Search

Type: Posts; User: mrjetskey

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. With yamaha if you have spark and compression...

    With yamaha if you have spark and compression then theres a good chance 99% that its fuel If you give it a shot of fuel or starting fluid does it then fire up?? If so when carbs were rebuilt if an...
  2. Replies
    29
    Views
    32,054

    I have replaced 2 on two different hondas both...

    I have replaced 2 on two different hondas both were non-turbo and both had the Knock sensor code,both have been running fine now for few yrs. I just came across one that has a different problem,its a...
  3. Replies
    5
    Views
    352

    Anyone ?? Has anyone seen this code on non-turbo...

    Anyone ?? Has anyone seen this code on non-turbo ski before. I checked all vacuum lines looked good. Thanks in advance !!!
  4. Replies
    5
    Views
    352

    Well checked all wiring ,replaced map sensor with...

    Well checked all wiring ,replaced map sensor with known good one (the old one was bad it wouldnt hold vacuum.) Also found out ski had 2.5 quarts too much oil.I checked the wiring ,installed new plugs...
  5. Replies
    5
    Views
    352

    Thanks, I couldnt be sure but its funny a non...

    Thanks, I couldnt be sure but its funny a non turbo would pop a 42 code, but some stranger things have occured.I have Mitchell sending me a replacement,This is a customer who wants to do his own...
  6. Replies
    5
    Views
    352

    Denso Map sensor

    My question is with the map sensor bad (code 42) I'm pretty sure by reading the TCP and Map sensor are one and same on non turbo ski. Would someone please let me know if I'm wrong on this ???THanks...
  7. Replies
    4
    Views
    155

    only if you have the early model 1200 PV motor,...

    only if you have the early model 1200 PV motor, some I have worked on have the newer style p.v. retainers that dont require the clips you can easily tell if you pull a P.V. cover and look at actuator...
  8. Replies
    2
    Views
    156

    Yes intercooler was replaced after pressure test....

    Yes intercooler was replaced after pressure test. I just replaced throttle body with a known good one took care of all faults ,it was sticking shut and dragging I supposed damaged by intercooler...
  9. Replies
    3
    Views
    312

    never been in salt, looks like new, adult owned...

    never been in salt, looks like new, adult owned and babied.running fine ,put up for evening on lift , then first thing next morning made it about one minute and overheat sensor put in limp,As I said...
  10. Replies
    2
    Views
    156

    RXPX 260 Fault codes P1615 and P160E

    This ski was bought used from dealer and had the Throttle body replaced and then the Intercooler as it had been leaking.Ran fine for 12.5 hrs. now its throwing these codes. My question is since the...
  11. Replies
    3
    Views
    312

    800 sxr need help please

    On a sxr800 kawa.it seems to be overheating.I flushed through all lines they are clear including feed line from pump to exhaust. My problem is after 30 to 45 seconds of running water out pee hole is...
  12. I'm going to add one thing and I'm going to shout...

    I'm going to add one thing and I'm going to shout it.I have repaired many SMC hulls, both Kawasaki and Yamaha. That center Bulkhead is molded but more resin than hulls.Two strokes have lots of oil...
  13. make sure when you adjust carbs the low speed and...

    make sure when you adjust carbs the low speed and high speed. always screw them in till bottom then usually a good starting point is one full turn out on low speed and 3/4 to one on high speed. Be...
  14. Replies
    2
    Views
    316

    removing resonator on 1300gpr

    I have a couple of blind nuts leaking on inside they are spun loose allowing leak.Normally no problem but this customer leaves his in water overnight and a few drips lead up to sunken jetski. I...
  15. Replies
    2
    Views
    202

    You got it!! At least twin cylinder don't keep...

    You got it!! At least twin cylinder don't keep running like triples until you fry piston!
  16. Replies
    21
    Views
    1,056

    I have done a lot of 1200 PV. also 800 pv . ...

    I have done a lot of 1200 PV. also 800 pv . That's heat and pre-ignition that caused that, if there was no all around seizing on piston just hole in top it most probably was caused by number one...
  17. Your xl800 has twin 44-46mm mikuni carbs that use...

    Your xl800 has twin 44-46mm mikuni carbs that use SBN I kits they have larger diaphrams than the std ( 38-44mm mikuni kits) Be sure to clean all jets and remove needles after counting turns in to...
  18. Replies
    6
    Views
    506

    Well after feeling the temp of water coming out...

    Well after feeling the temp of water coming out right peephole and feeling pipe He decided that it might be ok to go ahead and remove it!!! Relief. I used aftermarket head gasket and holes seemed to...
  19. Replies
    12
    Views
    583

    I just finished doing cylinder #3 on a 90 hr.ski...

    I just finished doing cylinder #3 on a 90 hr.ski perhaps it has something to do with cooling and or the viscosity of the oil you are using. Usually piston damage is caused by heat, which in turn is...
  20. Replies
    25
    Views
    8,624

    I wasn't sure if Yamaha injectors could handle...

    I wasn't sure if Yamaha injectors could handle premix as most fuel injectors were not designed to run oil in fuel thru them, that's why I was asking. UPON FURTHER RESEARCH NO INJECTORS ARE DESIGNED...
  21. Replies
    6
    Views
    506

    Why wouldn't it start break in on trailer? I have...

    Why wouldn't it start break in on trailer? I have neither the time or inclination to ride for few hrs.. However the first 15 minutes of running is part of break in and since its a jet pump loading...
  22. Replies
    6
    Views
    506

    GPR1300 owners question PLEASE!

    I have only come across 2 gp1300r in last 18 yrs here. I just had to replace a rear cylinder due to piston damage,I checked all oil lines and pump ok, Checked injectors all ok.Oil pump lines ok. When...
  23. Replies
    25
    Views
    8,624

    No one ever answered the question is it ok to run...

    No one ever answered the question is it ok to run premix in fuel injection ? I believe as long as its a port type injection such as Yamaha gpr1300 should be ok,I know I just rebuilt a rear cylinder...
  24. I can say this ,other than the oil checking...

    I can say this ,other than the oil checking routine (Yamaha 5 valve and all dry sump must be run before seeing proper oil level) and the FI controller as Honda labels it. The HONDA'S are awesome...
  25. Just for info I have asked both owners the 300hr...

    Just for info I have asked both owners the 300hr and 250hr skis always keep battery connected and charged. As for the 60 hour trailer queen battery was always connected but allowed to fail twice so...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4