views
    285

    try signing out, then signing back in

    try signing out, then signing back in
  14. Replies
    10
    Views
    688

    Might want to check engine alignment, engine...

    Might want to check engine alignment, engine mounts, driveshaft holder alignment, and driveshaft holder bearing too. Maybe one of those is putting extra stress on your pump bearings.
  15. Replies
    10
    Views
    688

    Your pump

    Your pump
  16. Early Release of "Some" 2022 Kawasaki Jet-Ski Models

    While the early release for "some" of the 2022 "Normally Aspirated" Kawasaki Jet-Ski Models appears to simply be a change in Graphics/Colors - there could quite possibly be "something special" for...
  17. Hi All! I have been searching the source for...

    Hi All!

    I have been searching the source for the similar problem and also been reading this thread. In my case the fault was caused bad fuel pump. I used the Quantum's kit for replacement, but the...
  18. Replies
    10
    Views
    669

    https://www.youtube.com/watch?v=ZxV80Zt0hUU I...

    https://www.youtube.com/watch?v=ZxV80Zt0hUU

    I think I got my answer. Per the video, the throttle was fully open and the lever was in a decompress position...when he moved it to idle position, the...
  19. After sitting for 2 years without a proper...

    After sitting for 2 years without a proper winterization and fuel stabilizer I would be opening the carbs to clean them out. 2 years is a long time for ethanol to sit with no stabilizer. you probably...
  20. FYI 1 year in and they still look perfect.

    FYI 1 year in and they still look perfect.
  21. Replies
    30
    Views
    2,248

    Scuba diving boots are great, I tried neoprene...

    Scuba diving boots are great, I tried neoprene shorts then decided it will be too traumatic for people to see on me!
  22. I would start off by recharging the battery. Then...

    I would start off by recharging the battery. Then remove the spark plugs and turn the motor over with the fuel off. I recommend doing that just in case the motor filled with gas or oil while sitting...
  23. Replies
    30
    Views
    2,248

    Two of the riders in that video clip are wearing...

    Two of the riders in that video clip are wearing Fly Racing Trekker helmets (couple of model years old). One rider is wearing an open face Fly helmet (I forget the exact model) and she wears riding...
  24. I added the proper amount of mix into the fuel...

    I added the proper amount of mix into the fuel (my buddy found the receipt- had the gallons printed on it) and I did the compression test. With the motor cold, each of the 3 cylinders gave me a...
  25. So others can benefit. I did find the problem and...

    So others can benefit. I did find the problem and it was a very simple solution. Fire had been intermittent. I was getting fire when I had the cdi box open. I had assumed it was firing because I...
Results 1 to 25 of 328
Page 1 of 14 1 2 3 4